The brake piston consists of a full circular part. Its cross section is shown in (Figure 1). Suppose that a = 22 mm, b = 80 mm, c = 50 mm, d = 40 mm, e = 20 mm, f = 45 mm. Figure a с b 1 of 1 Part A Determine the interior surface area of the brake piston. Express your answer to three significant figures and include the appropriate units. A = LLA Value Submit Request Answer < Return to Assignment Units Provide Feedback ?

The brake piston consists of a full circular part. Its cross section is shown in (Figure 1). Suppose that a = 22 mm, b = 80 mm, c = 50 mm, d = 40 mm, e = 20 mm, f = 45 mm. Figure a с b 1 of 1 Part A Determine the interior surface area of the brake piston. Express your answer to three significant figures and include the appropriate units. A = LLA Value Submit Request Answer < Return to Assignment Units Provide Feedback ?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

The Figure to the right shows a manufacturing process? What is this process called? 2. Identify the parte from 1 to 8 3. Explain how this process is performed? 1.
Q11 Com Pare between the following 1-blast furnace alld cu fola furnace 2-Saidalld pressure die casting B- Cold alnd hot rolling processes 1
D= 1.75 in d= 0.75 in r= .120 in
e?Y dx sin?x cos 3y oy
8 the ban
Question 6 a) The bore of each cylinder in a six-cylinder car engine is 45 mm and the stroke for each piston is 125 mm. calculate the cubic capacity of the engine in cubic centimetres (cm³); and calculate the clearance volume per cylinder for a compression ratio, r, of 8.75. b) The bore of each cylinder in a four-cylinder four-stroke internal combustion engine is 38 mm and the stroke of each piston is 165 mm. During testing, the engine runs at 180 revolutions per minute (rpm) with a pressure-volume indicator diagram showing a mean net area of 3.4 cm² and a diagram length of 1.2 cm. The pressure scale on the indictor diagram is set to 150 kN/m² per cm. Calculate the mean effective pressure (m.e.p) and the indicated power developed by this four-cylinder four-stroke engine. c) Figure Q6c shows a pulley system with a suspended load w of 2000 N. Calculate the following: (i) (ii) (iii) (iv) The effort force (FEffort) necessary to lift and hold a load of 2000 N. The ideal mechanical advantage…
the answer should be 30.85. since it was rounded off from 30.85376475
12
Find the Ixx value for the plate as shown below, where b1=d2=18 mm, d1=85 mm,b2=65mm. (ENTER ONLY THE VALUES IN THE BOXES BY REFERING THE UNITS GIVEN IN THE BRACKET) b1 b2 d2 d1 O The X value (unit in mm) =.
Topic: Gear complete the table below. Answer only no. 9-11 in the table.
use 3 sig figs pls
3) Graphically trace the area which contributes to the load for each joint of the middle parallel chord truss shown on the plan from a distributed area load. Also complete the free body diagram for the section shown for the truss on the bottom figure (with loads) with the appropriate directions (senses). 0.5P (3) 3 P