The 9-kg rod is released from rest when 0=tan (3/4) [position 1]. Knowing that AB=1.2 m. The spring (K=380 N/m}) is unstretched in position [1]. It reached position [2] when 0=0°.АВBKKinetic energy at position [1] Joules)a. 0о Б.2.16C. 4.32d. 3.24е. 6.48polar moment of inertia at instant center in position [2] (kg.m2)а. Оb. 2.16c. 4.32d. 3.24е. 6.48work done by weight is (Joules)extension of spring when 0=0°. (m)angular velocity when 0=0° (rad/s)O O

Given:-Weight of rod, w=9 kgθ=tan-134AB=1.2m K=380 N/mTo find:-a) Kinetic energyb) Polar moment of…

Answered: The 9-kg rod is released from rest when…

The 9-kg rod is released from rest when 0=tan (3/4) [position 1]. Knowing that AB=1.2 m. The spring (K=380 N/m}) is unstretched in position [1]. It reached position [2] when 0=0°.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A solid bar of mass m and length L stands vertically on a frictionless table and is then released to fall down. The moment of inertia about the center of mass is Ic = mL²/12. At the moment when the top end B just reaches the ground (0-0), (a) what are the angular velocity and angular acceleration? (b) what is the center-of-mass acceleration? (c) what is the normal force of the ground to end D? Hint: It may be helpful to find out the instant rotation axis. В m. L D
+ b 3. A tuning fork is an example of a "resonant system", that is, one that has a low damping ratio. A model of a (half) tuning fork is rod of mass m with air drag modeled as a damper connected approximately at its middle, and a torsional spring at the base of the cantilever. Assume the cantilever rotates back and forth about its pivot by a small angle o. Because other forces are much larger, you can reasonably neglect the effect of gravity in this model. The moment of inertia of a cantilevered beam pinned at one end is equal to ml2, where I is its length. (a) What is the natural frequency of this system if m= 0.1 kg and k = 2548 Nm/rad, and 1 = 0.1 m. Please give the value in rad/s and Hz. (b) Find an upper bound on the damping coefficient b that insures that the damping ratio of the tuning fork is no greater than = 0.01. (c) For this damping ratio, what is the damped natural frequency of the system? (d) For this damping ratio, what is the decay rate (the size of the exponent…
2. Flyballs A and B weigh 20 Ibs each. Neglecting the weight of the other links, what counterweight W in Ibs will maintain the system in the position shown below if the rotational speed is: а. 100 грm b. 150 гpm с. 200 гpm 1" 30 6" 45° A
A В X Figure 3 Refer to Figure 3. A slender rod of mass 1.5 kg and length L = 1 m is pivoted at one end as shown. It is released from rest in a horizontal position and swings freely. At the instant it is released the angular acceleration (alpha) is 14.715 rad/s^2. In the question that follows, select the answer that is closest to the true value. What is the force reaction at the pivot in the y-direction at the instant the rod is released (when it is still horizontal) in units of N ? Answers: A) 3.68 B) 4.91 C) 6.13 D) 7.36 --- O A O B O D
Derive the equations of motion using Lagrange's equations. (I, =mr? ) THE MOTION IS ON THE HORIZONTAL PLANE (NO GRAVITY) Trailer, mass M Cylinder, k1 mass m k2
Please answer quick you are in a bumper car with a total mass of 200.0kg your friend is also in a bumper car with a total mass of 200.0kg.You are moving to the right at 1.00m/s. Your friend is moving to the left at 0.500m/s. Your car hits a spot on your friends car that has no bumper. Your bumper acts as a spring with a spring constant of 2.00x10^4N/m. Determine the velocity of your car when the bumper has raced a maximum compression of 0.0700m.Assume friction is negligible.
The following mass-and-spring system has stiffness matrix K. The system is set in motion from rest (x1′(0)=x2′(0)=0)in its equilibrium position (x1'(0)=x2'(0)=0) with the given external forces F1(t)=0and F2(t)=540 cos 4t acting on the masses m1and m2,respectively. Find the resulting motion of the system and describe it as a superposition of oscillations at three different frequencies. m1 m2 k1 k2 k3 x1 x2 K= −k1+k2 k2 k2 −k2+k3 m1=1, m2=2; k1=1, k2=2, k3=2 Find the resulting motion of the system. x1(t) = x2(t) = (Type exact answers, using radicals as needed.)
A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity g=9.81 m/s2 . (2) ) If the mass moment of inertia of the drum about point O is IO, and the angular acceleration of the drum is α, select the correct moment equation of the whole drum-block system about the point O._____________ A. mbgr=rmb(rα) B. 0 C. mbgr=Ioα +rmb(rα) D. mbgr=Ioα
4. A rod of length L, = 1.50 m moves along the horizontal direction. The rod makes an angle 0, = 25.0° with the x' axis of its own moving reference frame S'. (a) How fast will the rod need to be traveling relative to an observer at rest to measure and angle of e = 71.0° with the axis x of the rest reference frame S? (b) If the rod has a mass of 1.00 kg, then how much work would have been done to accelerate the rod to this speed from an initial speed of 1.00 x 105 m/s?
0.5 m, k = 500 N/m, and k = 40 N.m/rad, In the system shown, m = 10 kg, r = 0.3 m, Ko where ko is the radius of gyration of the pulley about point 0. There is no slippage between the cord and the pulley. Replace the system with an equivalent { a) torsional spring and mass moment of inertia at point 0, and b) translational mass and spring at point A. т, Ко kt А k m ww
A uniform rod of mass M = 2.3 kg and length L = 0.2 m, lying on a frictionless horizontal plane, is free to pivot about a vertical axis through one end, as shown. The moment of inertia of the rod about this axis is given by 1/3 ML2. If a force F = 7 N, q = 47° acts as shown, what is the resulting angular acceleration (in rad/s2) about the pivot point?
A drum can rotate about a fixed-point O. The A block is attached to a cord wrapping around the drum. The mass of the drum is md = 100kg and the radius is r = 0.5 m. The radius of gyration of the drum about point O is ko=0.3 m. The mass of the block is mb= 20kg. The block is released from rest. The acceleration due to gravity is g=9.81 m/s2. (1) Calculate the mass moment of inertia of the drum about the point O, IO_______(kgm2) (two decimal places)