9 The factors affecting the capacitance are as follows, except:nature of materialseparation distance of the platesarea of the platesamount of voltage

We need to comment on what factors capacitance does not depend.

Answered: The factors affecting the capacitance…

The factors affecting the capacitance are as follows, except: O nature of material separation distance of the plates area of the plates amount of voltage

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter8: Capacitance

Section: Chapter Questions

Problem 8.1CYU: Check Your Understanding The capacitance of a parallel-plate capacitor is 2.0 pF. If the area of...

See similar textbooks

Similar questions

Find the total capacitance of the combination of capacitors in Figure 19.33. Figure 19.33 A combination of series and parallel connections of capacitors.
In Franklins time, a device for storing electric potential energy was called a Leyden jar. Today, we call that device a capacitor. Another term that is sometimes used is condenser. What ideas do these three terms bring to mind? What are the advantages and disadvantages of each?
Check Your Understanding Determine the net capacitance C of each network of capacitors shown below. Assume the C1= 1.0 pF, C2=2.0pF, C3=4.0pF, and C4=5.0 pF. Find the charge on each capacitor, assuming there is a potential difference of 12.0 V across each network.
A 10.0-F capacitor is charged to 15.0 V. It is next connected in series with an uncharged 5.00-F capacitor. The series combination is finally connected across a 50.0-V battery as diagrammed in Figure P20.83. Find the new potential differences across the 5.00-F and 10.0-F capacitors after the switch is thrown closed. Figure P20.83
Suppose that the capacitance of a variable capacitor can be manually changed from 100 pF to 800 pF by turning a dial, connected to one set of plates by a shaft from 0° to 180°. With the dial set at 180° (corresponding to C — 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. If friction is negligible, how much work is required to turn the dial from 180° to 0°?
If three unequal capacitors, initially uncharged, are connected in series across a battery, which of the following statements is true? (a) The equivalent capacitance is greater than any of the individual capacitances, (b) The largest voltage appeal's across the smallest capacitance, (c) The largest voltage appears across the largest capacitance. (d) The capacitor with the largest capacitance has the greatest charge, (e) The capacitor with the smallest capacitance has the smallest charge.
A pair of capacitors with capacitances CA = 3.70 F and CB = 6.40 F are connected in a network. What is the equivalent capacitance of the pair of capacitors if they are connected a. in parallel and b. in series?
Some camera flashes use flash tubes that requite a high voltage. They obtain a high voltage by charging capacitors in parallel and then internally changing the connections of the capacitors to place diem in series. Consider a circuit that uses four AAA batteries connected in series to charge six 10-mF capacitors through an equivalent resistance of 100 . The connections are thenswitched internally to place the capacitors in series. The capacitors discharge through a lamp with a resistance of 100 . (a) What is the RC time constant and the initialcurrent out of the batteries while they are connected in parallel? (b) How long does it take for the capacitors to charge to 90% of the terminal voltages of the batteries? (c) What is the RC time constant and the initial current of the capacitors connected in series assuming it discharges at 90% of full charge? (d) How long does it rake the current to decrease to 10% of the initial value?
A 2.0F capacitor and a 4.0F capacitor are connected in series across a 1.0-kV potential. The charged capacitors are then disconnected from the source and connected to each other with terminals of like sign together. Find the charge on each capacitor and the voltage across each capacitor.
Explain why electrons stop flowing when the potential difference between the plates of a capacitor equals the batterys terminal potential.
A capacitor is designed so that one plate is large and the other is small. If the plates are connected to a battery, (a) the large plate has a greater charge than the small plate, (b) the large plate has less charge than the small plate, or (c) the plates have equal, but opposite, charge.
A 4.00F capacitor and a 6.00F capacitor are connected in parallel across a 600-V supply line, (a) Find the charge on each capacitor and voltage across each, (b) The charged capacitors are disconnected from the line and from each other. They are then reconnected to each other with terminals of unlike sign together. Find the final charge on each capacitor and the voltage across each.