The buck regulator has an input Vs=12V. The required average outp voltage is Va=5V and R=500ohm and the peak-to-peak output ripple volta is 20mV. The switching frequency is 25kHz. If the peak-to-peak rip current of inductor is limited to 0.8A, Determine (i) the duty cycle D, (ii) the filter inductance 1, (iii) filter capacitance C (iv) the critical values of L and

The buck regulator has an input Vs=12V. The required average outp voltage is Va=5V and R=500ohm and the peak-to-peak output ripple volta is 20mV. The switching frequency is 25kHz. If the peak-to-peak rip current of inductor is limited to 0.8A, Determine (i) the duty cycle D, (ii) the filter inductance 1, (iii) filter capacitance C (iv) the critical values of L and

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

R1=10 20V R2=52 R4=52 R5=2.52 A C R3=2.52
if the resistor R1 and R2 terminals are connected across each and R3 is connected along single terminal. If the R1=5 R2=10 and R3=15 ohms, what will be the Rtotal?
Please answer the "required" portion. Show full solutions with brief explanation. Required: - total resistance in the picture - type of circuit (either parallel-series or series-parallel) between terminals - AC - BC
3
DDD (B) Figure 1-3 (A) 15) The symbol in Figure 1-3(A) represents the A) AND B) OR 16) The symbol in Figure 1-3(C) represents the A) OR B) NOT function. C) NOT function. C) AND D) AND/OR D) XOR 15) 16)
In step 3, what is the potential difference across D2 after the jumper wire is connected
Please answer all subparts for like either dislike.. Please Answer
Based upon the following assumptions: V1 = 13V, V2 = 19V, R1 = 0.9kQ, R2 = 9300, R3 = 3kQ, R4 = 3.4kQ, R5 = 1.2k2. If R5 is the load resistor find VTH Answer in volts with 3 significant digits, only enter the number, don't enter the units. V1 V2
Question 12 Signals can be neither analog or digital digital either analog or digital analog
Q3\ Draw the symbols of the following electronic devices. 1- LDR, 2-DIAC, 3-p-channel JFET, 4- Current meter
Please answer the table(instruction in figure 4) using this values: D1 = 1N4148 R= 12kohms DCsweep = V1 from -1V to 1V with 0.1 increments
It is a Basics electrical subject. Please show the complete and correct ans.