The composite piston P is held in equilibrium by the pressure of the gas pC flowing in the pipe. If the pressure pA= 700 kPa and the pressure pB= 150 kPa, find pC. Piston mass is 20 kg. Answer: 317.5 kPa

Q: The figure shows a high-pressure hand pump used for boosting oil pressure in a hydraulic line. When…

A: The hand pump's principle is to create low pressure in order to pull subsurface water. Two or more…

Q: There are two liquids in the container in the picture: oil of density ρu=820kg/m3 and water of…

A: ρu=830 kgm3ρw=998 kgm3ω=10 radsecD=.76 mh1=.3 mh2=.45 mH=.9 m

Q: 1 m H Water Gate F 2 m 30° Figure 1

A:

Q: The uniform 5-m-long round wooden rod is tied to the bottom by a string. find the tension in the…

A: the rod weight acts at the middle 2.5m from the point C while the buoyancy is 2m from C W is the…

Q: Air Air Oil SGol 0.91 D C 1 m B 2 m Water 1.25 m 1.5 m 25 m Water 10.5 m

A: According to principle of Manometry, pressure of 2 points at the same horizontal level…

Q: 1. The tank is fined with water. Determine the resultant force acting on the triangular plate A and…

A:

Q: A closed tin of height h contains air at atmospheric pressure. It floats vertically in water as…

A: The Answer is below

Q: 3-32. The maximum blood pressure in the upper arm of a healthy person is about 120 mmHg. If a…

A:

Q: The parabolic end-plate of the trough shown here is subjected to a fluid pressure that aries…

A:

Q: A bucket hangs off the end of a rod rigidly attached to a pulley. A spring acts as a counterbalance.…

A:

Q: A 98.43ft vertical column of fluid (density is 1878 kg/m3) is located where is 31.66ft/sec2.…

A:

Q: Two tanks are linked together by a pipe and a tap farm. The temperature of the gases they contain is…

A: Given: To find: Equilibrium pressure after opening valve

Q: The total weight of the plunger and load is 30 kN, the plunger diameter is D=200 mm. Neglecting…

A:

Q: 2. Mercury is poured into the tube in the figure until the mercury occupies 375 mm of the tube's…

A: Given dataMercury is poured in to a uniform diameter tubeMercury occupies 375 mm of the tube's…

Q: 4. Determine the pressure difference between the points at A and B. Take the density of air as…

A:

Q: The gauge pressure of the air in the tank shown in the figure is measured to be 56 kPa.  Determine…

A: Given:Gauge pressure of the air in the tank, Pg=56 kPaSpecific gravity of liquid, sl=0.9Specific…

Q: The 100cm radius cylinder weighs 3.1 KN and rest on the bottom of a container which is 1.5 meter…

A: Given that, Diameter of the cylinder, d=1.2 m,Weight of the cylinder, W=3.1 kN,Lenght of the…

Q: For all additional Problem: Piston The piston shown in figure is held in equilibrium by the pressure…

A: Given PI=350kPa            PII=130 kPa           PIII=210 kPaForce on piston due to PI,…

Q: Patients suffering from decompression sickness may be treated in a hyperbaric oxygen chamber filled…

A: Given: The diameter of the cylindrical chamber is D=0.75 m The gauge pressure of oxygen in the…

Q: 3. Due to its slight compressibility, the density of water varies with depth, although its bulk…

A:

Q: 11. The figure shows a high-pressure hand pump used for boosting oil pressure in a hydraulic line.…

A: Given, For the high pressure hand pump, θ=15° Force, P=120 N. Diameter of the piston, d=46mm

Q: 4. Determine the pressure difference between the points at A and B. Take the density of air as…

A: Answer: ( PA - PB ) = 63.7662 kPa.

Q: For the vertical wall shown on the left, the oil thickness is assumed to be 0.2 m and its SG is 0.8.…

A:

Q: 3. A vertical frictionless piston cylinder contains air at a pressure of 300 KPa with atmospheric…

A:

Q: the gas pressure inside the cy

A: To find  gas pressure inside the cylinder

Q: P= 2,6 bar Hava 0,6 m Su (p=1000 kg/m³) 0,6 m 0,6 m Civa (p=13600 kg/m³)

A:

Q: The U pipe in the figure has a diameter of 1 cm and stands in balance as shown in the figure. When…

A: Given: Diameter of the tube D=1cm The volume of water added in the right tube V=20cm3 Relative…

Q: The tank is filled with water. Suppose that h = 4.0 m. Solve the problem using the integration…

A:

Q: Air in the accompanying piston-cylinder device is in equilibrium at 190 oC.The mass of the hanging…

A: Draw the figure.

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.