The boom is supported by a ball-and-socket joint at A,and a wire at B. If the two 5-kN loads lie in a planewhich is parallel to the x-y planc, determinc the tensionin the cable at B and the x, y, z components of thereaction at A.Solution5 kN5 kN.30TB =kN3 mXA =kNYA =kNZA =kN2 mB-y

The boom is supported by a ball-and-socket joint at A, and a wire at B. If the two 5-kN loads lie in a plane which is parallel to the x-y planc, determine the tension in the cable at B and the x, y, z components of the reaction at A. Solution 5 kN 30 5 kN- 30 TB = kN 3 m XA = kN YA kN %3! ZA kN 2 m B

The boom is supported by a ball-and-socket joint at A, and a wire at B. If the two 5-kN loads lie in a plane which is parallel to the x-y planc, determine the tension in the cable at B and the x, y, z components of the reaction at A. Solution 5 kN 30 5 kN- 30 TB = kN 3 m XA = kN YA kN %3! ZA kN 2 m B

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

INFLUENCE LINE PROBLEM a. Determine the maximum positive ordinate for member DC. b. Determine the location of a point load that will give the maximum compressive force for member AB. show solution asap ,answers in 4 decimal places
7. Determine the horizontal and vertical components of reaction at the pin A and the tension developed in cable BC used to support the steel frame. TI 60 kN B ImIm- -1m- T 3 m A 30 kN - m
The light right-angle boom which supports the 360-kg cylinder is supported by three cables and a ball-and-socket joint at O attached to the vertical x-y surface. Determine the reactions at O and the cable tensions. A Ox - Answers: IM TAC = i Me C 0.65 m y 1.05 m! 0.65 m 10 B 360 kg 1.30 m 2.30 m N Oy E 1.45 m II D N TBD = 1.45 m Hr x N O₂ = Mi N TBE = i N N
Problem 4: The wall crane supports a load of 800 lb. Determine the horizontal and vertical components of reaction at the pins A and D. Also, what is the force in the cable at the winch W? 4 ft- E W 800 lb
N=25
IHE BARS AB AND AC ARE JÕINED BY A PIN AT A AND A HORIZONTAL CABLE. THE VERTICAL CABLE CARRYING THE 200-kg MASS IS ATTACHED TO THE PIN AT A. DETERMINE THE TENSION IN THE HORIZONTAL CABLE. NEGLECT THE WEIGHTS OF THE BARS. 30° 60° 3 m 2 m B 200 kg
The homogeneous bar AB weighs 550 N. End B lean against a rough vertical surface and end A is supported by a ball-and-socket joint. Determine the reaction at A and B of the tension in the cable is 150 N. Z. C 30° В 5 m 6 m --- 4 m X A y
From the moment diagram shown, assuming there are no variable loadsa. What is the value of the reaction at B.b. What is the value of the load from A to B?c. What is the value of the load from B to C?
The trusses are pin connected and suspended from the parabolic cable. If the structure is pin at B, hinge at A, and roller at C: a. What is the minimum tension of the cable DOE? b. What is the maximum tension of the cable DOE? c. What is the equivalent uniform load the cable is carrying? d. What is the length of cable DOE? Pronda K 50 kN 60 kN 8 @ 6m-48 m 70 kN E 12 m
Show solution
1.must draw fbd
Please answer asap