The Drag Polar Equation of an General Aviation Aircraft in clean configuration can be written as: Cp = 0.0270 + %3D 32.787 Its weight is 2300 lb and the wing area is 155ft2, Calculate the (L/D)max and the Minimum Thrust Required (Unaccelerated Level flight and Sea level Condition)

The Drag Polar Equation of an General Aviation Aircraft in clean configuration can be written as: Cp = 0.0270 + %3D 32.787 Its weight is 2300 lb and the wing area is 155ft2, Calculate the (L/D)max and the Minimum Thrust Required (Unaccelerated Level flight and Sea level Condition)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: What is the main cause of the increase in drag when you increased the angle of attack?

A: Drag is the aerodynamic effect that affects the motion through air. It is generated due to relative…

Q: An airfoil has a lift curve slope at 7/rad and angle at zero lift of -3deg. At what angle of attack…

A: Given data: The density of air in slug/ft3 is

Q: A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at…

A: To find: The power required to overcome aerodynamic drag. Given data. The drag coefficient is…

Q: which then reduces to the function 1+x f(x, y) = 1. + y (a) Suppose that the changes in power x and…

Q: 4.19 Calculate the drag coefficient for a wedge with a 20° half-angle at Mach 4. Assume the base…

Q: The lift on a spinning circular cylinder in a freestream with a velocity of 22 m/s and at standard…

Q: The lift on a spinning circular cylinder in a freestream with a velocity of 30 m/s and at standard…

A: Given data: Free stream velocity of air, V∞=30 m/s. At sea level conditions, density of air,…

Q: Laminar Flat-Plate Boundary Layer: Exact Solution 9.6 Plot the Blasius solution for the laminar…

A: Given: The velocity profile equation,

Q: Consider a rectangular wing with a NACA 0009 airfoil section spanning the test section of a wind…

Q: an angl ng in a w ing attacl is incline

Q: An aircraft has a total mass of (8.8000x10^1) kg and a wing area of (2.80x10^1) m2. It operated with…

Q: Derive a general expression to find circulation and the lift force for NACA 27014

Q: A small, fast boat has a specific resistance ratio of 0.06 (see Table 17.2) and displaces 125 long…

Q: The rectangular wings of a microlight aircraft have a combined spanwise length of 9.144 m and…

A: Given Length = 9.144 m Width = 0.9144 m Drag coefficient = 0.01 Lift coefficient = 0.3 Altitude =…

Q: 7. Calculate the minimum radius of curvature in the steady turn for a single-engined jet aircraft,…

A: Write the expression of minimum radius of curvature in the steady turn for a single-engined jet…

Q: In a laboratory, the drag forces that are generated on vehicles that carry are being studied…

A: Given data: Projected frontal area = 2 m2Drag force = 300 Nvelocity of air moving = 27 m/s T…

Q: Write down the Bernoulli equation and explain how the lift force is generated by an airfoil using…

A: The Bernoulli Equation is given by:P + ρgh + (1⁄2ρV2) = constant along a streamline (1)Where:P =…

Q: = 175 ft², aspect ratio of wing = 6.5. The maximum available thrust from the aircraft engine a…

Q: Problem 7: A small light plane with a wing area of 150ft² is cruising at 120mph at 7000ft altitude.…

Q: 16. The flow in a compressor cascade test has an angle of 60° at inlet and of 30° at outlet. The…

A: Givenα1=60°α2=30°sD=0.8

Q: An airplane with a NACA 662-215 airfoil cruises at 170 m/s at an altitude of 4550 m. The airfoil has…

A: Velocity = 170 m/s Altitude = 4550 m Aspect ratio = 9 Span length = 30 m Angle of attack = 2

Q: What happens if the required CL is larger than CLmax of your airfoil, and what speed regime is…

A: Given question: What happens if the required CL is larger than CLmax of your airfoil and what speed…

Q: 16. A boundary layer has a velocity profile that is approximated by a linear relationship:…

Q: Aircraft flying at an altitude of (3 Km ) with a velocity of (100 m/sec). The planform area of the…

Q: Task 3: An airplane with a NACA 23012 airfoil cruises at 150 m/s at an altitude of 6000 m. The…

A: Given data:- Span length of air foil S = 36 m Aspect ratio = 10 Speed, u = 150 m/s Altitude, h =…

Q: A three-blade propeller of a diameter of 1.5 m has a rotational speed is 60 Hz, the activityfactor…

A: The objective of the question is to calculate the required thrust to weight ratio for an aircraft to…

Q: The airplane as described has a stalling speed at sea level of 100 mph at the maximum take-off…

A: Given, vstall=100 mph=100×0.44709 m/s=44.704 m/sρ=0.002377 slug/ft3=0.002377×515.379 kg/m3=1.225054…

Q: A NACA 2412 airfoil with a chord of 0.64m is flying in an airstream of standard sea level…

Q: A three-blade propeller of a diameter of 1.5 m has a rotational speed is 60 Hz, the activity factor…

A: Given:The diameter of the propeller, The rotational speed, The activity factor, The static torque…

