The components in the circuit shown below are ideal. If the op-amp is in positive feedback and the input voltage V, is a sine wave of amplitude 1 V, the output voltage V, is 1 k2 ww- +5 V 1 V 1 k2 Vo WW -1 V -5 V (a) a square wave of 5 V amplitude (b) an inverted sine wave of 1 V amplitude (c) a non-inverted sine wave of 2 V amplitude (d) a constant of either +5 or -5 V

Q: 4. Find the values of the input and output impedances in Figure - 4. Also, determine the closed-loop…

A: The given op-amp circuit diagram is shown below, The parameters are,ZIN=2 MΩ.ZOUT=200 Ω.AOL=50000.

Q: 3. In an ideal op-amp, which is not true?

A: The correct option along with the explanation is provided in the following section.

Q: 3. The gain value of a differential op-amp circuit is (a) positive (b) negative

A: The difference between the two input signals is amplified by a Difference Amplifier or Differential…

Q: Given the four statements, which of the following statements are not true about the operation of an…

A:

Q: occurs when the input waveform is changing at a rate that is greater than the rate the op-amp output…

A:

Q: Find the maximum frequency of an output sine wave which can be produced at an amplitude of 3.5 V if…

A: We have been asked to find the maximum frequency of an output sine wave which can be produced when,…

Q: The Op-Amp is configured as shown below, and the input is a sinusoid with frequency = 1kHz, and 1…

A: Input voltage is given as Vin=0.5sinωt T=11K=1msec The maximum and minimum voltage of the opamp…

Q: A certain op-amp is used in a feedback configuration having a gain of 20 and a bandwidth of 500 kHz.…

A: NOTE: as per our guidelines we are supposed to answer only one question. Kindly repost other…

Q: An op-amp comparator in a firing circuit can produce waveforms at the output of up to 28 V…

A: Given data: Input peak-to-peak voltage = 28V.  peak input voltage (Vm) = 14V. It is also given that…

Q: 3. In an ideal op-amp, which is not true? a) Open loop voltage gain is infinite b) Input resistance…

A: The correct option along with the explanation is provided in the following section.

Q: The type of the feedback in this circuit is:

A: In the given question we need to discuss about the type of feedback in system.

Q: For the op-amp shown in Figure, R1 = 4.7 Kohm and R2 = 10 Kohm. If the input voltage is -0.4V,…

A:

Q: hich of the following statements is not true about the operation of an op-amp? In an op-amp,…

A: Op-amp offers good common mode rejection ratio and offer good amplification to opposite signals than…

Q: For an inverted op amp. Does the supply voltage equal the output voltage

A: For an inverted op-amp output voltage is not equals to the supply voltage. In inverted op-amp, the…

Q: For an op-amp with negative feedback, the output is O a. equal to the input O b. fed back to the…

A:

Q: One way to measure the slew-rate limitation of an op amp is to apply a sine wave (or square wave) as…

A: Given  Frequency of input sine wave is f =1 MHz The peak to peak amplitude of  output wave form is…

Q: Q: Design an op-amp circuit that performs the following mathematical operation. Vout = -0.23 V1 –…

A: The op-amp is working in inverting configuration as the output is inverted with respect to the input…

Q: A certain op-amp has the following internal critical frequencies in its open-loop response: 125 Hz,…

A: The criticle frequencies, The signal frequency,

Q: 5. The open-loop gain of a certain op-amp is 175,000. Its common-mode gain is 0.18. Determine the…

A: An amplifier called an op-amp is designed to provide a high gain for differential inputs while…