The basic barometer can be used as an altitude measuring device inairplanes. The ground control reports a barometric reading of 753mmHgwhile the pilot's reading is 690mmHg. Estimate the altitude of the planefrom ground level if the average air density is 1.20 kg.m-3 and thebarometer fluid is mercury, PHg=13600 kg.m3.To solve this problem determine the atmospheric pressure on the groundand then in the air using the barometric pressure readings.Then using the pressure difference between the ground and the plane, thealtitude can be derived by considering a column of air from the ground upto the plane, of constant density, in a similar manner to the barometer.[h=714m]

Name: The basic barometer can be used as an altitude measuring device inair
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: The basic barometer can be used as an altitude measuring device inairplanes. The ground control reports a barometric reading of 753mmHgwhile the pilot's reading is 690mmHg. Estimate the altitude of the planefrom ground level if the average air densi

Answered: Image /qna-images/answer/c900c815-d4ee-4c67-8043-3d861ba8087a.jpg

Engineering

Mechanical Engineering

The basic barometer can be used as an altitude measuring device in airplanes. The ground control reports a barometric reading of 753mmHg while the pilot's reading is 690mmHg. Estimate the altitude of the plane from ground level if the average air density is 1.20 kg.m³ and the barometer fluid is mercury, PHg=13600 kg.m-³.

The basic barometer can be used as an altitude measuring device in airplanes. The ground control reports a barometric reading of 753mmHg while the pilot's reading is 690mmHg. Estimate the altitude of the plane from ground level if the average air density is 1.20 kg.m³ and the barometer fluid is mercury, PHg=13600 kg.m-³.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

1:0A Question.pdf > Question Q:-Determine the force exerted on the cone curved surface. The liquid in the tank has a specific weight of 27 kN/m' and the absolute pressure of the air in the tank is 151 kPa. 151 kPa Absolute Air Liquid 3m 1 m Cone Good Luck Prof.Dr. Muhammad A.Eleiwi II
In figure (1), The Gauge pressure at A reads P87 kPa. All fluids are at 20°C. Determine the elevations Z in meters of the liquid levels in the open piezometer tubes B and c. Gasoline S.G= 0.8, Glycerin S.G= 0.9, air density= 1.25 kg/m³. A В C 2 m Air 1.5 m Gasoline 1 m Glycerin -
If F1 = 390 N force is applied to the piston with d1 = 4 cm diameter, what is the magnitude of the force F2 that can be resisted by the piston with d2 = 10 cm diameter? Neglect the weights of the pistons.
The manometer pressure at pipe A is about 30mmHg and the initial differential reading of Mercury is 0.30 m as shown.Calculate the absolute pressure at pipe B.
What is the mass of air contained in a room 4 x 8 x 2 if the pressure is 150 kPa and T = 30 deg C.
For the manometer shown in the image, all fluids are at 20°C. If PB- PA = 90 kPa, determine the height H in centimeters. The specific weight of water is 9790 N/m³ and the specific weight of mercury is 133100 N/m³. Meriam red oil, SG = 0.827 Water 18 cm H 35 cm Numeric Response B Mercury
Calculate the pressure at A in kPaa.
Problem 2 В A manometer was used to determine the pressure of the gas at B. Three fluids were used, two of which are made of liquid having specific gravities of 1.25 and 0.80 while the third is a gas with an unknown specific gravity. What is the pressure (in Pa) at B? The specific weight of water is 9,810 N/m³. 5 сm A 60° 6 ст S.G. = 1.25 4 сm S.G. = 0.80
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) How much payload mass can it carry if the mass of airship itself is 5Kg? Do you expect any change in lifting capacity while moving from point A to point B? (b) Calculate the mass of helium to be expelled out to maintain the constant pressure of 2 bar at point B.
An airship of 100m3 in size is launched from sea level and it gradually attains height until it reaches the desired altitude. A manometer measuring the gage pressure of the inside filled Helium gas show a reading of 1.2 bar at the altitude of A meters from the ground. Manometer shows reading of 2 bar when it reaches to a height of B meters. Assume; Density of air at point A = 1.00 kg/m3 and at Point B= A = 0.80 kg/m3. You can also assume average density = 0.9 kg/m3 where required. Consider temperature inside the balloon = 10°C and negligible change in temperature during the process. (a) Calculate external atmospheric pressure difference between Point A and B (b) Neglecting the effect of altitude on local gravitational acceleration, determine the height attained from A to B.
The cylindrical tank with hemispherical ends contains a volatile liquid and its vapor. The liquid density is 800 kg/m3 and its vapor density is negligible. The absolute pressure in the vapor is 120 kPa, and the atmospheric pressure is 100 kPa. What is the height h (in mm) of the mercury (γ =13.6) on the manometer? a. Not listed b. 171.3 c. 208.7 d. 246.2 e. 187.6 f. 193.7
The water in a tank is pressurized by air, and the pressure is measured by a multifluid manometer as shown in the Figure. The elevation differences are , , and . The density of water, oil, and mercury are , , , respectively. The gravitational acceleration is . (2)Determine the correct expression of the gage pressure of the air in the tank__________ ***** I submitted this question earlier, and "C" is not the correct expression. I submitted that answer and it was wrong.*****