The bend rod is supported at A, B, and C by smooth journal bearings. Determine the components of reaction at the bearings if the rod is subjected to the force F. The bearings ar ein proper alignment and exert only force reactions on the rod. F= 815 N e= 1.95m d= 1.00 m f= 2.20 m 30° 60° F B d C 0.75 m

Q: The uniform beam has a mass of 56 kg per meter of length. Determine the reactions at the supports.…

A: To Find :  The reaction at support . Given :  The uniform beam mass is m=56kgm Free body diagram :…

Q: 1 the reactions at A and C. 3 N, A=140 N, C=180 N

A:

Q: The bar AB has a built-in support at A. An external force F=6kN is applied at B (8,0,0)m, towards to…

A:

Q: The light right-angle boom which supports the 560-kg cylinder is supported by three cables and a…

A:

Q: Determine the magnitude of the pin force at A.

A:

Q: A 300kg counterweight with center of mass at G is mounted on the AB crank rod of the oil pump unit.…

A: Given Data Torque supplied by motor is : M=250 Nm  Mass of the counter weight mounted on crank AB…

Q: 1. the cable is wrapped around the pulley and attached vertically at A. The bearing B only allows…

A: According to the question F=10i-30j-10k N We need to find The tension in the rope

Q: 8 kN 8 kN 2 kN-m 30°7 В 600 500 600 600 mm mm mm mm

A: Given :-  To Find:- Support reactions at point A and B

Q: Two traffic signals are attached to the 42-ft support cable at equal intervals as shown. Determine…

A:

Q: 4/36 Determine the force in member BE of the loaded truss.

A: Here we will use the method of section to calculate the load in member BE

Q: Determine the magnitudes of all pin reactions for the frame loaded as shown. Assume F = 630 N, a =…

A:

Q: Determine the four support reactions. El is constant L-4 m, q=5 kN/m A q L B

A: Given question is from Basic mechanics. We have to find support  reation. Stepwise solution is…

Q: If in equilibrium, the anticlockwise turning effect of force F must equal the clockwise turning…

A: Calculate the force F by applying moment at the pin point as follows: ∑MO=0F×0.25=5×0.5F=10 N This…

Q: Determine the reactions at the support. There are two supports: a collar that can slide along the…

A:

Q: *5-80. The bent rod is supported at A, B, and C by smooth journal bearings. Determine the magnitude…

A: The force ,The reaction,To find:The magnitude of force F2

Q: The 410-kg uniform beam is subjected to the three external loads shown. Compute the vertical…

A:

Q: The uniform I-beam has a mass of 60 kg per meter of its length. Determine the tension in the two…

A: Givenm'=60 kg/m

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.