The following first order liquid phase reaction is carried out in n similar size CSTRS connected in series and operating at the same temperature. A → Products The number of reactors n required to achieve 65% conversion for Damkohler number of 0.5 is EL TE TEAM O a. O b. 20 O C. none of the mentioned O d. 1 O e. 3. O f. 10

Q: Which pump is an integral part of the petrochemical and edible oil factory? What are the use of this…

A: There are a lot of pumps used in petrochemical and edible oil factory like positive displacement…

Q: 5. List the relations that control the connection of pipes in parallel, and explain the two types of…

A: Introduction: Pipe Flow: In fluid mechanics, pipe flow is a sort of liquid flow inside a closed…

Q: D: Define and draw the Unit Cell and give an example.

A: A unit cell is the smallest element of a crystal lattice that indicates the three-d sample of the…

Q: What is meant by variable underflow and what causes it?

A: The definition of the variable underflow is to be defined along with the cause of it.

Q: How does environmental conditions affect flow conduits selection

A: Flow conduit are affected by many factors. Some of them are: Density of fluid. Viscosity of fluid.…

Q: How is compressed gas released?

A: The compressed gases are hazardous while handling as the are stored under containers in very high…

Q: All diffusivities for the three transport processes have the same units. True False

A:

Q: 4- Prove the continuity equation.

A:

Q: Caking in crystals is not formed during O a. Poor flow properties of crystals O b. Open…

A: The process in which clumps or cakes are formed when crystals are stored improperly. The crystals…

Q: In chemical engineering, explain the concept of multiphase flow and its significance in various…

A: Chemical engineers use the term "multiphase flow" to describe the simultaneous movement of two or…

Q: Which among the following is not a parameter for scaling up stirred vessels? A. Geometric similarity…

A: We have to answer and explain the parameter for scaling up stirred vessels?

Q: Feed A Feed B

A: We have to answer the meaning of the drawing “X” in this diagram. i.e. What does the “X” inside this…

Q: how does compressor stations become essential components of the pipeline network

A: The importance of compressor stations in the pipeline network is to be mentioned.

Q: Why might a column not have a uniform diameter?

A: Diameter of distillation column depends upon different factors because of which it cannot be…

Q: Briefly discuss what the ternary phase diagram is

A: Discuss the ternary phase diagram.

Q: conviction is higher in crossflow than in parallel flow why?

A: Reason for higher conviction in crossflow than in parallel flow has to be stated

Q: Convert 400 ft /day to cm/ sec O 13.1 O 131.1 O 1.31 O 0.131

A: It is required to convert 400 ft3/day to cm3/sec

Q: What is Chemical Engineering principle

A: Chemical engineers use basic principles to turn raw material into value added products. The basic…

Q: A core sample is saturated with water, Weight of saturated sample in air is 22.5 g. Water-saturated…

A: Bulk volume of the sample is volume of the water trapped between the pores of the sample. The weight…

Q: Q/ what 's defperence between Gross Pay and net Pay2

A: In the question it is given about two terms they are gross pay and net pay no we need to find…

Q: Why should a packed tower be operated below the flooding point?

A: Packed towers or columns are used in process industries to carry out various separation processes…

Q: What if the amount of air is not stated? How can we assume for that? Is there any technique?

A: Given that :amount of air (assume 79mol% N2, 21mol% O2) is given

Q: (3) (a) Define process flow sheet or process flow diagram. (b) What does the process flow diagram…

A: (a)Process flow diagram: It is a flow sheet that shows the connections between different major…

Q: an AE unit for energy

A: The specific heat capacity of a substance is the amount of energy required to raise the temperature…

Q: Chemical engineers focus on O Physical Model O mathmitical model

A: Mathematical modeling research are more and more acknowledged as an necessary device for evidence…

Q: 2.5 S.m¹¹ = ...S.cm

A: We know that, 1m = 100 cm

Q: 14. A smaller absorption factor means an increased driving force for absorption. [……..] 15.…

A:

Q: environment showing (b) Describe the mechanism of distillation operation in a chemical processing…

A: McCabe Thiele method ( Description)  McCabe Thiele method  is a simple graphical tool that helps in…

Q: How to apply the concept of polarity and intermolecular forces of attraction in predicting retention…

A: Intermolecular forces may be dipole-dipole interaction, H-bonding etc.

Q: During the selection of material, the characteristics of the material are an important factorcompare…

A: Answer: True

Q: e) Plot GE /RT, In y, and In y, as calculated by the given equation for GE /RT and by the equations…

A: To answer subpart e based on the previous solved subparts in the original question

Q: III. Food is milled from 6.5 mm to 0.0013 mm using a 10 hp motor. Would this motor be adequate to…

A:

Q: What is a residue-curve map?

A: The concept of Residue curves is particularly useful in two situations, firstly, for the azeotropes…

Q: What is the implication of an operating line in absorption that is vertical?

A: implication of an operating line in absorption that is vertical needs to be answered.