Answered: The beam shown is subjected to a… | bartleby

Related questions

Question

100%

The beam shown is subjected to a bending moment of 150N:m about
the x-axis.
1) Determine the location of the centroid x, ỹ, and sectional property Ix, ly, and Iy.
2) Calculate the maximum compressive and tensile stresses due to bending and
determine the location of them.
y
32 min
88 mm
......
8 mm
Mx 15 X

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 5 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

2. Determine the maximum tensile and compressive bending for the beam shown. Young's modulus- 29000 ksi, Moment of inertia - 9700 in4, Section depth = 27 in, symmetric section. xyz plf Fixed end xyz ft.
None
Determine the moment M that will produce a maximum stress of 70 MPa on the cross-section.
Kendra holds the end of a rope that is .5 kilograms and .60 meters long, while her friend Lupita holds it on the other end, with a force of 150 N. What is the torque that Kendra withstands? The rope has a Young's Modulus of 55x10^8 Pa, unfortunately, it cannot stretch more than 3 cmfrom 600 Newtons of tensile force, or else it would break apart. Would it break apart in this case?
Answer the following questions. 1. Calculate the elongation of the cable due to load, if a steel cable of 4cm diameter is used to lift a load of 350kg. Given that and the length of cable is 10m and E=3x10'kg/cm. 2. A tensile test was conducted on mild steel bar. The load at elastic limit was 200KN and the diameter of the steel bar was 3cm. What will be the value of stress? 3. A steel bar 600mm long and having 30mm diameter, is turned down to 25mm diameter for one fourth of its length. It is heated at 30 C above room temperature, clamped at both ends and then allowed to cool to room temperature. If the distance between the clamps is unchanged, the maximum stress in the bar ( a = 12.5 x 10" per C and E = 200 GN/m) is 4. Determine the yield stress of a steel rod 15 mm diameter, if the yield load on the steel rod is 70KN. 5. Where do the maximum BM occurs for the below diagram. 10 KN 2M OM
The beam is made of an elastic-plastic material for which σYσYsigma_Y = 70 MPaMPa . The largest moment in the beam occurs within the center section a-a. Determine the magnitude of each force PP that causes this moment to be the largest elastic moment. Determine the magnitude of each force PP that causes this moment to be the largest plastic moment.
3. The center of gravity A В C D of the following structures is indicated by x. Which of the following structures is the most stable?
MAN Two builders carry a sheet of drywall up a ramp. Assume that W = 1.9 m, L = 3.3 m, theta = 19.00, and that the lead builder carries a weight of 109.0 N (24.5 lb). 0 What is the weight carried by the builder at the rear? The builder at the rear gets tired and suggests that the drywall should be held by its narrow side. 0 W What is the weight he must now carry?
Needs Complete solution with 100 % accuracy don't use chat gpt or ai plz plz plz.