The boundary layer thickness at a distance of 2 m from the leading edge of a flate plate kept at zero angle of incidence to the flow direction is 0.1 cm. The velocity outside the boundary layer is 30 m/s. The boundary layer thickness at a distance of 5 m from leading edge is [Assume laminar boundary layer]

The boundary layer thickness at a distance of 2 m from the leading edge of a flate plate kept at zero angle of incidence to the flow direction is 0.1 cm. The velocity outside the boundary layer is 30 m/s. The boundary layer thickness at a distance of 5 m from leading edge is [Assume laminar boundary layer]

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter7: Seepage

Section: Chapter Questions

Problem 7.1P

See similar textbooks

Similar questions

Solve and provide answers
In horizontal pipe, which of the following is constant? Pressure headElevation headVelovity head 12
Solve correctly
Consider a laminar flow in the x-direction between two infinite parallel plates (Couette flow). The lower plate is stationary and the upper plate is moving with a velocity of 1 cm/s in the x-direction. The distance between the plates is 5mm and the dynamic viscosity of the fluid is 0.01 N-s/mlf the shear stress on the lower plate is zero, the pressure gradient, D, (in N/m² per m, round off to 1 decimal place) is. ap ax 2-61965 26-6-2 = 2 2012 201 2013-0
Question In fully developed laminar flow in a circular pipe, if the velocity at midway between the wall surface and the centerline is measured to be 6 m/s, then the velocity at the centre of pipe is
Problem 13.11 A thin plate is moving in still atmospheric air at a velocity of 5 m/s. The length of the plate is 0.6 m and width 0.5 m. Calculate (i) the thickness of the boundary layer at the end of the plate, and (ii) drag force on one side of the plate. Take density of air as 1.24 kg/m' and kinematic viscosity 0.15 stokes. siela lo dibivW
Consider a laminar flow in the x-direction between two infinite parallel plates (Couette flow). The lower plate is stationary, and the upper plate is moving with a velocity of 1 cm/s in the x-direction. The distance between the plates is 5mm and the dynamic viscosity of the fluid is 0.01 N-s/m². If the shear stress on the lower plate is zero, the Әр pressure gradient, (in N/m² per m, round off to əx 1 decimal place) is
1) At small Reynolds numbers, the viscous forces are larger than the inertial forces and large enough to suppress the rapid fluctuations of the flow. These flows are called laminar flows. True or False 2) The control volume is selected arbitrary, but the bounding control surface should be fixed. True or False 3) In the following figure, which control volume is the best? a) cannot be determined b) CV B c) CV A = CV B d) CV A
The following statements are true except: O The ordinate for influence line for shear of simply supported beam will not exceed 1 O The ordinate for influence line for moment can be greater than 1 O The ordinate for influence line for moment of a simply supported beam will not exceed 1 O The ordinate for influence line for reaction of a continuous beam will exceed one
pressure gradient is required.
Find the pressure gradient
Complete answer