The complex formed between salicylate ion and iron (I) in the pH range (0.5-2) is: tri-salicylato complex of iron (II) O di- & tri-salicylato complex of iron (III) mono-salicylato complex of iron (III) di-salicylato complex of iron (III)

The complex formed between salicylate ion and iron (I) in the pH range (0.5-2) is: tri-salicylato complex of iron (II) O di- & tri-salicylato complex of iron (III) mono-salicylato complex of iron (III) di-salicylato complex of iron (III)

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: Write the correct answer with 1 place after the decimal point. What is the molecular mass of…

A: What is the molecular mass of C10(N1O1]3?

Q: A harmful chemical named TNF has been found to be in the regional environment in Reno. Environmental…

A: Based on the given data, it is identified that TNF is consumed through fish, water, air, and settled…

Q: log 100 (try without a calculator!)

A: Logarithm is known as the exponent to which a number must be raised in order to get a certain new…

Q: B. Calculate the following information. USE THE FACTOR-LABEL METHOD TO DO YOUR CALCULATIONS!!! 1. A…

A: The density of a solution is calculated by the formula: Density=MassVolume Note: Since you have…

Q: Part II. Investigating the Bunsen Burner Record whether or not the wire melted in each region of the…

A: A question about Bunsen flame, which is to be accomplished.

Q: This was all one question. Could you complete the bottom portion?

Q: Open Sans 12 BIUA * 職日、 +] GO D bacterum can grow in the environment which has a laCK of…

A: 2. Arsenic and phosphorus are chemical analogues. They shows lot of similar behavior on chemical…

Q: what is 34 and 35 answers

A: 34) Given

Q: 28.9 nm to μm. could I get a step by step, please?

A: 1 nanometre = 0.001 micrometre 1 nm = 0.001 μm By using this conversion factor we can convert the…

Q: Calculate the C1 V1- 0.5 L V2- 0.6 L C2-0.0836 M C1- ?

A: It is given that the initial volume (V1) is 0.5 L with a final volume (V2) of 0.6 L and a final…

Q: HDPE and PS are both inert to bases and acids, which plastic would you rather chose to put 1 Liter…

A: HDPE is high density polyethylene is a thermoplastic made from many ethylene molecules and it is…

Q: STARTING AMOUNT How many moles of hydrogen are in 3.06 x 10 of glycine, CHNO,? ADFACTOR CJANO, 2…

Q: Questions 2 and 3 on the photo please!

Q: Can you hwlp us with number 4 in attached.. This is not a graded question as it is a practice…

A: Greater the number of H+ ions produced in the aqueous of stronger is the acid Let us consider an…

Q: Please help with number 12 and this is not a graded.This is not a graded question as it is a…

A: We see that the reaction rate significantly increases when dissociation of iodine bond takes place…

Q: Make a dilution series to get to 1:100. Start with making 1:10 dilution by adding 1mL of sample and…

A: A question based on concentration terms that is to be accomplished.

Q: The question should be in the picture, I'm just so confused.

A: The metals are the elements that have a tendency to lose electrons. The nonmetals have a tendency to…

Q: How many nails are present in 14.5 lb of annular ring nails if two dozen of annular ring nails weigh…

A: The weight of two dozens of annular rings is given. The number of nails in the given amount needs…

Q: You give your home health patient an unopened 500-mL bottle of guaifenesin and tell them to take 2…

A: Given:Volume of guaifenesin = 500 mLDosage = 2 teaspoons 4 times a dayTo determine:How long the…

Q: Hey, do you think that the answer should be 187.65 or 187.7? Thankyou for your help!

A: Rules for determining the number of significant figures in an answer : The result of an addition or…

Q: Sea Surface Temp (°C) 10 20 32

A: Sea surface temperature (SST) (also known as ocean surface temperature) is the temperature of water…

Q: ased on the given data, what is the λmax of cobalt? 0.1M Cobalt 300 0.451 325 0.467 350 0.584…

A: Given : We have to tell the lambda max for cobalt.

