The fuel has the ff. analysis:   Carbon = 89% Nitrogen = 2% Hydrogen = 8% Sulfur = 1%   With 3% excess air, Determine the following: a. Theoretical Air-Fuel Ratio b. Actual Air-Fuel Ratio c. Higher Heating Value d. Lower Heating Value

Q: Heat Transfer For a food processing you are diluting 500 kg of juice (cp 3.5 kJkg- 1K- 1) at 70° C…

A: According to heat transfer rate the amount of heat loss in hot fluid = amount of heat gain in cold…

Q: 04: One mole of Methane with a mole of air were míxed to represent a laminar per mixed flame at 0.8…

A:

Q: An ordinary octane gasoline (C8H18) is to burn inside an internal combustion engine cylinder with 50…

A: Basis: 1 kg of octane gasoline (C8H18) The mass of fuel mf = 1 kg = 1000 g Molecular weight of C8H18…

Q: Provide solutions.

A: Basis: 1 mole of propane gas Combustion reaction: C3H8 + 5O2 → 3CO2 + 4H2O The theoretical amount of…

Q: Q2) A mixture of 40% propane (C3Hs) and butane (C4H10) by moles is burned with 35% excess air.…

A: Composition of the feed is,'Propane = 40 %Butane = 60 %Flow rate of air = 45 SCMH% excess air = 35 %

Q: A single-effect evaporator concentrates 2.00 kg/s of a 15% by mass aqueous solution of H2SO4 to 50%.…

A: Given: Feed (mf) to evaporator is 2 kg/s at (Tf)25°C, which concentrates 15% by mass aqueous…

Q: Question Two a) Derive the Clapeyron equation'? AH TAVm bi The specific volume of liquid water is 1…

A: Clapeyron Equation to be derived:  Since, different questions have been asked. According to…

Q: Q1: A one mole of Methane is burned at equivalence ratio (0.7), the fuel - air mixture at initial…

A: Note: Since we are entitled to answer only 1 question, we will answer the first one as it is not…

Q: If you burn methane with 50% excess air, what would be the flue gas composition?

A: Given Combustion of methane with 50% excess airTo findFlue gas composition

Q: Using Clapeyron and/or the Clausius - Clapeyron Equation(s), estimate the latent heat of…

A: We are given that  With the help of Clausius Clapeyron equation, we have to estimate the latent heat…

Q: 100 kmoles of heptane is burned with 35% excess air find the conposition of the flue gas if…

A: Write the ratio for combustion of Heptane as follows : C7H16+ 11O2 → 7CO2 + 8H2O Basis : 1 Kmole of…

Q: What is the mobile phase (carrier gas) used on the GC instrument? 1) He 2) CO2 3) Air 4) N2

A: GC instrument Gas Chromatography Instrument

Q: 4. Calculate the theoretical (adiabatic) flame tempcrature for CO burned at constant pressure with…

A:

Q: Thank you question in the photo.

A: Given data: Melting point of water = 0 0C Boiling point of water at 1 atm = 100 0C Enthalpy of…

Q: 26821 lbm/h of a 80 weight % H2SO4 solution in water at 120F is continuously diluted with chilled…

A:

Q: Air is cooled and dehumidified as it flows over the coils of a refrigeration system from 35 ° C and…

A: Refrigeration is the process of cooling a substance or a material by removing heat from the…

Q: ta) Heavy fuel oils may contain sulphur and vanadium as impunties. Write a balanced chemical…

A: Vanadium is a naturally occurring element that is present in diesel. Vanadium when reacted with…

Q: ta) Heavy fuel oils may contain sulphur and vanadium as impunties. Write a balanced chemical…

A: Vanadium is a naturally occurring element that is present in diesel. Vanadium when reacted with…

Q: Q1- Compare the laminar flame speed of propane-air mixtures with dm =1.08, Bm 34.22 cm/s and B2 = -…

A:

Q: Please answer this correctly,You need to refer to the thermodynamics table.

A: your question about determining the quality of a two-phase liquid-vapor mixture of refrigerant-134a…

Q: 8.0 kg of water at 32 C is mixed with 1.3 kg of water at 98 C. Assuming steady-state conditions and…

A:

Q: Copper has a specific heat of 385 J/kg-K. If a 10-kg piece of pure copper is initially at 25 °C,…

A:

Q: burning a 75% butane and 25% propane mixture with excess air of 25% find: a) the balance of the…

A: Hi and thanks for the question. Since you have posted a question with multiple sub-parts, we will…

Q: The following results were obtained for Tray n from a rate-basedcalculation of a ternary…

A:

Q: It is IMPOSSIBLE to transfer heat from a body at a lower temperature to a body at a higher…

A: Given data: Second law of thermodynamics statement.

Q: 5: Octane no. of paraffins: (a) Remain constant with change in the number of carbon atoms (b)…

A:

Q: If there is crude oil that contains 200 PPM of Vanadium if 5000 barrel is burned per day calculate…

A: Crude oil is a liquid found below the Earth's surface that can be separated into various useful…

Q: The lattice energy of five ionic compounds A, B, C, D and E are measured. The energies are found to…

A: Given Data: ionic compounds are NaCl,NaF,KBr,RbBr & KCl Lattice Energy(kJ/mol) Compounds…

Q: 238Pu, which decays by the emission of an alpha-particle, has been used as a thermal power source.…

A:

Q: True or false. if the statement is FALSE, place the correct word/s that should replace the word/s in…

A: Saturated liquid is the liquid which is at its bubble point.

Q: Question 3: Inside a high-temperature hydrocarbon cracker, an equimolar mixture of three high…

A: Dear Subscriber! As per our policy, we have solved the first three subparts. We suggest you repost…

Q: 10 kg of H2O is stored in an icebox at - 13.7 C. After a few days, the temperature is measured at…

A:

Q: 2. The molar heat capacities for solid, liquid, and gaseous molecular chlorine can be written in the…

A: Given information:   The formula for the calculation of the specific heat capacity for molecular…

Q: Estimate the crystallinity in a PET fiber with a density of 1.395 given that the extremes (0% and…

A: Given that a fiber has a density of 1.395 g/cm3 (ρ) And that the extreme (0%) has density of 1.335…

Q: In a hot flame, the emission intensities of the sodium lines at 589.0 and 589.6 nm are greater in a…

A: Flame emission spectrum is based on metallic elements emitting light if sufficient energy is…

Q: Braqmet erti szips of food riguone eipiensp of beloper sd of ever bluow d. What singular change can…

A: d) To vaporize letter B, we have to increase temperature or decrease pressure because presently…

Q: 1. How much heat is required when 10,000 kg of CaCl, is heated at atmospheric pressure from 50°C to…

A:

Q: the number of equilibrium stages required for the separation.

A:

Q: A phase diagram for tin is shown below. What phase transition occurs when white tin is heated to 600…

A: A phase diagram represents the variation of the state of a substance with pressure and temperature…

Q: 7: Which of the following petroleum products has a minimum flashpoint? (a)Gasoline (b) Kerosene (c)…

A: As per bartleby multiple subparts question guidelines, we are supposed to answer only first 3…

Q: For the distillation in figure 3 below, calculate Nmin and the distribution of the nonkey components…

A: Given that,  for the distillation column-Higher key (HK)= i-C5Lower key is (LK)= n-C4The rest…

Q: Consider 2.5 kg of austentie containing 0.65 wt% °C, cooled to below 727°C a) What is the…

A: a) Ferrite is the pro eutectoid phase since 0.65 wt% C is less than 0.76 wt% C. b) For ferrite,…