The electromotive force of a battery is given by E = 8 volts. A resistor wtih resistance R1 = 24 kSN is connected in series with the battery.What is the current through the circuit?Give your answer to at least two significance digits.AWhat is power loss in the resistor? (give absolute value as the input.)Give your answer to at least two significance digits.J/sSubmitYou have used 0 of 2 attemptsSave Series and Parallel configuration0.0/1.0 point (graded)Say you have two resistor with resistane R1 = 20 kN and R2 = 73 kN.What is the equivalent resistance if they are connected in parallel?Give your answer to at least two significance digits.What is the equivalent resistance if they are connected in Series?Give your answer to at least two significance digits.Submit

NOTE- Since the question in the 2nd image is graded, we will only solve the question mentioned in…

The electromotive force of a battery is given by E = 8 volts. A resistor wtih resistance R1 = 24 kSN is connected in series with the battery. What is the current through the circuit? Give your answer to at least two significance digits. A What is power loss in the resistor? (give absolute value as the input.) Give your answer to at least two significance digits. J/s

The electromotive force of a battery is given by E = 8 volts. A resistor wtih resistance R1 = 24 kSN is connected in series with the battery. What is the current through the circuit? Give your answer to at least two significance digits. A What is power loss in the resistor? (give absolute value as the input.) Give your answer to at least two significance digits. J/s

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter9: Current And Resistance

Section: Chapter Questions

Problem 70AP: A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the...

See similar textbooks

Similar questions

A 10.00-meter long wire cable that is made of copper has a resistance of 0.051 ohms, (a) What is the weight if the wire was made of copper? (b) What is the weight of a 10.00-meter-long wire of the same gauge made of aluminum? (c)What is the resistance of the aluminum wire? The density of copper is 8960 kg/m3 and the density of aluminum is 2760 kg/m3.
A 1,00-?O voltmeter is placed in parallel with a 75.0kresistor in a circuit, (a) Draw a circuit diagram of the connection, (b) What is the resistance of the combination? If the voltage across the combination is kept the same as it was across the 75.0-kresistor alone, what is the percent increase in current? (d) If the current through the combination is kept the same as it was through the 75.0-kresistor alone, what is the percentage decrease in voltage? (e) Are the changes found in parts (c) and (d) significant? Discuss.
A battery has an emf of 15.0 V. The terminal voltage of the battery is 11.6 V when it is delivering 20.0 W of power to an external load resistor R. (a) What is the value of R? (b) What is the internal resistance of the battery?
Consider the following circuit diagram. The potential difference across the battery is 40.0 volts, and it supplies a current of 5.00 amperes to the circuit. There is a current of of 2.70 amperes flowing through R1. Resistor R2 has a resistance of 5.50 ohms. What is the resistance of R3? Answer in ohms to two decimal places, but do not include units in your answer.
In the schematic below two batteries are in series and drive current through the circuit as shown. The first resistor has a voltage drop AV₁ = 1.2 V, the middle resistor has a resistance of R = 64, and the last resistor has a voltage drop AV₂ = 1 V. Given these parameters, what is the magnitude of current flowing through the circuit in milli-amps (mA)? Giver your answer to 3 significant figures. AV, ww 3.0 V 4.5 V ww ΔV, ww R
The electromotive force of a battery is given by E = 6 volts. A resistor wtih resistance R = 71 N is connected in series with the battery. What is the current through the circuit? Give your answer to at least two significance digits. A What is power loss in the resistor? (give absolute value as the input.) Give your answer to at least two significance digits. J/s
What is the equivalent resistor between the terminals a and b if you replace R1 by 38 Ohm and R2 by 34 Ohm ? This combination of resistors goes to infinity by repeating itself. Write your answer in units of Ohm. No decimal points is necessary. Maximum od 4% of error is accepted in your answer.
R = Two identical resistors of Ro= 41 Q are connected head-to-tail. www Express the resistance Ro of one of the resistors in terms of the resistivity p, length L, and the cross section area A. Calculate the total resistance R of the two resistors in ohms. R R
Consider the circuit shown in (Figure 1). For related problem-solving tips and strategies, you may want to view a Video Tutor Solution of Charging a battery. Part A Find the current in resistor R. Express your answer in amperes. V ΑΣφ I = A Submit Request Answer Part B Find the resistance R. Express your answer in ohms. ? R = Submit Request Answer Figure 1 of 1 Part C 28.0 V R Find the unknown emf E. Express your answer in volts. 4,00 A ? x 6.00 N 6.00 A E = V 3.00 N Request Answer Submit
In the circuit below, if the battery in the circuit below is 5.9V, resistor R1=76.03ΩΩ, and resistor R2=77.61ΩΩ, what is the magnitude of the current that passes through R1? Give your answer in units of milli-Amps (mA).
Three resistors, R1= 30 Ω, R2= 77 Ω, and R3=R, are connected in parallel with a 12 V battery. A) The total current flowing through the battery is 0.88 A. Find the value of resistance R. Express your answer using two significant figures. B) Find the current through each resistor. Enter your answers numerically separated by commas. Express your answers using two significant figures.
A battery has emf 30.0 V and internal resistance r. A 9.00 resistor is connected to the terminals of the battery, and the voltage drop across the resistor is 26.0 V. What is the internal resistance of the battery? Express your answer with the appropriate units. TE II Submit μÀ Value Provide Feedback Request Answer Units ?