The coefficient of static friction between the 50-kg crate and the ramp is μs = 0.35. The unstretched length of the spring is 800 mm, and the spring constant is k = 660 N/m. Determine the following: 1 The normal force acting on the crate is Blank 1 N. 2 The friction force acting on the crate is Blank 2 N. 3 The minimum value of x at which the crate can remain stationary on the ramp is Blank 3 mm.

Q: The 113-lb force P is applied to the 250-lb crate, which is stationary before the force is applied.…

A: GivenP=113 lbm=250lbμs=0.41μk=0.32

Q: 21° W A 190 kN horizontal force Pis applied to a 220 kN box resting on an 21° incline. The line of…

A:

Q: Determine the force P for impending sliding motion of the wedge to the left if the angle offriction…

A: Angle of friction φ = 16° Incline angle θ = 12°

Q: Determine the force P required to force the 16° wedge under the 99-kg uniform crate which rests…

A: Given: The mass of the crate m=99 kg The coefficient of friction for all surface (μ)=0.47

Q: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F -30 N…

A:

Q: Wedge Sample Problem The two 20kN blocks are pushed apart by the 15⁰ wedge of negligible weight. The…

A:

Q: A small block of weight W is placed on a plane inclined at an angle θ to the horizontal The…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: The 472-N force is applied to the 84-kg block, which is stationary before the force is applied.…

A:

Q: Determine the force P required to force the 18° wedge under the 83-kg uniform crate which rests…

A: given The coefficient of friction for all surfaces is 0.39 weight = 83x9.81=814.23 N

Q: This climber (mass=52kg) is maintaining this posture while grabbing onto a rock at P3 and reaching…

A:

Q: Q4: The uniform box shown in next figure, has a mass of 40 Kg. If the two forces T = 60 N and F =30…

A:

Q: The 783-N force is applied to the 117-kg block, which is stationary before the force is applied.…

A:

Q: Determine the maximum possible mass (m) in kilograms so that the block will remain in position…

A:

Q: Assume μs = P 0.47, Mk = 0.36. Answer: F = i Hs Hk lb

A: Given,  P= 114 lb  W= 220 lb

Q: I UBC Engineering The 4 kg block sits on the edge of a disk with a radius of r = 1.25m. a. Assuming…

A: First, we need to calculate the centripetal force acting on the block. The centripetal force is the…

Q: 2. Two men are sliding a 100-kg crate up an incline. If the lower man pushes horizontally with a…

A: Please see the attached images for the solution. If there are queries or if the images are not…

Q: The 499-N force is applied to the 102-kg block, which is stationary before the force is applied.…

A: Given data: P=499 Nm=102 kgθ=36°μs=0.65μk=0.43 Need to determine the magnitude and direction of…

Q: The 76-lb force P is applied to the 170-lb crate, which is stationary before the force is applied.…

A:

Q: A roll of paper has a uniform weight of 2kN and is suspended from the wire hanger so that it rests…

A: Given, Weight of the roll paper = W = 2 kN Angle θ = 30o Coefficient of friction = μ = 0.3 Radius of…

Q: The 381-N force is applied to the 83-kg block, which is stationary before the force is applied.…

A:

Q: The 517-N force is applied to the 95-kg block, which is stationary before the force is applied.…

A:

Q: The 111-lb force Pis applied to the 230-lb crate, which is stationary before the force is applied.…

A: To find the frictional force

Q: 3. Car A has a mass of 1.4 Mg with center of gravity at point G as shown in Fig. 3. If car B exert a…

A:

Q: Q6: The 1.2 kg wooden block is used for level support of the 9 kg can of paint. Determine the…

A:

Q: m = 40 kg 4) Determine the magnitude and direction of the friction force which the vertical wall…

A:

Q: The 68-lb force P is applied to the 160-lb crate, which is stationary before the force is applied.…

A:

Q: Two blocks A and B of mass 200 kg and 100 kg respectively are placed in contact with each other as…

A:

Q: The coefficient of friction between all surfaces is us = 0.4 and UK = 0.3. The mass of A is 10 kg…

A:

Q: DRAW FREE BODY DIAGRAM DETERMINE THE AMOUNT OF NORMAL FORCES EXERTED ON THE CONTAINER. ANSWER IN 2…

A: Given:m=41.2 Kgx1=0.23 mx2=0.19 mk=2507 N/mμ=0.6

Q: Q 2 : In the system shown in the figure. When a vertical force F=500N acts on the point A, determine…

A:

Q: The 491-N force is applied to the 102-kg block, which is stationary before the force is applied.…

A:

Q: The 50-kg block rests on the horizontal surface, and a force P = 200 N, whose direction can be…

A:

Q: 4° 17° 1.2 m 71 kg 0.5 m A 17⁰

A: Given-Information:- Wedge Angle, θ1 = 17°Mass, m = 71 kgCo-efficient, μ = 0.38Length, L = 1.2…

Q: Q2: Shown below is a 50 lb block. The coefficient of friction are u=0.3 between the block and the…

A:

Q: A (10 Kg mass) block is resting on a rough horizontal surface for which the coefficient of friction…

A: Given coefficient of friction = 0.30 Given mass of the block = 10kg  Draw free body diagram of the…

Q: S If the coefficients of static friction at contact points A and B areμ = 0.21 andμ¹ = 0.24…

A:

Q: Two blocks A and B have a weight of 10 lb and 6 lb, respectively. They rest on the inclined plane…

A: Two blocks A and B have a weight of 10 lb and 6 lb, respectively.They rest on the inclined plane…

Q: Determine the force P required to force the 18° wedge under the 83-kg uniform crate which rests…

A:

Q: The crate, which has a mass of 140 kg, is subjected to the action of the three forces shown in the…

A: The frictional force is the force which comes into action when friction generated between two bodies…

Basic Terminology in Mechanics

The area of science and mathematics concerned the motion of the objects, the relation between the force matter, and motion if specified. Forces exerted over the objects result in displacements or changes in the position of an object concerning its environment. This branch of physics keeps its roots in Ancient Greece in the form of the scripts of Aristotle and Archimedes.