The assembly consists of two A-36 steel rods and a rigid bar BD. Each rod has a diameter of 0.753 in. If a force of 15 kip is applied to the bar, determine the angle of tilt of the bar in degrees. 3.5 ft 2.5 ft E D H1.25 ft- 0.75 ft' 1 ft 15 kips

Q: A transmission tower is held by three guy wires attached to a pin at A and anchored by bolts at B,…

A: Given  TAB= 110 lb

Q: Problem 1 An L-shaped bar is supported by a normal bearing at A and a smooth horizontal surface at…

A: Given data:- Below L-shaped bar diagram is given in question;

Q: find  axial force diagram shear force diagram  bending moment diagram

A:

Q: 5 kip/ft 1 ft 11 ft 30 kip-ft 11 ft Figure P-552 11 in ♫

A:

Q: B 16-28. The gear A on the drive shaft of the outboard motor has a radius A = 0.7 in. and the meshed…

A:

Q: Both shafts have the same diameter 2cm and are made of low quality steel G=77 GPa. A torque of 1200…

A: Given: Diameter of both the shafts: d=2cm=0.02m Length of the shaft AB: LAB=0.35m Length of the…

Q: 1-5. The shaft is supported by a smooth thrust bearing at B and a smooth journal bearing at A.…

A:

Q: *5-80. The bent rod is supported at A, B, and C by journal bearings. Determine the components of…

A: On a rod, a load of 200 lb and a moment of 30 lb-ft are applied. This load and the moment are…

Q: 400 lb A (b) C 12 in. D 1600 lb 12 in. E G 12 in. F 400 lb 12 in. B 8

A:

Q: The compound beam is pin supported at C and supported by a roller at A and B. There is a hinge (pin)…

A:

Q: 5-78. The bent rod is supported at A, B, and C by smooth journal bearings. Compute the x, y, z…

A: Introduction- A reaction force opposes an action force by acting in the opposite direction. During…

Q: The beam provided is known to support at deadload of 7 kN/m, live load of 23 kN/m, and the vehicle…

A:

Q: Replace the forces acting on the plate by a wrench. Specify the force and couple moment for the…

A: Consider the figure,

Q: pin The solid 24-mm-diameter steel [E = 220 GPa] shaft supports two belt pulleys. Assume that the…

A: Given:- P=530 NQ=610 NLAB=250 mmLBC=180 mmLCD=250 mmLDE=180 mmE=220 GPaDiameter of solid shaft = 24…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.