Q: Can you please help us with number eight. ? Please see the picture. This is not a graded question…

A: solution- Suppose volume of HCN is a mL and volume of NaCN is b mL the concentration of HCN and…

Q: What are in the distillate collected from the distillation?

A: (1) A receiver

Q: Answer and explain the 2 questions below. No copy-paste in google, please. When is magnetic…

Q: Q 25 please

A: Given:Molar mass of KMnO4 is 158.0g/mol.Volume of the solution is 3.00 liters.Molarity of the…

Q: 17. A stat chemistry test is requested. Which of the following tubes is recommended to use? O A.…

Q: 9/5(31)+32

A: Given, 9/5(31)+32

Q: hates 2. In a chromatographic experiment with a nonpolar stationary phase, which compou first;…

A: Given that the coloum chromatography

Q: _H2 + _N2 => _NH3

A: ANSWER

Q: What is Thurstone Scales?

A: The term thurstone scales has to be defined.

Q: Instructions: Draw the structure of the each compound next to its matching spectrum. Mark peaks on…

Q: I have attached a picture showing the questions i have. Numbers 5B and 5C are where i am confused.

Q: a. How many hydrogen atoms are in the picture? Nitrogen? b. Does the formula indicate how many atoms…

Q: 350 Line of sight

A: option last that is 380mL is correct answer

Q: Plz answer

A: To answer this question, we need to follow these steps:List the Ingredients of Each Toothpaste:…

Q: 1. NABH4 H. 2. H,О FEB 20

Q: A 25-mL specific gravity bottle was found to weigh 46.05 g when filled with water, and 52.93 g when…

A: Specific gravity is also known as Relative density. Specific gravity of a substance can be defined…

Q: can you please answer question #4 on th picture

A: #4: Net ionic reaction is written by canceling all the spectator ions and keeping only the reactants…

Q: nonmetal Lithium is a and sodium is a Lithium is in' group , and main group metal sodium is in group…

A: In this question we have to fill the blanks according to the options. And in the options we have…

Q: Draw the starting alkene that would lead to these major products under these conditions.

A: Alkenes are hydrogenated by the reaction with hydrogen in presence of finely divided nickel,…

Q: . What is the difference between temporary and permanent hardness?

A: Difference between temporary and permanent hardness :

Q: НО TSOH Q

Question

i need the answer quickly

The complex formed between salicylate ion and iron (I) in the pH range (0.5-2) is:
tri-salicylato complex of iron (II)
O di- & tri-salicylato complex of iron (III)
mono-salicylato complex of iron (III)
di-salicylato complex of iron (III)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

Which construction would you never use in the laboratory? (A) (B) (C) (D) (E) Construction D Construction B Construction C Construction E
Chemistry Help with observation(s) please -
Chemistry Interactive 3D display mode H₂C-9 Submit 9129₂293 -C-C-NH₂ 0 Request Answer
Please help with number four. We think the answer is B.This is not a graded question as it is a practice question . I am 60 years old and helping my son prepare for the AP exam in a few months. We do questions at the back of the textbook by Zumdahl and Zumdahl
as a laboratory analyst how can you reduce your waiting time during filtration
▼ Part A Interactive 3D display mode H₂ H₂C= Spell out the full name of the compound. Submit Part B CH₂ H₂C- Interactive 3D display mode CH₂ CH₂ Request Answer Submit =C- -C-CH₂ Spell out the full name of the compound. Request Answer
Catra wanted to determine the concentration of copper(II) chloride at an unknown concentration .She began by trying to determine the value of epsilon (ε) using beers law for copper(II) chloride. Catra remembered in lab when they wanted to solve for epsilon they would test the absorbance for three different concentrations of a known solution and then graph it. Catra got frustrated and asked Shera what to do next to determine epsilon. What should Shera tell Catra?
Can you please check my answers. Thank you.
Can you help with 13. This is not a graded question as it is a practice question . I am 60 years old and helping my son prepare for the AP exam in a few months. We do questions at the back of the textbook by Zumdahl and Zumdahl
Help with J!
OMe OMe OMe TBSO. HO SiMe3 BF 3*OEt₂ TBSO. OMe