The figure below shows a coil with N = 126 turns surrounding a long solenoid of length = 3.75 m, radius Rs = 0.192 m, and a turn density n = 4.08 m. Calculate the self-inductance of the solenoid and the mutual inductance of the solenoid and the coil. Find the total flux through the all the loops of the solenoid if the current in the solenoid is Is = 3.49 A and the current through the coil is Ic = 3.77 A and the magnetic fields from both the coil and the solenoid are in the same direction. i T-m²

Q: A solenoid with 485 turns has a length of 7.00 cm and a cross-sectional area of 3.50 x 10-9 m2. Find…

A: a) The inductance of the solenoid can be obtained as L=μ∘N2AlSubstituting the given values :L=(4π x…

Q: A solenoid with 515 turns has a length of 5.00 cm and a cross-sectional area of 3.10 x 10-9 m². Find…

A:

Q: A long solenoid with a axa square cross section has n turns per length sits iwth a vertical central…

A: The objective of the question is to find the mutual inductance between a long solenoid and a flat…

Q: A toroidal solenoid has 500 turns, cross-sectional area 6.25 cm2 , and mean radius 4.00 cm. (a)…

A: Given that, Number of turns (N) = 500 Cross-sectional area (A) = 6.25 cm2 Radius (R) = 4 cm=4×10-2 m…

Q: B=-Bo X @ y A coil of 15 turns, each of radius 1 centimeter, is rotating at a constant angular…

A: Here is solution of given problem. I = (25 × 10−3) π sin ωt Ampere I = 25 π sin ωt milli Ampere   If…

Q: A long, cylindrical solenoid with 60 turns per centimeter has a radius of 1.5 cm. (a) Neglecting end…

A: Faraday's Law state that the rate of change of magnetic flux across any closed circuit is…

Q: A solenoid has a length of 20 cm, a radius of 0.8 cm, and 350 turns, and carries a 2.9-A current.…

A: Find the self inductance of the solenoid. L=μ0N2AL…

Q: A long, cylindrical solenoid with 180 turns per centimeter has a radius of 3.5 cm. (a) Neglecting…

A:

Q: A solenoid has a winding of 400 turns, has a length of 30.0 cm and an area of 5.00 cm2. Find the…

A: Step 1: Step 2: Step 3: Step 4:

Q: A long solenoid with a axa square cross section has n turns per length nd sits iwth a verticla…

A:

Q: We have proved that the mutual inductance of coil 1 due to coil 2 are equal to the mutual inductance…

A:

Q: How many turns should a solenoid of cross-sectional area 0.035 m² and length 0.32 m have if its…

A: The solenoid’s cross-sectional area is,The solenoid’s length is,The inductance of a solenoid is,

Q: We have a perfect solenoid of radius 10 cm and length 50 cm with 50,000 loops. A constant current of…

A:

Q: The solenoid is 22.0 cm long and wound with 129 turns of wire. If the current in the solenoid is…

A:

Q: A coil wound around a core of ferrite material has N = 4.5 windings, length 1 = 10 mm and diameter D…

A: Given data :  No.of windings N = 4.5  Length l = 10 mm diameter D = 5 mm  Self induction of a…

Q: A long solenoid with a axa square cross section has n turns per length sits iwth a vertical central…

A: The mutual inductance between the long solenoid and the flat circular coil can be found by…

Q: has a self-inductance of 28 H. (a)    What induced emf opposes shutting it off when 90 A of current…

A:

Q: inductance (in H)

A:

Q: single loop is made around the center of a solenoid with a length of 20 m and a radius of 4 m. How…

A:

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.