The figure shows a rod of length L = 7.83 cm that is forced to move at constant speed v = 4.06 m/s along horizontal rails. The rod, rails, and connecting strip at the right form a conducting loop. The rod has resistance 0.577 N; the rest of the loop has negligible resistance. A current i = 81.9 A through the long straight wire at distance a = 9.15 mm from the loop sets up a (nonuniform) magnetic field throughout loop. Find the (a) magnitude of the emf and (b) current induced in the loop. (c) At what rate is thermal energy generated in the rod? (d) What is the magnitude of the force that must be applied to the rod to make it move at constant speed? (e) At what rate does this force do work on the rod? L. (a) Number Units (b) Number Units (c) Number Units (d) Number Units (e) Number Units xx •. xx XX XX

The figure shows a rod of length L = 7.83 cm that is forced to move at constant speed v = 4.06 m/s along horizontal rails. The rod, rails, and connecting strip at the right form a conducting loop. The rod has resistance 0.577 N; the rest of the loop has negligible resistance. A current i = 81.9 A through the long straight wire at distance a = 9.15 mm from the loop sets up a (nonuniform) magnetic field throughout loop. Find the (a) magnitude of the emf and (b) current induced in the loop. (c) At what rate is thermal energy generated in the rod? (d) What is the magnitude of the force that must be applied to the rod to make it move at constant speed? (e) At what rate does this force do work on the rod? L. (a) Number Units (b) Number Units (c) Number Units (d) Number Units (e) Number Units xx •. xx XX XX

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a current carrying conductor, see figure, the current flows in the direction as shown, what force/field will be induced and in what direction?
Dear sir Hand written solution is not allowed.
What do you calla closed conducting path? A Node B Short circuit C) Loop Junction
Please help
please answer part d, e and f
In a Curie-type paramagnet, all the ions with magnetic moments contribute to the total susceptibility, but in a metal, only very few of the free electrons contribute to Pauli paramagnetism. Why?
8. An iron ring has a mean circumferential length of 40 cm and a cross sectional area o 1 cm2. It is wound uniformly with 500 turns of wire. Measurements made with a search coil around the ring show that flux in the ring is 6Wb. If the relative permeability of the core is known to be 65, determine the current flowing in the windings.
9 ст 9 cm 25 cm- 15 cm -25 cm Q2 A core with three legs is shown in Figure. Its depth is 5 cm, and there are 200 turns on the leftmost leg. The relative permeability of the core 9 cm can be assumed to be 1500 and constant. What 2 A flux exists in each of the three legs of the core? What is the flux density in each of the legs? Assume a 4% increase in the effective area of the 200 turns 0.04 cm 25 cm air gap due to fringing effects (20) 9 cm Core depth 5 cm
With the aid of Figure Q4(a), explain Lenz's Law. Illustrate the direction of the induced voltage generated by the loop. B The applied magnetic field is increasing y Figure Q4(a)
2. The parallel conductors of 10 mm diameter each carry 100 A in opposite directions are separated by an air space of 50 mm. The conductors are 10 m long. The force on each conductor will be
The corecivity of a small magnet where the ferromagnet gets demagnetized is 3 x 10³ Am-¹1 The current required to be passed in a solenoid of length 10cm and number of turns 100, so that the magnet gets demagnetized when inside the solenoid is:
Consider the magnetic circuit given in below figure with parameters: u=105 Ho, d1=7.2 cm, d2-6.6 cm, d3=5.5 cm, d4=0.4 cm and N=493. Assume that all branches have the same cross-sectional area of 5 cm². Magnetic flux density is 0.4 Wb/m2 in the air gap. Based on the given configuration calculate the current I in [AJ in the coil. d2 dg Tolerance + 0.1 relative Answer: