The 119-lb crate is carefully placed with zero velocity on the incline. What is the acceleration of the block (positive down the incline) if (a) e = 16° and (b) e = 21°? U = 0.32 119 lb HA = 0.27 Answers: (а) Ө - 16°, а- i ft/sec2 (b) Ө - 21°, а%3D ft/sec?

The 119-lb crate is carefully placed with zero velocity on the incline. What is the acceleration of the block (positive down the incline) if (a) e = 16° and (b) e = 21°? U = 0.32 119 lb HA = 0.27 Answers: (а) Ө - 16°, а- i ft/sec2 (b) Ө - 21°, а%3D ft/sec?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Calculate the uplift pressure at point C₂ shown in the figure below using Khosla's theory. 5m AH-6m…

A: Given Data: The data for the point C2 is given as: b=20md=3m

Q: Determine the maximum force P that can be applied without causing the two 50-kg crates to move. The…

A: Determine the maximum force P that can be applied ??

Q: A golf ball is driven with the initial conditions shown in the figure. If the wind imparts a…

Q: Situation 01. A 60-kg block is at rest when an upward force parallel to the 15° surface is applied.…

Q: incline surface has a coefficient of static friction equal to 0.35 and the coefficient of kinetic…

A: Given:- coefficient of sttaic friction =0.35 coefficient of kinetic friction=0.25 To find:- P to- a)…

Q: Using the CID shown, the value of ϕPne/Agh = 1.00 ksi. The value of eccentricity = 250 mm, and h =…

A: Answer We are given eccentricity e = 250 mm Height of column h = 500 mm Area of steel As = 10000 mm2…

Q: A car is on a slope of 20 degrees. The handbrake can deliver 9 kN. What is the maximum mass that can…

A: Assume mass of the car = m Free body diagram of the given problem:

Q: Pmin = N (round of to 2 decimal placed) Pmax = N (round of to 2 dectmal placed)

Q: Calculate the horizontal force P on the light 15° wedge necessary to initiate movement of the 41-kg…

Q: Write the V and M equation of the beams loaded as shown and the diagram. Then repeat the method…

Q: why in the slope deflection method of step 1 is ic from (3) for MDC negative shouldn't it be…

Q: For the beam loaded as shown in the fgure 3, determine the vertical reaction at B in kN using any…

Q: Co e- 30 A sphere of weight W is released with no initial velocity and rolls without slipping on the…

Q: LEASE SHOW COMPLETE FBD AND COMPLETE SOLUTIO

A: MAKE FBD OR EQULIBRIUM LETS MAKE NO ACCERLERATION

Q: 100 lb In the fig. shown, compute the minimum Weight W to prevent impending motion of the block up…

Q: Q-A ship has a metacentric height of 0.90 m and its period of rolling is 20 seconds. The relevant…

A: Given data- Metacentric height- Gm=0.90 m,T=20 s, To Find- The relevant radius of gyration (k).

Q: Support Reaction Ay unit Dirction(U/D) kN 10 kN-m By kN Support Reaction unit Ma Dirction(CW/CCW) 10…

Q: 1. The coefficients of static and kinetic friction between the 100 - kg block and the inclined plane…

A: Block on inclined friction surface problem ###

Q: The crate in an inclined plane (angle of inclination, 82=10. has a masS M-200 kg and is subjected to…

A: Given Data: Mass of crane=m=200 Kg g=10 m/s2 θ1=20 degrees θ2=10 degrees It is asked to find…

Q: and an incline of 10.0° with an initial velocity of 4.0 ft/s. Attached to the crate is a spring with…

Q: Two large moving plane surfaces (moving at 0.12m/s) are 18mm apart and the space between them is…

Q: A long, very smooth board is inclined at an angle of 10° with the horizon- tal. A weight starts from…

A: given:inclined angle θ=100height h=10ft

Q: 60. The distance between two parallel shafts connected by Oldham's coupling is 25 mm. The driving…

A: Distance d=25 mm Speed N=240 rpm

Q: 3 m. 8 m. Water 6 m. A concrete dam retaining water is shown. If the specific weight of the concrete…

