The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s = 350, in units of 106 N/m². What are (a) the Young's modulus and (b) the approximate yield strength for this material? Assume & = 0.010. (a) Number (b) Number i Stress (100 N/m²) 11 Units Units E Strain 2ɛ

Q: A thin rectangular plate is uniformly, deformed, as shown. Determine the shear strain Yxy at P.…

A: Solution: The shear strain of the thin rectangular sheet in the y-direction can be obtained using…

Q: The wood beam has an allowable shear stress of Tallow = 5 MPa. (Figure 1) Figure 50 mm 50 mm 50 mm…

A:

Q: A thin rectangular plate is uniformly, deformed, as shown. Determine the shear strain y, at P.…

A: Given values, a = 21in b = 29in c= 0.16in d = 0.28in We have to calculate shear strain for the…

Q: A 18 cm long tendon was found to stretch 5.4 mm by a force of 14.0 N. The tendon was approximately…

A:

Q: The two bars shown in the figure are used to support a load P. When unloaded, joint B has…

A: The solids have a great property called elasticity owing to interatomic forces between them working…

Q: A metal slab of side (74+ 75) cm and thickness (74 + 25) cm is subjected to a tangential force of…

A:

Q: a) Figure Q2a shows a hollow tube of rectangular cross-section subjected to an axial compressive…

A: Write the given values with the suitable variables. P=250 kN=250×103 Nb=0.12 md=0.05 mt=0.003 m…

Q: A wooden dowel is subjected to a shearing force of 715N on its top cylindrical face. If the dowel…

A: Shearing force F=715 N, diameter of dowel d=3cm (radius r=1.5cm), height of dowel h=11 cm and shear…

Q: The following data was collected from a tensile test and plotted on a copper-nickel alloy. The gage…

A: We know that, the ultimate tensile strength is given by,Now, here from the plot, the maximum load…

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set by s =…

A:

Q: An aluminum wire 1.50 m long has a diameter of 0.750 mm.  If a force of 60.0 N is suspended from the…

A:

Q: Question 7. The following true stress-strain curve for a carbon nanofiber/epoxy with CaCO3…

A: Formula be used  σ=kεnσ is a true stressε is a true straink and n are constant From the graph we get…

Q: The figure shows the stress-strain curve for a material. The scale of the stress axis is set bys =…

A: s = 350 ×106 Nm2ε = 0.010

Q: Please no hand writing solution

A: Given that diameter of a solid circular shaft,D=2'' Applied torque,T=9 kip.in Strain ,ε=305×10-6

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).