The figure shows the layers of soil in the tube that is 10 cm by 10 cm in cross section. When the tube is supplied with water, a constant head difference of 30 cm is observed. Sample K (cm/sec) 30 cm A 2 x 10-3 B 3 x 10-3 4 x 10-3 A B |15 cm 20 cm 25 cm Compute the rate of water supply (in cm³/s). O 0.516 cm³/s O 0.147 cm³/s O 0.342 cm³/s O 0.230 cm³/s

The figure shows the layers of soil in the tube that is 10 cm by 10 cm in cross section. When the tube is supplied with water, a constant head difference of 30 cm is observed. Sample K (cm/sec) 30 cm A 2 x 10-3 B 3 x 10-3 4 x 10-3 A B |15 cm 20 cm 25 cm Compute the rate of water supply (in cm³/s). O 0.516 cm³/s O 0.147 cm³/s O 0.342 cm³/s O 0.230 cm³/s

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

pts Water flowing through a soil column with the following characteristics: K = 0.01 cm/s dh/dx = 0.01 Determine Darcy velocity (cm/d) 8.64 11.2 O 1,48 15.4 5.21 2.67
1. Water 3m/s 75mm Þ Determine mass flow rate [13.26 kg/s] 2. Oil RD = 0.86 +17 kg/s 100mm Þ Determine velocity [2.52 m/s] Given viscosities of water and oil are 0.001 Ns/m² and 0.03 Ns/m² respectively, determine the Reynolds number in examples 1. and 2. [2.25 X 10°, 7224] 3.
Two pumps whose characteristics are given in Sample Prob. 15.13 are to be used in parallel. They must develop a head h = 35 + 20Q2 as in the sample problem. (a) What is the flow rate with both pumps operating at 1800 rpm? (b) The speed of one of the pumps is reduced until it no longer delivers water. At approximately what speed will this happen? Sample Prob. 15.13: The two pumps (n = 1800 rpm) each have the following characteristics: h, ft: 100 90 80 60 40 20 Q, gpm: 0 110 180 250 300 340
Round off answer to two decimal places unless otherwise stated in the problem
Soil mechanics
A 1.5m square tank, 3m tall is drained by a 25mm-diameter orifice located at its bottom. If the tank is initially filled with water, how deep is the water in the tank after 45 minutes? Assume C=0.62
Water discharging into a 6 m wide rectangular horizontal channel from a sluice gate is observed to have undergone a hydraulic jump. If the flow depth and velocity before the jump are 0.5 m and 8 m/s, respectively, then which of the following statements is/are true? A Flow depth after the jump is 2.31 m. B Hydraulic jump formed is a weak jump. C Efficiency of jump is 65.6%. D Relative energy loss is 0.824.
The value of x is 8
B1
Two reservoirs are connected by two pipes in series,as shown below. Determine the flow rate using ken = 0.55 and kex= 1.8. Use the explicit form of the Colebrook-White equationdeveloped by Moody to solve for the friction factors. Let μ =1.003x10-3 kg/m-s
Water flows in a rectangular channel at a depth of 1.5 m. A 30 cm high smooth hump produces a drop of 15 cm in the water surface elevation. Neglecting losses, estimate the discharge per unit width of the channel. Solution: Refer to Figure 2.18. Let suffixes 1 and 2 refer to sections upstream of the hump and on the hump respectively as indicated in the figure. Energy Line V Е, У, 1 0.15 m √₂ Hump AZ = 0.30 m 2