The following table shows the results obtained from laboratory tests done on samples of aggregates. Weight of Aggregates + Metal BSG for SSD Metal Measure % ABS % MC Measure Inside Diameter 30.39 kg 2.67 3.69 9.24 = 6 inches Height = 12 inches Empty weight = 8.62 kg 1. Calculate the Dry Rodded Unit Weight of Aggregates in kg/m³. 2. Calculate the % Voids in 1 m³ of aggregates.

Q: Name four methods of flow measurement?

A: Name four methods of flow measurement?

Q: Describe implicit time method.

A: Describe implicit time method.

Q: Convert 1600 mils into equivalent value in grads O 90 degrees O 180 degrees O 270 degrees

A: To convert mils to degree

Q: Q2/ Initial Map scale is 1: 1000. The playground is rectangular and on the map has dimensions 8 cm…

A: This question is related to the Surveying Engineering from Civil Engineering. In this question ask…

Q: Write brief notes on the following: a, the technique of estimating mean depth and mean area; and b,…

A:

Q: Define Spencer Charts.

A: Spencer defines the factor of safety as the available shear strength quotient divided by mobilized…

Q: re there any situations where a scale layer can be helpful to a water utility? (answer in one or two…

A: calcium carbonate form the protective layer on lead pipe by making lead carbonate. which increase…

Q: A GPS enabled device has many uses. Write or record a short description of what GPS stands for, how…

A: Reference : Surveying/ Mapping and Photogrammetry, GPS To determine : 1. Small Description 2.…

Q: What is the measurement benchmark（more than one answer） (multiple choice questions) A. position…

A: Measurement bench mark is a position reference and an elevation datum. It is a point with respect to…

Q: Hand Writing not allowed please provide Typed answer

A: The distance between v1 and v2 is  √37 or approximately 6.08 units.Explanation:Formula for distance…

Q: Calculate the end areas for depths of fill from 0 to 20 ft using increments of 2 ft for level…

A:

Q: 1. Tables below show data of stream flow and rainfall observed for a particular watershed with an…

A: (3) The question is based on the streamflow and rainfall data for the particular watershed. The area…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.