The figure shows two forces of equal magnitude acting on an object. If the common magnitude of the forces is 4.6 N and the angle between them is 40°, what third force will cause the object to be in equilibrium? a) 7.0 N pointing to the right b) 8.2 N pointing to the right c) 3.5 N pointing to the right d) 8.6 N pointing to the right

The figure shows two forces of equal magnitude acting on an object. If the common magnitude of the forces is 4.6 N and the angle between them is 40°, what third force will cause the object to be in equilibrium? a) 7.0 N pointing to the right b) 8.2 N pointing to the right c) 3.5 N pointing to the right d) 8.6 N pointing to the right

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

What will happen when the supports are removed from this system? 30 kg 12 kg 1.75 1.5 1.25 1 0.75 0.5 0.25/ \0.25 0.5 0.75 1 1.25 1.5 1.75 Meters Meters A
A 10 m long uniform board weighing 400 N is supported by ropes at each end. A worker weighing 900 N stands 3.0 m from the rope on the left. Determine the tension in the two ropes for static equilibrium.
Modelled after problem 5 in the Problems_Torque_Statics: A 12.83-m-high and 19.48-m-long wall under construction and its bracing are shown in the figure. The wall is in stable equilibrium without the bracing but can pivot at its base. Calculate the force exerted by each of the 10 braces if a strong wind exerts a horizontal force of 871.28 N on each square meter of the wall. Assume that the net force from the wind acts at a height halfway up the wall and that all braces exert equal forces parallel to their lengths. Neglect the thickness of the wall. The angle between the braces and the wall is as shown in the figure as 35 degrees.
The figure below shows a claw hammer being used to pull a nail out of a horizontal board where 0 = 25.6°. The mass of the hammer is 1.00 kg. A force of 145 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Assume the force the hammer exerts on the nail is parallel to the nail. Ө 30.0 cm Single point of contact 5.00 cm (a) Find the force exerted by the hammer claws on the nail. magnitude KN direction above the horizontal (b) Find the force exerted by the surface on the point of contact with the hammer head. Ĵ) N ( Î +
An 66 kg man is climbing up a 7.0 m ladder that is resting against a smooth, frictionless wall. The ladder has a mass of 10 kg and it makes an angle of p=58° with the ground. The maximum horizontal force the ground can exerts to support the ladder is 342.ON. At what position, measured from the bottom along the ladder, as the man climbs the ladder will start to collapse? Answer: 5.55 m.
The diagram shows a uniform 30 cm strut weighing 5 N supporting a 10 N weight 10 cm from the pivot. Find the tension in the cable attached to the wall. 10 cm 10 N 30°
Please show me how to calculate where I need to place the stack of bricks on the right side in order for the beam to become balanced? Please refer to image.
The figure shows a 1280 kg car that has slipped over the edge of an embankment. People are trying to hold the car in place by pulling on a horizontal rope. The car's bottom is pivoted on the edge of the embankment, and its center of mass lies farther back, as shown. 2,4m 1,8m 3 If the car makes a 34 degree angle with the horizontal, what force must the people apply to hold it in place? T=_N
Modeled after problem 5 in the Problems_Torque_Statics: A 13.98-m-high and 12.18-m-long wall under construction and its bracing are shown in the figure. The wall is in stable equilibrium without the bracing but can pivot at its base. Calculate the force exerted by each of the 10 braces if a strong wind exerts a horizontal force of 586.31 N on each square meter of the wall. Assume that the net force from the wind acts at a height halfway up the wall and that all braces exert equal forces parallel to their lengths. Neglect the thickness of the wall. The angle between the braces and the wall is as shown in the figure as 35 degrees.
A uniform beam of length 1.0 m and mass 10 kg is attached to a wall by a cable as shown. What is the tension in the cable? What are the horizontal and vertical forces at the point where the wall and beam meet?
A 65 kg person is standing on a 25 kg wood board as shown. How far can they go past the left support without the board tipping? 1.5 m 2.5 m Page 4 1.5 m of 4 ZOOM + Find the value of if the system is in equilibrium M
The figure below shows a claw hammer being used to pull a nail out of a horizontal board where ? = 27.3°. The mass of the hammer is 1.00 kg. A force of 165 N is exerted horizontally as shown, and the nail does not yet move relative to the board. Assume the force the hammer exerts on the nail is parallel to the nail. A hand uses a hammer to pull a nail out of the ground. The head of the hammer is curved and touches the ground at a single point of contact at the center of the head. The nail in the ground makes an acute angle ? clockwise from the vertical. The nail is hooked in the hammer claw 5.00 cm horizontally to the left of the hammer head's point of contact to the ground. The hand pulls the hammer handle horizontally to the right 30.0 cm above the ground with a force vector F.(a) Find the force exerted by the hammer claws on the nail.magnitude kNdirection ° above the horizontal (b) Find the force exerted by the surface on the point of contact with the hammer head.( î + ĵ)…