The air considered as the ideal gas flows through the compressor and heat exchanger at a volumetric flow rate of 26.91 m3 / min as shown in the figure. At the same time, a stream of liquid water passes through the heat exchanger. The information given in the figure is for continuous flow. Considering the compressor and heat exchanger as adiabatic and ignoring kinetic and potential

Q: Problem 3. Consider a shower that mixes hot and cold saturated liquid water to maintain a steady…

A:

Q: E.3) There is a steam system in which the boiler must be fed by using a pump that supplies 0.005…

A:

Q: Ammonia exits the stream of a process as saturated liquid at a pressure of 11bar, and is reduced to…

A:

Q: Air enters a diffuser of a jet engine at T₁ °C, 90kPa and a velocity of V₁ m/s. If the inlet…

A:

Q: Energy balance open system (hydraulic turbine):   Lake water contained by a dam is used to generate…

A: Given Data The pressure at point 1 is: P1=150 kPa The height of the point 1 is: 25 m The pressure at…

Q: Steam @ 400 C and 1600 kPa enters a nozzle at a velocity of 28 m/s and leaves as saturated vapor at…

A:

Q: Q1: Steam at 10 MPa and 530 °C, 70 m/s, at inlet a turbine and leaves at 12 kPa with a quality of…

A:

Q: Нeat 4 Exchanger water 3 Figure 2 What is the specific isentropic work done of compressor in kJ/kg?…

A: Given data: The initial temperature of the air is T1 = 30 oC. The final temperature of the air is…

Q: In a compressor, air enters at a temperature of 100 kPa and 20 ° C and leaves the compressor at 1200…

A:

Q: Saturated ammonia at a temperature of 50oF and a flow rate of 3 lbm/s enters a steady-state…

A:

Q: 2. (Pp160p-ex4.18-jrfra) - Consider an ordinary shower where hot water at 60 °C is tempered with…

A:

Q: A device submitted to the Pa- tent Office is shown schemati- cally in the figure to the right. Its…

A: To determine if steady-state operation of this device is thermodynamically permissible, we need to…

Q: 2.13 Air at 30°C and 2MPa flows at steady state in a horizontal pipeline with a velocity of 25 m It…

A:

Q: A completely insulated mixing vessel is designed to deliver water at 60 ⁰C and atmospheric pressure…

A:

Q: In the turbine of a gas turbine unit the gases flow through the turbine at 14+24 kg/s and the power…

A:

Q: 4. In a steady flow apparatus,135kJ of work is done by each kg of fluid. The specific volume of the…

A:

Q: a desuperheater insulated unit (figure F) converts the inputs into a saturated vapor stream.…

A:

Q: An air compressor is designed to compress air (assumed to 100 kPa, 20 ° C at a pressure of 1 MPa).…

A:

Q: The suction fan of a building heating system draws ambient air at 100 kPa and 30 °C into a duct of…

A: Given Data:-

Q: rite down the steady flow energy equation (SFEE) and apply it for boiler, turbine, heat exchanger…

A: An open system's total energy fluxes are described by the Steady Flow Energy Equation. The mass…

Q: Water at 910 kPa, 25°C enters a 1-m-diameter horizontal pipe with a steady velocity of 13 m/s At the…

A:

Q: The initial state enthalpy for water (h3(kJ/kg)) is equal to: The final state enthalpy for water…

A: For solution refer below images.

Q: In the system shown in the figure, saturated liquid water at a pressure of 12 MPa enters the boiler…

A:

Q: The initial state enthalpy for air (h,(kJ/kg)) is equal to: The final state enthalpy for air…

A: Given Data State 1: Air, 550 K,1 MPa State 2: Air, 250 K,1 MPa State 3:Water,30°C,0.1 MPa State…

Q: A compressor in a plant receives air at 100 kPa, 280 K, with low  velocity. At compressor discharge,…

A: Let T1 = Temperature at inlet of compressor =280K T2 =Temperature at outlet of compressor =500K T3…

Q: It flows through a compressor and a heat exchanger. Cooling water (does not change phase) flows…

A: Given Data: The pressure of air at state 1 is, P1=96 kPa. The temperature of the air at state 1,…

Q: For the production of high-speed trains at the SIEMENS company in Krefeld, considerable amounts of…

A:

Q: B) There is a steam system in which the boiler must be fed by using a pump that supplies 0.005 m³/s…

A:

Q: Refrigerant (known as R-134a) enters a heat exchanger at 100 kPa. The refrigerant is of 20% quality…

A: Given data: The pressure of refrigerant in the heat exchanger is P = 100 kPa. The dryness fraction…

Q: Warm water in a geothermal heating system enters the pipe of a radiator at 20 psia and 108°F with a…

A: Notice that the condenser area incorporates both the high temp water and space radiator and station…

Q: Water enters a heat exchanger operating stably at P = 10 bar and T = 80oC, given that the outlet is…

A: GivenP1=10 bar T=80oCAt outletP2=10 bar  saturated steam

Q: 3. A juice at a rate of 500 kg/h is heated from 60 °C to 115 °C. The juice has a specific heat of…

A: To Find :  The mass flow rate of steam necessary to heat the juice. Given :  The mass flow rate of…

Q: 12 kg of air per minute is delivered by a centrifugal air compressor It enters the compressor at a…

A:

Q: Question 43 At a science fair, an inventor suggests a hypothetical device that operates permanently…

A: INTRODUCTION: We will compute the entropy production of the given gadget in this challenge. To…

Q: Heat exchangers exchange only heat and not mass (fluid does not mix). The working fluid is water…

A: Given Data Steam Inlet: 500 kPa, 300°C

Q: With regard to the flash vessel, consider 10 bar steam (hg=2,782 kJ/kg) entering a turbine and…

A: Given: Steam pressure = 10bar At 10 bar hg = 2782 kJ/kg hf = 782 kJ/kg  At 1.5 bar  hg= 2717 kJ/kg…

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.