Q: 1.om 0.8m 20 0.5 0.5 1.om

Q: To unload a tied pile of plywood from a truck, the driver first tilts the truck bed and then…

A: To determine: smallest acceleration of the truck that would cause the plywood to slide acceleration…

Q: The 1.5-in (0.125- ft) gap between two large plane surfaces is filled with SAE 30 oil at 80 deg F (μ…

A: Given data- Distance between two plates (y) = 0.125 ft Viscosity (μ) = 0.0063 lb-sec/ft^2 Area(A) =…

Q: PROBLEM 2: A support block is acted upon by two forces as shown. Knowing that the coefficients of…

Q: Two shafts A & B are made of same material subjected to same twisting moment T. The diameter of…

A: Two shafts A & B are made of same material subjected to same twisting moment T. The diameter of…

Q: An open cylindrical container 800 mm in diameter and 1.50 meter high contains fresh concrete (s=…

Q: At a certain instant, the 92-lb crate has a velocity of 36 ft/sec up the 24° incline. Calculate the…

A: The given figure is shown below:

Q: QI) Knowing that the coefficient of friction between the 25-kg block and the incline is , = 0.25,…

A: Given:- weight=25 kg coefficient of friction=0.25 To find:- a) smallest value of P b)the…

Q: A bundle is projected 10 m upward on a 0.26 rad inclined plane so that it reaches the top of the…

A: Solution: Given Data: Coefficient of kinetic friction=0.08Bundle is projected=10 mInclined plane…

Q: Assuming no groundwater, calculate the critical angle of the steepest safe slope, given that…

A: Given Above condition And we have to find critical condition

Q: Based on the following figure if the mass of block A is 212kg and the static and dynamic…

Q: B TIM F Compute vertical displacement at C using conjugate beam method method.

Concept explainers

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.

Question

The 119-lb crate is carefully placed with zero velocity on the incline. What is the acceleration of the block (positive down the incline) if
(a) e = 16° and (b) e = 21°?
U = 0.32
119 lb
HA = 0.27
Answers:
(а) Ө - 16°, а%3
i
ft/sec2
(b) Ө - 21°, а%3D
i
ft/sec2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q.6 /A 300 hp tractor towing tired trailer is climbing a uniform 6.5% slope on steady speed 9 mph, the rolling resistance is 170 Ib/ton. The single-axle tractor weight 72000 Ib, and the trailer weight 52000 Ib. the combined weight distribution is 57% on the drive axle. What is the ability to move the tractor? If not. what do you suggest to the moving up? Discuses that according to the coefficient of traction.
skip if you arleady did this or else downvote
b6
Must be solved using the unit load method
Two blocks A and B have a weight of 10 lb and 6 lb, respectively. They are resting on the incline for which the coefficients of static friction are μ = 0.16 and μ = 0.25. Determine the incline angle for which both blocks begin to slide. Also find the required stretch or compression in the connecting spring for this to occur. The spring has a stiffness of k = 2.0 lb/ft. (Figure 1) Figure A 0 B 1 of 1
This is not a graded question. Kindly give me right solution with clear calculations.
If coefficient of friction is 0.27, determine the maximum weight of the rectangular block before it impends to sliding.
Uploading this question 3rd time, do not copy other solution
3. Determine if the tractor which has a weight of 8000 lb with center of gravity at G, can push the 550-lb log up the incline. The coefficient of static friction between the log and the ground is 0.5, and between the rear wheels of the tractor and the ground 0.8. The front wheels are free to roll. Assume the engine can develop enough torque to cause the rear wheels to slip. 1.25 ft B 2.5 ft |10° 3 ft -7 ft
sarking y Highoay Curves ark Pofation nith Variable Acceleration Situation # 4 - a particle rotates in aiccordance with the equation d= o4-6t>, where & is in %3D rad/s? ard t is in secs. when t -0, w= do rads/s ard + = 0. Find the maximum angular velocity.
need within 1 hr pls thanks
I need the answer as soon as possible