Answered: The cable is attached in bar AB as…

The cable is attached in bar AB as shown in the figure. Determine the tension force in the cable and the reaction at support A. 1.5m &m 4M T 200 3.5m

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter5: Displacement And Force In Two Dimensions

Section: Chapter Questions

Problem 82A

See similar textbooks

Related questions

Q: Find the tension in the wire BA and BC (to significant figure)

A: The balancing force in the horizontal direction is given as shown below. The balancing force in the…

Q: The uniform beam shown in figure 4 weighs 500N and supports a 700N load. Find the tension in the tie…

A: weight of beam= 500 Nweight of load= 700 N Let T= tension in string

Q: A 50-kg block is suspended as shown. The beam is weightless and is hinged to the wall at A. The…

A: Given : Mass of block=m=50 kg In this question we have to find the magnitude of Tension T in the…

Q: Unless otherwise instructed Use g =10m/s2 Answer in SI unit to 2 decimal places Sam and Joe are…

Q: A cook holds a 1.95-kg carton of milk at arm's length (see the figure below). What force F, must be…

Q: 5. If the tension in the cable is 400 N, determine the magnitude and direction of the resultant…

Q: At the back of the leg, two muscles pull on the Achilles tendon to create an upward force. Estimate…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Question 2- The 60-lb collar A can slide on a frictionless vertical rod and is connected as shown to…

A: The 60-lb collar A can slide on a frictionless vertical rod and is connected as shown to a 65-lb…

Q: Each cord can sustain a maximum tension of 500 N. Determine the largest mass of pipe that can be…

A: Given that:- Maximum tension sustained by each cord=500N

Q: 12.6 ft 7.2 ft 12.6 ft 16.8 ft 9.9 ft Three cables are used to tether a balloon as shown. Determine…

A: Solution:-Given thatTAB=60 lb

Q: Four l-in.-diameter pegs are attached to a board as shown. Two strings are passed around the pegs…

A: A couple is a pair of equal forces acting opposite to each other. It is also the twisting force that…

Q: Answer the following question: 1. Draw the free-body diagram of the truss that is supported by the…

A: To draw the free-body diagram of the truss that is supported by the cable AB and pin C. The given…

Q: HW Blocks A and B have a mass of 7 kg and 10 kg. respectively. Using the coefficients of static…

A: Let the largest vertical force which can be applied at P without causing any motion be T The…

Concept explainers

Newton’s Third Law of Motion

The horse pulls the cart and the cart pulls the horse in response as per Newton third law. So the big question is, “Don’t the two forces cancel each other? How does the cart accelerate?”

Question

The cable is attached in bar AB as shown in the figure. Determine the tension force in the cable and the
reaction at support A.
1.5m
3m
4M
T
200KN 3.5m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Two muscles in the back of the leg pull upward on the Achilles tendon, as shown below. (These muscles are called the mediaI and lateral heads of the gastrocnemius muscle.) Find the magnitude and direction of the total force on the Achilles tendon. What type of movement could be caused by this force?
Find the magnitude of the tension in each supporting cable shown below. In each case, the weight of the suspended body is 100.0 N and the masses of the cables are negligible.
Two children push on opposite sides of a door during play. Both push horizontally and perpendicular to the door. One child pushes with a force of 17.5 N at a distance of 0.600 m from the hinges, and the second child pushes at a distance of 0.450 m. What force must the second child exert to keep the door from moving? Assume friction is negligible.
A body of mass 100 kg is weighed at the North Pole and at the equator with a spring scale. What is the scale reading at these two points? Assume that g=9.83m/s2 at the pole.
As shown below, if M=5.50kg , what is the tension in string 1?
When using a pencil eraser, you exert a vertical force of 6.00N at a distance of 2.00cm from the hardwood-eraser joint. The pencil is 6.00mm in diameter and is held at an angle of 20.0 to the horizontal. (a) By how much does the wood flex perpendicular to its length? (b) How much is it compressed lengthwise?
In order to lift a shovelful of dirt, a gardener pushes downward on the end of the shovel and pulls upward at distance l2 from the end, as shown below. The weight of the shovel is mg and acts at the point os application of F2 . Calculate the magnitudes of the forces F1 and F2 as functions of l1 , l2 , mg, and the weight W of the load. Why do your answers not depend on the angle that shovel makes with the horizontal?
Why are the forces exerted on the outside world by the limbs of our bodies usually much smaller than the forces exerted by muscles inside the body?
Ina traction setup a broken bone, with pulleys and rope available, how might we be able to Increase the force along the tibia using the weight? (See Figure 4.30) (Note that the tibia is the shin bone shown in this image.) Figure 4.30 A leg is suspended by a traction system in which wires used to transmit forces. Frictionless pulleys crw.ge the direction of the force T without changing Its magnitude.
A crate of mass 100.0 kg rests on a rough surface inclined at an angle of 37.0with the horizontal. A massless rope to which a force can be applied parallel to the surface is attached to the crate and leads to the top of the incline. In its present state, the crate is just ready to slip and start to move down the plane. The coefficient of friction is 80of that for the static case. (a) What is the coefficient of static friction? (b) What is the maximum force that can be applied upward along the plane on the rope and not move the block? (c) With a slightly greater applied force, the block will slide up the plane. Once it begins to move, what is its acceleration and what reduced force is necessary to keep it moving upward at constant speed? (d) If the block is given a slight nudge to get it started down the plane, what will be its acceleration in that direction? (e) Once the block begins to slide downward, what upward force on the rope is required to keep the block from accelerating downward?
Explain why the forces in our joints are several times larger than the forces we on the outside with our limbs. Can these fortes be even greater than muscle forces?
Check Your Understanding Find the angle between forces F1and F3in Example 2.16.