The electric motor exerts a torque of 800N*m on the steel shaft ABCD when it rotates at a constant speed. Design specifications require that the shaft diameter is uniform from A to D and that the angle of twist between A and D does not exceed 1.5°. If it is known that the maximum shear must be less than or equal to 60MPa and G=77GPa. Determine the diameter which can be used for the axis. The figure is in the attached image

Q: The A-36 hollow steel shaft is 2 m long and has an outer diameter of 40 mm. When it is rotating at…

A:

Q: The cylinder of a hydraulic ram supported at the open end is 200 mm internal diameter and is…

A:

Q: I only need 5

A: Solution:

Q: The drive shaft of the motor is made of a material having an allowable shear stress of τallow= 72…

A:

Q: Torsion A hollow circular shaft has inside and outside diameters of 30 mm and 40 mm respectively.…

A:

Q: A compound shaft consists of an outside tube (1) and an inner tube (2) that are fully connected…

A:

Q: The torque of 250 kN.m produces a maximum shear stress of 48 MPa in the 8 m-long hollow steel shaft.…

A:

Q: Determine a.) the maximum torsional stress, τmax, and b.) the maximum angle of twist, φ, of the…

A:

Q: The diameter of and LCD = 240 mm. 1. The lengths LAB = LBC = 200 mm parts AB and CD of the bar is 25…

A: Find the angle of twist and torque .

Q: The dimensions of the cross section of an airplane fuselage are shown in figure 1. If the fuselage…

A: Given Data: The torque subjected to the fuselage is, T=8 MN·m=8 MN·m×1000 mmm=8×103 MN·mm. The…

Q: shear

A:

Q: If the shaft is made of red brass C83400 copper with an allowable shear stress of ?allow = 20 MPa,…

A: allowable stress = 20 Mpa  Length = 0.75 m  Modulus of rigidity G =37 GPa

Q: Problem 2: A steel tube having an outer diameter of 2.5 in. is used to transmit 10 hp when turning…

A: Given:D=2.5 inP=10 hpN=30 rpmζallow=12 ksi

Q: A circular solid shaft has a diameter of 60 mm and is subjected to a torque load of 8.7 kN•m.…

A: Given      Diameter, d = 60 mm  Torque load, T = 8.7 kN•m

Q: The 43-mm-diameter shaft is subjected to the torques shown. What is the angle of twist of end A with…

A: The given shaft can be drawn as, Free body diagram of CB and AB can be drawn as,

Q: a) Find the diameter of both shafts. b) If the modulus of rigidity of shaft (2) G is 77.2 GPa,…

A: for solution refer below images.

Q: A solid 0.64-in.-diameter shaft is subjected to the torques shown. The bearings shown allow the…

A: The problem is based on strength of material

Torsion

In mechanical engineering, torque, torsion, and twisting moment are three of the most important concepts which have different meanings. Torque is the consequence of a moment of a force that produces an angular acceleration in a body or induces rotational kinetic energy in a body. For instance, in an automobile, the power transmission shaft is a body that is always under rotation due to the external torque acting on it, this torque is created by the engine.