The boat to be pulled onto the shore using two ropes. If the resultant force to be 400 N, directed along the keel aa as shown, determine the magnitudes of forces T and P acting in each rope and the angle Nof P so that the magnitude of P is a minimum. T acts at 30° from the keel as shown. 30° T 400 N

Q: II. Method of Superposition Problem 4. Draw the moment diagram for the beam using method of…

A: Bending moment at a section can be found be superimposing(adding) the bending moments due to the two…

Q: The angle beam OC is subjected with two concentrated loads at A and C. Determine the unkown forces…

A: Draw the free body diagram.

Q: 25 kN 8 kN/m 10 kN-m 2 m A 15 kN 30° 12 kN 2.5 m 1 m 3 m 2.5 m 2 m

A:

Q: Analyze the beam below: 1 m Α.Δ. 400 kN/m 6 m 2 m 600 kN B 2 m (a) determine the maximum moment…

A:

Q: 1.5 m 2 m B 4 kN 3 kN 2 m

A:

Q: Solve for the following internal forces occurring on the beam loaded as shown below. a. Moment at B…

A: Moment at Support A, MA = 0 KN-m => -12(26)(6)(7.6+236) + RD(10.6) - (15.9)(3.6) => RD =…

Q: force water. Determine the force & angle on gate AB.

A:

Q: The taligate is supported by the hydraulic lift BC. If the lift exerts a 125 lb force directed along…

A: Force along BC = 125 lbDimensionsTo find out Moment at A

Q: The vertical mast supports the 5.8-kN force F and is constrained by the two fixed cables BC and BD…

A: Given:- The magnitude of the force F = 5.8 N  The force is constrained by the two cables BC and BD…

Q: Determine the resultant and the moment of the system of forces with respect to point B with b = 1.0…

A:

Q: Problem II. Refer to the beam shown below. 9 (kN/m) P (kN) A C -6 m- -3 m a) Determine the support…

A:

Q: A drawbridge has mass M and length L and is approximately uniform. It has a hinge at the right end,…

A: