The design speed for a two-lane road is 80 kmph. When a design vehicle with a wheel base of 6.6 m is negotiating a horizontal curve on that road, the off-tracking s measured as 0.096 m.The required widening of carriageway of the two-lane road on the curve is approximately

The design speed for a two-lane road is 80 kmph. When a design vehicle with a wheel base of 6.6 m is negotiating a horizontal curve on that road, the off-tracking s measured as 0.096 m.The required widening of carriageway of the two-lane road on the curve is approximately

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Draw the cross section of a 4 lane divided national highway with with unpaved shoulder on a plain…

A: Draw the cross section of a 4 lane divided national highway with with unpaved shoulder on a plain…

Q: 6 What is the correct limits of a Carriageway? Multiple answers allowed Edge of traffic lane to Edge…

A: All of the answers are correct. Carriageway is the portion of roadway on which the vehicle actually…

Q: The installation of suitable surface and sub-surface drainage system is an essential part of highway…

A: Surface and sub-surface drainage system is very important part of highway design and construction.…

Q: Compute the end area of the irregular cross-section described below: Width of Road = 9 meters 3.8…

A: Solution Cross-section of the earthwork is drawn below. All the areas are fill areas. Width of road…

Q: 4. A section of a freeway has the following properties in the design direction. Determine the level…

A: Interchange spacing = 105 = 2 miles/interchangeInterchange density = 510 = 0.5 interchange/mile

Q: Compute the cross sectional area for the roadway section at station 10+33.89 using the following…

Q: Congestion mitigation policies can themselves influence the "timing" of rural space. (A) True B)…

A: The statement is TRUE. CONGESTION MITIGATION ALLOWS THEM TO provide jam free traffic , crowded free…

Q: A design control that determines the future demand of a highway and can reduce the risk of under or…

A: In addition to their particular setting and character, a highway project also needs to take into…

Q: Given the following end-sections of a 15-m wide road whose side slope is 1.5:1. 8 4 6 4 + 580 4 +…

Q: RING 1 RING 2 $1 2 DJL $5 MAJOR STREET lead-lag lag-lag none $2 $6 BARRIER = Phase Number =…

A: Protected permitted operations are a combination of the permitted and protected modes. Left-turning…

Q: Compare the AASHTO system with the USCS system in road design

A: Answer:- AASTHO system: According to American Association of State Highway and Transport officials,…

Q: You are asked to: A. Determine the maximum peak-hour volume that the segment can serve at a LOS C.…

A: Given data: Lane width=3.4 m Number of lanes(N)=2 in each direction Lateral Clearance=3m 85%…

Q: passing and no passing sections

A: Passing sections of a highway refers to the zone of road where overtaking a slow moving vehicle is…

Q: Compute the cross sectional area for the roadway section at station 10+33.89 using the following…

A: Solution Draw the section of road at station 10+33.89 based on the given data (which is drawn…

Q: Determine whether Use 0• and 45 parking gives the highest parking number for an on-

Q: Patrice's Paving Company is fine grading a 3-acre lot prior to paving using a CAT 12K with the blade…

A: Given data: Angle of blade, 30o (2 ft overlap) Speed of grader, v=2.1 mph (forward)v=2.6 mph…

Q: nvironmental and cultural factors to consider of Pan American High

A: The network of highways that connect the North America and South America is considered as the…

Q: need

Q: An antique 6-lane urban parkway has the subsequent characteristics: 11-ft lanes; common roadside…

Q: Design a highway with the following criteria (Determine the minimum radius, widening and check if it…

Q: Different types of medians can be used in highways. Select one type and present it by providing a…

A: Medians/ Traffic separators- Median is used as a traffic separator to avoid the collision between…

Q: c) Table 2 presents the geometric and traffic characteristics of three road sections. As a Highway…

A: There are 5 types of the road as per IRC:1) National highway2) State highway3) Major district road4)…

Q: A consecutive upgrade consists of two sections, the first of 2 percent grade and 5000 ft long, and…

A: first of 2% grade and 5000 ft longsecond of 6% grade and 5000 ft longAverage passenger car speed (S)…

Q: The following cross-section notes of the road was examined to calculate volumes. The width of the…

Q: A direct factor that directly affects the required right of way necessary to construct the road.

A: Before knowing the factor firstly we should know the Definition of Right of Way or What is Right Of…

Q: What are the positive impact of onstructing highway through existing farmland to the community?

A: Following are the positive impact of constructing highway through existing farmland to the…

Q: what are the factors that are of specific importance in the location of scenic routes.

