The boom ABC in Fig 4 is held by the ball and socket joint at A and the two cables EBF and CD, as shown. The cable EBF passes through a frictionless pulley at B. A 20 kN force acts as shown at point C. Calculate the tensions in the two cables and the reactions at A. Neglect the weight of the boom. 2 m 1 m 20 kN 1m 1.5 m- 1.5 m

The boom ABC in Fig 4 is held by the ball and socket joint at A and the two cables EBF and CD, as shown. The cable EBF passes through a frictionless pulley at B. A 20 kN force acts as shown at point C. Calculate the tensions in the two cables and the reactions at A. Neglect the weight of the boom. 2 m 1 m 20 kN 1m 1.5 m- 1.5 m

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Find the force acting in each of the members of the truss shown below. Remember to specify if each member is in tension or compression. 6 ft - 6 ft 6 ft 500 lbs 6 ft
A boom hinged at the base of a vertical mast is used to lift a 2000 load. Find the tension in the cable and the reaction R the end of the boom. The angle of the boom is 40 degrees with the horizontal and the cable is 60 degrees with the vertical mast. Show complete solution including FBD.
If the mass of cylinder is 100 kg, find the tension developed in wires AB and AC and find the support reactions in point O.. 3 m 1.5 m to 1.5 m 3 m B 1 m
A crane boom is supported as shown. The boom has a mass of 660 kg and the box on the end of the cable has a mass of 98 x 10 kg. Assume that the center of mass for the boom is half way along its 15 meter length. Calculate the tension in the upper (diagonal) cable required to support the crane in equilibrium. The cable angle with the ground is 45 degrees and the boom angle with the ground is 60 degrees.
The 600-lb box is held in place on the smooth bed of the dump truck by the rope AB. Find: (a) if a = 25°, what is the tension in the rope? (b) if the rope will safely support a tension of 400 lb, what is the maximum allowable value of a T a B
Problem 4: The mass of the diver is 75 kg and the mass of the diving board is 45 kg. Draw the free body diagram of the diving board. Find the reactions at A and B. B Wp WD + 1.2 m 2.4 m 4.6 m
Stop Share The horizontal boom AO is supported by cables AB and CD, and a ball-and-socket joint at O. Calculate the tensions in the cables, and support reactions at O in terms of x. Neglect weight of the boom. L=10 kN, a= 7 m, b=3 m, c-2 m, d=4 m x A C B X b C D
KINDLY SHOW COMPLETE SOLUTION 1) The horizontal reaction at B(Bh) 2) The vertical reaction at B(Bv) 3) The vertical reaction at A(Av) 4) What is the force at member CD
3. A 550 kg drawbridge has a hinge at one end and a cable attached to the other. It is stuck in a position where it makes an angle of 30° with the vertical. The cable pulling on the far end of the bridge is horizontal. Find the tension in the cable as well as the vertical and horizontal components of force from the hinge.
A uniform ladder, 4.8 m long and weighing 220 N, rests against a smooth vertical wall. By taking moments about lower end of the ladder, which is 1.5 m from the wall, calculate the horizontal reaction of the wall on the ladder. Take the weight of the ladder as acting at its mid-point. Also, find the magnitude and direction of the reaction at the floor.Note: Show a free-body-diagram and all your workings.