THE BELOW CIRCUIT IS SHOWN PLEASE FIND WHAT THE WATTMETER READING WILL BE

Q: The single phase full bridge inverter har a resistive load of R=10 2 and de input volkrge ir 2eoU.…

A:

Q: Clamp on meter can be used to measure currents in milliamperes. True False

A: Given  Clamp on meter can be used to measure  current in milliamperes True or false

Q: A 24-volt circuit has a total resistance of 120 ohms.   Determine the power consumption of the…

A: The obstruction offered to the smooth flow of current is called resistance. The electrical element…

Q: where did you get the 746 watts?

A: Since, the power is given in hp.i.e., Po=40 hp

Q: Eight resistances [identical] are connected in series across 220-V line a. Identify the voltaege…

A:

Q: 3) In the circuit shown, what current does the ammeter read?... and for good measure practice doing…

A: In this question, we need to determine the reading of the Ammeter as shown in the circuit. We solve…

Q: What is the voltage drop across RB, VB, in volts?  (Enter the number, not the units.)

A:

Q: Two different types of currents are encountered in the household. These are   Question 9 options:…

A: There are two type of current which is encountered in household that are alternating current which…

Q: Potential coil of watt meter is connected connection

A:

Q: TRUE or FALSE: During open-circuit test, the current in the high-voltage winding is equal to zero.

A:

Q: what is the computed load for an electric range with a nameplate rating of 12kW

A: => Article 220 (Table 220.55) NEC mentioned the loads and demand factor for various household…

Q: Write about the examples of Renewable Energy in 300 line

A: We need to write about the examples of Renewable Energy.

Q: Three resistors are connected in delta configuration which are 2 ohms, 4 ohms and an unknown…

A: The objective of this question is to find the value of the unknown resistance in a delta…

Q: In the energy conservation concept, the positive and negative power in an electric circuit must be

A: In an electric circuit, the power which are delivered into the circuit by any active or passive or…

Q: A 50-ohm, a 90-ohm and an unknown value resistor are in series across a 60-V generator with 1/3A…

A: given circuit

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: Part 3: Resistors in Parallel and Series Aim: To understand how the magnitude of the total…

A: TWO RESISTORS IN SERIES WITH A BATTERY:

Q: How does the magnitude of the voltage across the power supply compare to the voltage across the bulb…

A: Concept If the supply element (active source) and absorbing load type of element are connected in…

Q: A 100 kva load operates at 0.75 lagging power factor when connected to a 230v, 60hz AC source. The…

A: Given load is 100 kVA Power factor is 0.75 lagging. Power factor angle is 41.409 degrees.

Q: The alternator voltage is higher than the battery voltage by around 2 volts, why?

A: In the concept of vehicle(load) charging system, the vehicle is connected to both battery and…

Q: A system has the following open loop transfer function; G(s) = s+4/(s+1)(s2+5s+9) List the break…

A:

Q: List out the different types of ohm meter. Explain the same with neat schematic diagram.

A: Ohmmeter- It measures the resistance in an electric circuit which is known as an ohmmeter. It is…

Q: 1. Convert the following current source into an equivalent voltage source and redraw the circuit.…

A: As per bartleby expert policy, only one individual question is to be answered.

Q: VAB=100 volt. find RAB and IT???????????

A: Given circuit is shown below:

Q: Why is current and voltage in phase when two resistors are connected in series? explain in full…

A:

Q: How do you do the 2 wattmeter and 3 wattmeter method?

A: A two Wattmeter Method can be used to measure the power in a 3 phase, three-wire star or delta…

Q: What are the symbols for loads in electricity

A: As we  have to find the symbols for loads in electricity As load means it is passive element which…

Q: What is the rating of the branch circuit if the circuit breaker is 20A.      a. 15A      b. b. 20A…

A: Given Data:A circuit breaker with,Current Rating To Find:The current rating of the branch circuit.

Q: In a series circuit, a variable resistor and a 66.2 microfarad capacitor is supplied by a 120 volt,…

A: The solution is given below

Q: What is the voltage of the following circuit, if the current and resistance are given? 1A 10

A: According to ohms law voltage across load = Current through resistor ×Value of resistance. Given…

Q: 1. Three resistors are connected in delta. If the ohmic value of each resistance is 3 ohms, what is…

A: Delta to why conversion  RA = R1R2/(R1+R2+R3) RB = R2R3/(R1+R2+R3) RC = R1R3/(R1+R2+R3)

Q: The technician is troubleshooting the following circuit and finds that there is an electrical…

A: In the given electrical circuit, the following things can be observed: The circuit consists of a…

Q: Draw and explain a power supply diagram of 12V?

A: A power supply diagram for a 12V DC (direct current) power supply typically consists of several…

Q: Three resistors are connected in delta configuration which are 2 ohms, 4 ohms and an unknown…

A: The objective of the question is to find the unknown resistance in a delta configuration of…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.