The acoustical system shown in the figure below is driven by a speaker emitting sound of frequency 632 Hz. Sliding section Receiver Speaker (a) If constructive interference occurs at a particular location of the sliding section, by what minimum amount should the slider be moved upward so that the destructive interference occurs instead? (b) What minimum distance from the original position of the sliding section will again result in constructive interference?

The acoustical system shown in the figure below is driven by a speaker emitting sound of frequency 632 Hz. Sliding section Receiver Speaker (a) If constructive interference occurs at a particular location of the sliding section, by what minimum amount should the slider be moved upward so that the destructive interference occurs instead? (b) What minimum distance from the original position of the sliding section will again result in constructive interference?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Problem 28.11 - Enhanced - with Expanded Hints Moe, Larry, and Curly stand in a line with a spacing of d = 1.60 m. Larry is 3.00 m in front of a pair of stereo speakers 0.800 m apart, as shown in the figure(Figure 1). The speakers produce a single-frequency tone, vibrating in phase with each other. Figure 0.800 m -3.00 m Curly Larry Moe 1 of 1 Part A What are the two lowest frequencies that allow Larry to hear a loud tone while Moe and Curly hear very little? Express your answers using two significant figures separated by a comma. ► View Available Hint(s) ΓΙ ΑΣΦ f = 0.11,0.33 Submit Previous Answers Request Answer X Incorrect; Try Again Provide Feedback ? kHz
Water Your task is to find the frequency of the tuning fork by using above experiment in the lab. The length from the water surface of the tube is 55.0 cm for third resonance. What is the frequency of the tuning fork? You may use speed of sound in air as 343 m/s.
Task 1: Interference of waves 1. Using the two-dimensional wave interference pattern shown, a ruler and the two equations involving wave path difference, complete the following. If you do not have access to a printer or ruler, you can use the online version. animation speed Time = 0 s slow fast Velocity of river relative to earth (m/s)3 Run M North Show Velocity Vectors Vb-r Velocity of Boat Relative to River (m/s) 4 Pause Show Ve Reset Aim Direction -0° West of North Aim Direction -0° (-90° - West, 0° - North, 90° - East) VB>E-5 m/s @36.87° E of N Start 1. Measure the distance between the sources, and the path distance from each of the sources to the nodal point shown on the diagram. Show the complete calculation for wavelength. 2. Measure the path distances from each of the sources to the anti-nodal point shown on the diagram. Using measurements from part 1 for the distance between sources and the measurements made in part 2, show the complete calculation for the wavelength. 3. What…
In a two-point source interference pattern in a ripple tank, a point is one wavelength farther from one sourcethan the other. If the two sources are in phase, then there isa. destructive interference at this pointb. constructive interference at this pointc. both constructive and destructive interference simultaneouslyd. neither constructive nor destructive interference at this pointe. no interaction between the two waves at this point
What minnimum frequency will produce maximum destructive interference at your location? What minimum frequency will produce maximum constructive interference at your location?
Need help with parts A and B pls
Suppose polarized light passes through a polarizing filter with its axis at an angle of 19° to the direction of polarization. To what percent of its original value is the intensity of the polarized light reduced?
Two pulses are about to interfere as shown. 10cm Will the pulses interfere constructively or destructively? destructively What is the magnitude and direction of the displacement at total interference? cm, upward