A: Scenic routes- It is a road or path designed to enjoy the natural beauty of any location through a…

Q: RING 1 RING 2 $1 2 $5 lead-lag lag-lag MAJOR STREET none $2 $6 BARRIER Phase Number = Protected…

A: Given:The above mode provides for efficient left-turn service, often without causing a significant…

Q: What is PIEV analysis in Highway engineering?

A: As per the PIEV analysis in highway engineering, the total reaction time of the driver is divided…

Q: RING 1 RING 2 $1 9 $5 MAJOR STREET $2 O none $6 BARRIER = Phase Number Protected Movement 43 MINOR…

A: The above mode provides for efficient left-turn service, often without causing a significant…

Q: Meaning of the Word "Road"

A: Meaning of Road :

Q: What type of highway curves does the picture falls under and what are the parameters needed to…

A: Question is based on the highway curves. In the question type of highway curves does the picture…

Q: Q2 / Estimate the monthly expansion factors for June, Apr, and Jan for a rural primary road for the…

A: It is required to find the monthly expansion factor for January, April and june month from the given…

Q: collecter

A: The urban principle arterial system includes the following subclasses Interstate,expressways

Q: What modern tools are used to create route surveys? Site these tools/software and their specific…

A: Given data: 5 modern tools to create Route survey To Find: Modern tools name ,uses ,advantages and…

Q: Discuss classification of highways very briefly with neat sketches?

A: The Nagpur Plan divides roads into 4 main categories: (1)National Highways (2)State Highways…

Q: Answer the following: 1. Identify the design speed, minimum surface, outside shoulder, and paved…

Q: Describe the main elements of road. Explain the typical cross section of road

A: The main elements of road are; Shoulders Bus Bays Parking lanes Sidewalks or footpaths Cross slope…

Concept explainers

Intersection Design

An intersection is a location where two or more roads or railways meet or join. The traffic movement is controlled at the intersection that depends on its design and type. It governs the operation, efficiency, speed, capacity, and safety of the highways, airways, and railways. The movement of the pedestrian causes hazards and delays at the intersection.

Question

Highway problem.

The design speed for a two-lane road is 80 kmph. When a design vehicle with a
wheel base of 6.6 m is negotiating a horizontal curve on that road, the off-tracking
is measured as 0.096 m.The required widening of carriageway of the two-lane road
on the curve is approximately
ALLA

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given-

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

$1 $5 MAJOR STREET 42 lead-lag lag-lag none 46 BARRIER -Phase Number -Protected Movement 43 MINOR STREET LU Permitted Movement >-Pedestrian Movement BARRIER In this ring and barrier diagram, what sequencing is used for the protected left turns? lead-lead
Four-legged intersection has 8 merging conflicts A True B False
From the following cross section notes where SS is 1.5H:1V and width of highway is 20.00 meters at every station. Determine the following: 1. Total road volume using end area 2. Total road volume using prismoidal formula 3. Total road volume using prismoidal correction Cross -Section Notes - 6.2 -5.3 0.0 STA 5+100 -6.0 -12.0 -4.0 10.0 -8.8 -X STA 5+160 - 4.2 -5.0 -8.0 -6.5 0.0 -2.0 8.0 -7.6 -X Draw the cross-section of profile of roadway per station.
How are economics factors in to affecting the alignment of roads?
Diverts traffic from any existing roadway whenever the construction operations block the flow of traffic. A) Barangay roads B Detour roads C) Bypass roads D) Access roads
designing a rural highway is required so how many lanes are needed in the peak hour based on the given information:v = 4000 vehicle/ hour (per lane )level terrainPt ( trucks ) = 15%Pr = 3%Fp =1lane width 3.6mlateral clearance 1.8mphf =0.85interchange density = 0.9 interchange/km..no LOS was given and the units (metric)
A highway crew measures the radius of curvature at a tight corner in a highway as 900 feet. What is the maximum safe speed?
I need a quick solution within 15 minutes With my best wishesT
How many numbers of conflict are present in a 4-legged intersection? a.12 b.8 c.4 d.6
From the following cross section notes where SSis 1.5H:1V and width of highway is 20.00 meters at every station. Determine the following: 1. Total road volume using end area 2. Total road volume using prismoidal formula 3. Total road volume using prismoidal correction Cross -Section Notes STA 5+100 - 6.2 -6.0 -12.0 -5.3 0.0 -4.0 10.0 -8.8 -X - 4.2 -2.0 8.0 STA 5+160 -5.0 -8.0 -6.5 0.0 -7.6 -X Draw the cross-section of profile of roadway per station.