Q: Q 6(c) In your own words and using diagrams explain how lift is generated on a wing. Q 6(d) Estimate…

A: Lift force Lift force is a component of force perpendicular to the flowing fluid. Drag force Drag…

Q: 3.) Determine the induced drag force developed if a wing of span area 36m^2 and chord of 2.4m has a…

A: Given:Wing span area (S) = 36 m^2Wing chord (c) = 2.4 mLift coefficient (CL) = 1.2Velocity (V) = 52…

Q: n aircraft has the drag polar, C_d=0.015+0.05C_l^2 For a lift coefficient of 0.5, find the value of…

A: Given:Drag coefficient, Cd=0.015+0.05ClLift coefficient, Cl=0.5

Q: Choose a specific airfoil for an airplane and determine the lift and drag forces after that power…

A: Airfoil for an aeroplane: The wing of an aeroplane has a unique shape known as an airfoil. The…

Q: Flow separation over an airfoil occurs at high angle of attack. Lift coefficient of a wing is less…

A: given; Explain the following: Flow separation over an airfoil occurs at high angle of attack. Lift…

Q: 3 If the pressure difference in the wind tunnel experiment is 50 mmH,0, the density of air is 1.2…

Q: Calculate the lift and drag of the wing (full span) shown below (half span) if it is flying at 25000…

Q: 6. For a wing of aspect ratio AR, having an elliptical lift distribution, the induced drag…

A: 6) For a wing of aspect ratio AR, having an elliptical lift distribution, the induced drag…

Q: Consider a wing with a linear AR of 8.0 and a taper of 0.5, the wing has a wingspan of 196 ft and a…

A: Write the expression of maximum lift coefficient of the wing. CL,max=Cl,max0.86-0.002∧

Q: 5) A wedge airfoil is placed in a supersonic flow at M = 2. G. Calculate the lift and dra at 4 angle…

Q: CD=0.01 +0.02CL2. What is its maximum lift-to-drag (L/D) ratio?

Question

The Drag Polar Equation of an General Aviation Aircraft in clean configuration can be written as:
C2
Cp = 0.0270+
%3D
32.787
Its weight is 2300 lb and the wing area is 155ft?, Calculate the (L/D)max and the Minimum Thrust Required
(Unaccelerated Level flight and Sea level Condition)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Fick’s Law of Diffusion and Mass Transfer

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Answer this ole
Discuss and comment on the effect of drag polar for Re 5003352.
A new sports car has a drag corfficient of 0.30 and a frontal area of 18.5 ft<, and is traveling at 90 mi/h. How much power (in ft-lb/s) is required to overcome aerodynamic drag if air density is 0.002378 slugs/ft?
3) An advertising sign mounted on the roof of a car is 33 inches tall, 15 inches wide and 54 inches long (airflow direction). The underside of the sign is flush with the top surface of the roof. Take air properties to be: p = 0.075 lbm/ft' and u= 1.22x10 lbm/ft.sec. Used a pressure drag coefficient of 1.2 for the advertisement sign. Calculate the total drag on the sign and the power required to overcome its effect if the car is travelling at a constant speed of a) 12 mph and b) 45 mph. Note: Provide a schematic diagram (sketch) of the problem configuration (if applicable). Every numerical calculation must be preceded by the appropriate equation. Do not forget units & dimensions during your calculations.
Estimate the landing ground roll distance at sea level for the CJ-1. No thrust reversal is used; however, spoilers are employed such that L drag coefficient by 10 percent. The fuel tanks are essentially empty, so neglect the weight of any fuel caried by the airplane. The maximum lift coefficient, with flaps fully em- ployed at touchdown, is 2.5. 0. The spoilers increase the zero-lift,
An aircraft is required to climb with 10° of climb angle. The aircraft has a mass of 30,000 kg and produces 50,000 N of drag. Assume zero angle of attack and zero thrust setting angle. How much thrust the aircraft engine must produce?
A Mitsubishi A6M Zero which has a wing area of 22.44 square meters with a lift generated of 6,000 N. If the wingspan is 12 meters, Calculate the velocity at minimum thrust required at standard sea level conditions. Assume wing is an elliptical planform and parasite drag is 0.045.
D
Parvin bhai
An aircraft has the drag polar, C_d=0.015+0.05C_l^2 For a lift coefficient of 0.5, find the value of the drag coefficient and lift drag ratio? I am asking It For Second Time. Please Read the Question Carefully.
7. A 2700-lb car is traveling @ sea level at a constant speed. Its engine is running at 4500 rev/min. and is producing 175 ft-lb of torque. It has a drivetrain efficiency of 90%, a drive axle slippage of 2%, 15-inch-radius wheels, and an overall gear reduction ratio of 3 to 1. If the car's frontal area is 21.5 ft, what is its drag coefficient?
Calculate the Road load power for the case Toyota Prius (fronatal area =0.8m2 sliding over a street has coefficient of rolling resistance CR= 0.015, drag coefficient CD=0.26 air density=1.2 kg/m3 the mass of the car 1500 kg. O a. 3.48 kW O b. 2.15 kW O . 9.72 kW