The following figure shows an epicyclic gear train (EGT) having two inputs. The sun gear 2 rotates at an angular speed of 50 rad/s. whist the arm rotates at 75 rad/s in the same direction as gear 2. What is the angular velocity of gear 5? The same module has been used in all the teeth of the gears and the number of teeth on each gear is shown in the brackets.

The following figure shows an epicyclic gear train (EGT) having two inputs. The sun gear 2 rotates at an angular speed of 50 rad/s. whist the arm rotates at 75 rad/s in the same direction as gear 2. What is the angular velocity of gear 5? The same module has been used in all the teeth of the gears and the number of teeth on each gear is shown in the brackets.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

For the simple gear train below, Gear A is the input gear and rotates at 2500 rpm and Gear D is the output gear for this simple gear train. The number of teeth for each gear is as follows: NA = 116 Teeth, NB = 178 Teeth, NC = 70 Teeth and ND = 120 Teeth Calculate the output angular velocity at Gear D (ωD). Give your answer in rads-1to the nearest radian.
4- Find the gearing ratio for the given compound gears shown in figure 10. 5- Given that the torque (t) of the driver gear is (40+x) N.m, find the torque of the green gear. (x is the last digit of your ID) (M) rrrrv Figure 10 Figure 11 D Error
Find the speed direction of gear 7 if gear 1 rotates clockwise. What is the overall the train value?
I need answer within 20 minutes please please with my best wishes
i need the answer quickly
4. What is the overall gear ratio for the following compound gear train? What is the output shaft speed and direction if the input shaft rotates clockwise at 1000 rpm? 8 teeth, Ø 5mm 16 teeth, Ø 10mm 24 teeth, Ø 15mm 32 teeth, Ø 20mm driver driven
A three-stage automobile transmission is shown schematically. The number 6 crankshaft has an angular angle of 50 rad / s.Find the angular velocity (w1) of the drive shaft no. 1 as it rotates with speed [w6 = 50 rad / s]. Each of the spur gears has a fixedrotates around the axis. It should be noted that gears 6 and 5, 4 and 3, 2 and 1 engage each other.. Division Circle of Gearsdiameters d6 = 180mm; d5 = 60mm; d4 = 60mm; d3 = 100mm; d2 = 140mm and d1 = 120mm.
Question about Planetary Gear Trains (Theory of machines course or Mechanism ) N is the speed of the gear T is number of teeth
only hand written otherwise i'll downvote
In the planetary gear train shown in below figure, Gear A is the driver and gears B and D are compounded.Gears E and C are internal gears with C as the fixed gear.Number of teeth on gears are TA-20;TB-60; Tc-140;TD-40;,TG-120. If the drive gears rotates at 720rpm CCW when seen from the right, find out the speed at which driven gear rotates C140 120 Output D 40 60 20 Input