The figure above represents the FM modulation of a square wave signal. Find the followings :( show you calculations) 1- FH 2-FL 3- The massage signal frequency.

Q: NOT AB AND E NOT OR Y

A: Given: A logic circuit diagram as shown in figure,  To find: Truth table for the above circuit.

Q: adding bcd numbers

A:

Q: The concept of the state of a dynamic system refer to a .maximum set of variables The root locus is…

A:

Q: Explain any four dynamic characteristics of   measurement system

A: Every instrument is sensitive towards some factors like heat, pressure, resistance etc. due to these…

Q: The static characteristics of the measurement instrument are act

A: In this question, The static characteristics of the measurement instrument are act....?

Q: Subject- Analog & Digital Communication There are five message signals generated by a source with…

A: Given that the question belongs to Analog and Digital Commutation subject. The given parameters are…

Q: Identify the component which is not available in digital Voltmeter? a. Clock generator b. ADC c.…

A: We need to select component which is not inside the digital voltmeter .

Q: When the load of a voltage multiplier is too small, __." Choices: the output voltage is unaffected…

A: Voltage multiplier is the circuit which is used to give high dc value of voltage at the output…

Q: Which is not a type of external noise? a. thermal noise b. atmospheric noise C. cosmic noise d. man…

A:

Q: In N-channel JFET the Id is controlled by_______. a.Idss b.Vgs c.Vds d.Ig

A:

Q: Convert n- cmil W-U of foot

A: Given unit  Ω-cmilfoot

Q: Crosstalk, shielding and grounding

A: According to question: Crosstalk: It is one of problem seen in communication system which occurs…

Q: ckt diagram of refrigerator

A: In refrigerator, split single phase induction motor is used to run the compressor unit. Compressor…

Q: The number of possible values for signals is restricted. a. Analog b. Digital c. Either (a) or (b)…

A: A digital signal is a signal which is represented as s sequence of discrete values.  In digital…

Q: Evaporator in absorption cooling system changes into vapors at low pressure? O i. Refrigerant O ii.…

A: Purpose of Evaporator in absorption cooling system

Q: Measures to be taken in protecting the electronic rotection of information centers

A:

Q: importance of familiarizing electrical terminologies to engineering students

A:

Q: How many select lines are required for a 1-to-8 demultiplexer? Select one: a. 4 b. 3 Cc. 2 d. 5

A: Given data, Select lines requires in 1-to-8 demultiplexer.

Q: Redo the question, a

A: It is given that: SS=150 KVAVP=3000 VVS=300 Vf= 50 HzVsupply=6250 V

Q: Which is not a type of external noise? a. thermal noise b. atmospheric noise C. cosmic noise d. man…

A:

Q: Accuracy of an instrument or device is the difference between the indicated value and actual value.…

A:

Q: 1. How does speaker convert electrical energy to sound energy? 2. How does microphone convert…

A: Solve the first question, unless the student has asked for a specific question to be solved, subject…

Q: A type of noise that is directly proportional to the frequency of the operation. a. shot noise b.…

A: Another quite noise that happens in transistors is referred to as transit time noise. Transit time…

Q: Purpose of electrical instrumentation

A: To find the purpose of electrical instrumentation

Q: a brief reflection on ELECTRICAL MEASUREMENT UNITS

A: Measurement is the act of finding an unknown physical quantity by using a standard quantity. The…

Q: Surge Protector Conclution

A: surge protector conclusion

Q: Need solution within 15 mins. Give 5 stars for correct solution

A: The solution is provided in the following section:

Q: The following are examples of an FM detector except for ___. a rectifier detector b PLL…

A: FM detector is instantaneous convert the frequency change the carrier signal to output counterpart…

Q: The figure (Figure 1) shows a portion of a silver ribbon with z = 12.0 mm and y =0.23 mm, carrying a…

A: Given Z1=12 mm y1=0.23 mm I=110 A in +x direction B=0.93 T in +y direction =By Assumption : free…

Q: name of symbol name of symbol name of symbol name of symbol name of symbol * name of symbol name of…

A: Hydraulic- Hydraulic is the technology that deals with the generation, control, and transmission of…

Q: B- What is the noise in communication sytems. Clasify the types of noise and how can elimiteate the…

A: we need to discuss what is the noise in communication system and  types of noise and how can we…

Q: A certain appliance uses 350 W. If it is allowed to run continuously for 24 hrs, how many…

A:

Q: 4.) Why is thermal noise sometimes called white noise?

A: White noise: It is a random signal having same intensity at different frequencies. Its power…

Q: Q4/ Compare between Wet and Dry Etching?

A:

Q: The information signal is always an analog signal. an analog signal in case of an analog carrier…

A: Correct option is an analog signal in case of an analog carrier why because information signal is a…

Q: How to know if the variable is independent

A: Independent variables- Independent variables are things that will be manipulated in the experiment,…

Q: What are the types of Biomedical Instruments

A: Biomedical instrumentation is the field of engineering that applies the knowledge and technology for…

Q: Group-1: 1. Draw the block diagram of temperature measurement system using thermistor as sensor with…

A: Thermistor: Thermistors are generallly composed of semiconductor materials. Although positive…

Amplitude modulation

A radio signal can carry information in the form of sound or image for broadcasting or communication. For it to be sent to a greater distance, the signal must be changed or modulated in some way. One of the easiest way is to change the amplitude of the signal with variations of the video or the audio signal. This is called Amplitude Modulaton. In this modulation information of message is carried in amplitude of carrier signal.