The 1000-kg uniform bar AB is suspended from two cables AC and BD; each with cross-sectional area 400 mm². Find the magnitude P and location x of the largest additional vertical force that can be applied to the bar. The stresses in AC and BD are limited to 100 MPa and 50 MPa, respectively.

Q: The prismatic bar has a solid circular cross section with 2-in. radius. Determine the average normal…

A: Given data : Radius (r)=2

Q: The beam is loaded by one couple at each of its ends, the beam cross-section shown below (Figure…

A:

Q: The member shown has a rectangular cross section, determine the state of stress that loading…

A:

Q: A B C 80 kN 2 m 50 kN D E F -1m--1 m--1 m--1 m-|

A:

Q: *1-32. Determine the largest intensity w of the uniform can be applied to the frame without causing…

A:

Q: The rigid bar EFG is supported by the truss system shown. Determine the cross-sectional area of…

A:

Q: Two forces P1 and P2, of magnitude P1 = 15 kN and P2 = 18 kN, are applied as shown to the end A of…

A: Given:P1=15 kN     =15000 NP2=18 kN     =18000 NRadius c=20 mmThe axial force and bending moment…

Q: The pin-connected rigid rods AB and BC are inclined at 0 the force P is applied, 0 becomes 32°.…

A:

Q: P A B 1m E 1m 2m The simply supported beam shown has a solid rectangular cross section having beam…

A: b = 130 mm h = 200 mm  P = 25 KN w = 30 KN/m

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.