Tie bars of 12 mm diameter are to be provided in a concrete pavement slab. The working tensile stress of the tic hars is 230 MPa, the average bond strength between a tie har and concrete is 2 MPa, and the joint gap between the slab is 10mm. Ignoring the loss of bond and the tolerance factor, the design length of the tie bars (in mm, round off to the nearest integer)

Tie bars of 12 mm diameter are to be provided in a concrete pavement slab. The working tensile stress of the tic hars is 230 MPa, the average bond strength between a tie har and concrete is 2 MPa, and the joint gap between the slab is 10mm. Ignoring the loss of bond and the tolerance factor, the design length of the tie bars (in mm, round off to the nearest integer)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

answer quickly
answer quickly
Please answer completely
Please answer only number 13. Thank you so much!
answer quickly
I need the correct answer
please answer question below step by step..
answer quickly
answer quickly
PLEASE ANSWER QUICKLY
I need the correct answer
A 10 m deep cut has side slope of 1.5 H: 1 V. The soil was tested and found to have the following properties: c = 25 kN/m², e = 1, = 18°, Y = 9.81 kN/m³. The factor of safety against sudden water level Sn down will be decimal places) Take: S₁ 6° 0.122 7° 0.116 14° 0.074 and G = 2.7. (upto two