Answered: The Bragg's angle in the first order… | bartleby

Related questions

Question

The Bragg's angle in the first order for (220) reflection from nickel (FCC) is (38.2° ). When X-rays of wavelength 1.54 A° are employed in a diffraction experiment. Determine the lattice parameter of nickel?

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Consider scattering with electrons of 54 eV on a crystal with planes separated by 0.22 nm. How many diffraction peaks should be expected? Justify your answer
Young's experimental setup can be used to monitor the width of the lead wires in transistors. The cables are placed in a narrow opening as shown in the figure. The opening is illuminated with highly coherent light. The position of the tenth maximum is measured on a screen located at 0.5m. The expected diameter of the wires is 0.100±0.005 mm. (a) What is the maximum deviation that the position of the tenth maximum can have so that the cable has an acceptable diameter? What would happen if the first maximum was used as the criterion, would the decision be easier or more difficult?
Refractive index of water at 283K is 1.34 for radiation of wavelength 580 nm. What is the polarizability of the molecule?
Quartz is a uniaxial birefringent material with refractive indices no=1.5534 and ne=1.5443. It is desired to make a quarter-wave plate of quartz for use with a Sodium laser of wavelength λ0=589 nm. Calculate the minimum thickness of the plate.Give your answer in micrometers to 1 d.p.
The vanadium crystallizes in the body centered cubic lattice with a lattice parameter a. The X-ray diffraction data were collected from this compound and the following first four Bragg positions 20 (degrees): 21.06, 30.17, 37.03 and 43.10 were registered. The wavelength of the used X-ray radiation is 2 = 1.54Á. 1- Give the Bragg's Law. 2- Determine the inter-planer spacing d of the family of lattice planes (hke) of the cubic system. hkt 3 - Using the structure factor, determine the allowed reflections of the body centered cubic. 4- Index the four Bragg angles given above and calculate the cell parameter a.