The following results were obtained from direct shear tests on specimen of sand compacted to the in-situ density Determine the value of shear strength parameters Normal stress (kPa) Shear stress at failure (KPa) 30 50 20 120 180 30 75 110 Angle of friction (deg) Cohesion (KPa) Would failure occur on a plane with a mass of this sand at a point where the shear stress is 80 kPa and normal stress of 150 kPa

Q: A multiple-tube fermentation test for coliform group of two water samples yielded the following…

A: Given data, 1 ml = 5 0.1 ml = 3 0.01 ml = 2 0.001 ml = 1 0.0001 ml = 0

Q: Circle the letter of the true answer of the following questions: 1-A part of the rainfall that…

A: Thank you for the question . As per honour code we are allowed to answer the first question since…

Q: Two reservoirs A and B have elevations of 250 m and 100 m, respectively. The two tanks are connected…

A:

Q: A clayey sample of 2 cm thickness is collected from a 30 cm thick strata resting on impermeable…

A:

Q: In a constant-head permeability test. A test gives these values: .L= 12 cm A=95 area of the specimen…

A:

Q: Differentiate between the following terms? Emulsion and Cutback, Slippage failure, Rutting.

A: Emulsion and cutback are types of Bitumen. And Slippage and rutting are defects of road .there…

Q: Q1: Discuss in detail Kennedy and Lacey Theory? Write down all the design steps. Civil Engineering…

A:

Q: 3. A detention pond has the shape of an inverted truncated pyramid, shown below. It has a…

A: Rectangular bottom of dimension 120 x 80 ft maximum depth of 5 ft uniform side slopes of 3:1 Length…

Q: What is Structural Engineering?

A: QUESTION : What is Structural Engineering?

Q: A wood cone, 700 mm diameter and 1000 mm high floats in water with its vertex down. If the specific…

A:

Q: A 2.5km long pipe connects two reservoirs as shown. The minor head losses are estimated to be 10% of…

A: Given:- Minor loss = 10% of major loss To find:- Discharge in pipe the Darcy–Weisbach equation is…

Q: Consider the tabulated design intersection data and based on Webster method, then the number of…

A:

Q: computer aided engineering

A: Computer-aided engineering (CAE) is the use of computer software to simulate performance in order to…

Q: Q#02: Given below are the ordinates of a 6-hunit hydrograph. Calculate the ordinates of DRH due to a…

A: Solution:

Q: Please solve this it’s my final exam and there’s little time remaining. Just draw the graphs on page…

A: The soil is classified into fine-grain soil or coarse-grain soil based on the soil passing through…

Q: Which of the following is a common connection method for prefab concrete wall panel systems? Panels…

A: For prefabricated concrete wall panel systems generally bolted or welded connections are used for…

Q: For a moist soil sample, the following are given: Volume be 2.15 m3, and soil mass be 1650 kg, and…

A:

Q: Discuss in detail how the amount of organic pollutants in a water sample affects its BOD Level.

A: Note:-As the given question is a multiple type question, therefore as per the guidelines of Bartleby…

Q: Which of the following defects can occur if lack of tack coat is applied during the * road…

A: A tack coat is primarily used an adhesive material that is applied in the between layers of asphalt…

Q: The scope of Engineering Geology  a. planning c. urban planning  b. design d. all of the above

A: The knowledge of engineering geology can be helpful in all of the mentioned stages,   i. e, the…

Q: Design a facultative pond to treat 12900gpm of sewage having 645mg/L of BOD. The average summer and…

A:

Q: The difference between maximum void ratio and minimum void ratio of a sand sample is 0.30, if the…

A:

Q: If a given 1.8-m diameter culvert conveys water at a depth of 160 cm, then: Calculate the flow…

A:

Q: Discuss in detail Kennedy and Lacey Theory? Write down all the design steps.  Subject: Irrigation…

A:

Q: Problem: 1. Design a facultative pond to treat (10650)gpm of sewage having (10650/20)mg/L of BOD.…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: 10- To protect the Symon's rain gauge we should: a- put it inside a building are false b- put it…

A: Guidelines foe setting of a raingauge:* A raingauge must be surrounded by an open fenced area of…

Q: Problem 3: As shown, a solid cylinder with a diameter of 0.30m and weighs 180 N has a cord wound…

A:

Q: The coefficient of permeability of fine sand is 0.012 cm/sec at a voids ratio o0.57. Estimate the…

A: Please refer the attached image for complete solution.

Q: 4. If viscous effects are neglected and the tank is large, determine the flowrate from the tank…

A:

Q: Question # 2 The following bearings were taken in traversing with a compass in a place where local…

A:

Q: Problem 3: A water treatment with an average flow of 2.84 m3/s treats its water with ferric chloride…

A:

Q: A toll bridge carries 7,000 veh/day. The current toll is $4/vehicle. Studies have shown that for…

A: let V be travel demandV=7000-500×x50since the original toll was 400 cents per vehicles the new toll…

Q: PROBLEM 3: Given the void ratio 0.53, specific gravity 2.96,dry unit weight 1757.85 kg/m^3 and water…

A:

Q: The following data were tabulated for a direct shear test of a normally consolidated soil sample.…

A:

Q: 3. Calculate the net radiation in the river basin in W/m² with an evaporation rate of 10mm/day and a…

A:

Q: Solve the following system of equations using the Gauss Elimination or Gauss Elimination with Row…

A: Solution: The given set of equations is: 4x1+x2+2x3=212x1-2x2+2x3=8x1-2x2+4x3=16

Q: Circle the letter of the true answer of the following questions: 1- for wide and deep reservoirs,…

A: Given question about hydrology:

Q: A consolidated-drained triaxial test was conducted on sand. The results are as follows: Confined…

A: Using formula to get internal friction angle

Q: Water runoff can be channeled away from the pavement using the following drainage types EXCEPT; O…

A: This question is from transportation engineering here  some options are given and we are asked to…

Q: How can you calculate BOD value? What happens if you have a higher BOD value? Subject:…

A: Given information in question which is to be discussed  BOD value calculations What happens if…

Q: 1. The infiltration into soil as a function of time for a steady-state rainfall rate of 4 mm/h is as…

A: Given, The table for infiltration into soil as a function of time is,

Q: Give one importance of studying Geology for the Civil Engineering Field and elaborate it, thanks!

A: There are some aspects based on which we can get the importance of the geology in civil engineering…

Q: What do you think about the reliability/accuracy ranking of the followings? Cu = 55 kPa from SPT Cy…

A: Filed tests and laboratory tests are the two methods by which soil properties can be determined.…

Q: The half-life of 222 Rn is 4.2 days. A sample of 222 Rn is allowed to decay for 17.2 days and after…

A: As per question , This question is related to Environment Engineering.Given data - Half life = 4.2…