The aluminum rod AB (Gal = 27 GPa) is bonded to the brass rod BD (Gbr = 39 GPa). The portion CD of the brass rod is hollow and has an inner diameter of 40 mm. If the allowable shear stresses for the aluminum and brass are 90 MPa and 70 MPa, respectively, and the allowable angle of twist of the free end A is 6 degrees, determine the maximum permissible value of T

Q: The minimum strain at failure in tension steel having yield stress modulus E = 200 GPa, as per Limit…

A:

Q: Explam how the total stess at a distance z be determined from the figure below Com ground surface…

A: For multi layered soil Total stress is given by :σt=∑ γtγ=unit weightst=thickness of each layer

Q: Beam CX is subjected to a loading condition as shown in the figure. What will be the (a) the maximum…

A:

Q: 160KN 个 160KN 6cm 6cm 40 cm

A:

Q: 8 ksi, øy = -4 ks The normal stresses at a point in a steel member are ox 10 ksi. Using E = 29 × 10³…

A: Given data in question  Stresses Elasticity modulus  Poissons ratio To find out  Normal strains

Q: what differ between plane stress and strain.As like pancel is which of those? （eg,a pancil ,glass…

A: Given data: Difference between Plane stress and Plane strain.

Q: When the normal stresses are at their maximum or minimum values, the shear stresses are zero. We can…

A: 1- Yes when normal stresses are maximum or minimum, then at that element shear stress is zero. 2-…

Q: y 400 mm a 200 mm A 150 N a 10 mm В A Section a –a

A:

Q: H.W 3 Two aluminum alloy plates (2) are attached to the sides of a wooden beam (1) as shown in…

A: Solution: Given data: b1=80 mmd1=240 mmb2=10 mmd2=120 mma=60mmE1=12.5 GpaE2=70 Gpa Calculation:…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.