The following are given for a natural soil deposit: Moist unit weight, y = 17.8 kN/m° Moisture content, w = 16 % G, = 2.7 This soil is to be excavated and transported to a construction site for use in a compacted fill. If the specification calls for the soil to be compacted at least to a dry unit weight of 18.4 kN/m° at the same moisture content of 16%, how many cubic meters of soil from the excavation site are needed to produce 21,000 m³ of compacted fill? (Enter your answer to three significant figures.) Total volume of soil to be excavated = m³

The following are given for a natural soil deposit: Moist unit weight, y = 17.8 kN/m° Moisture content, w = 16 % G, = 2.7 This soil is to be excavated and transported to a construction site for use in a compacted fill. If the specification calls for the soil to be compacted at least to a dry unit weight of 18.4 kN/m° at the same moisture content of 16%, how many cubic meters of soil from the excavation site are needed to produce 21,000 m³ of compacted fill? (Enter your answer to three significant figures.) Total volume of soil to be excavated = m³

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

1. A 1 m³ sample of moist soil weights 1800 kg. The water content is 10%. Assume p, is 2700 kg/m³. With this information, fill in all the blanks on the phase diagram. After your phase diagram is complete, compute void ratio, porosity and dry density. Show all your calculations. V 4 V Air Water Soil A M + M
Situation 1: Dry soil with Gs = 2.7 is mixed with water to produce 20% water content and compacted to produce a cylindrical sample of 40 mm diameter and 80mm long with 5% air content. Calculate the following: a. Mass of the mixed soil that will be required b. Void ratio of the sample c. Dry unit weight d. Moisture unit weight e. Saturated unit weight f. Amount of water to be added for full saturation.
Subject is soils mechanics
The laboratory compaction test of a certain type of soil gives a max dry density of 1.486 gm/cu.cm with an optimum water content of 12.5%. The ff are the results of a field density test using sand code equipment: Volume of soil excavated from the hole= 0.001337 cu.m. Weight of wet soil from the hole- 2220 grams Weight of soil after oven drying= 1890 grams a. Determine the field unit weight of the soil in gm/cu.cm. b. Find the water content of soil. c. What is the relative compaction?
Geotechnical Engineering
An in-situ (subgrade) soil located in Colorado (TMI = -20) has the following index properties: Percent passing No.200 = 25 percent Plasticity Index = 20 Compaction tests indicate this soil has an optimum degree of saturation of 85 and a maximum dry unit weight of 100 PCF. The resilient modulus at optimum conditions is 10,000 psi. Estimate the resilient modulus at equilibrium with the environment for this soil. Clearly outline the steps followed and assumptions used to find the answer.
Please help solve this homework problem. I don’t understand show all work so i can understand please thank you!
Q2) Classify a soil using USCS from the following information: 75% of the material is retained on the sieve No.200. less than of the percent above and more than 50%, is passing on the sieve No.4. L.L. 35% and P.L.= 29% D10 0.18mm, D30 = 0.88mm, and D60 = 1.12mm d)
Question 13 The compaction of a soil obtained from a standard compaction test is shown in the attached figure. At OMC (optimum moisture content) the degree of saturation = 93 %. What is the highest possible dry unit weight for this soil to have when the moisture content is 9 %? P (1+w) 20.0 1 10 Pa(s) 19.5 19.0 18.5 18.0 Dry unit weight, y, [kN/m³] 17.5 17.0 16.5 16.0 6 7 8 9 14. 1 10 11 12 13 14 Water content, w, [%] 15 16 G.P 1+ wG S 17 18
Q1: A. Answer in True or False 1. A soil has a Cu =1, then it is considered as a poorly graded soll. 2. A soil has L.L-60% and P.L-35%, then it plots a point below the A-line in the plasticity car 3. A soil described with a symbol (SP) has % passing No. 200 sieve more than 50% 4. Decreasing water content below shrinkage limit is accompanied with a decreasing in void ra 5. Water molecules are considered polar and known as dipoles. 6. Dry Density is the smallest density. 7. Capillary rise is directly proportional to the pore channel diameter. 8. The unconfined compressive strength is twice the undrained cohesion. 9. Piping or boiling occurs when effective stress equals to zero. 10. It is assumed that the secondary compression begins when the primary conso
A soil has bulk unit weight of 20kN / (m ^ 3) and water content of 18%. Calculate the water content if the soil particle dries to a unit weight of 22kN/(m ^ 3) and the void ratio remains constant. (Give the answer rounded to the nearest integer value)