Thanks 250-V, 350-A, separately excited de motor with an armature resistance of 0.05 ohm, anda field voltage 200V and a field resistance is 50 ohm. The no-load speed is 1200 rpm.1- Find the starting current.2- Find the no-load current.3- Find the speed of this motor when the line current is 250 A.4- For part 3, if the mechanical losses is 5kW find the efficiency of this motor.5- If we wish to limit the maximum starting current to twice its rated value, find themodified armature resistance?

Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Answered: Thanks | bartleby

Engineering

Electrical Engineering

Thanks

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: What is mean by equipment grounding and system grounding?

A: As per bartleby guideline for more than one question asked only first three are to be answered…

Q: After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience…

A: Given: After reduction, the current carrying capacity of a conductor is referred to as the ___.

Q: List the minimum trade size Type EMT for each of the following applications. (Objective 12-1)…

A: As per Bartleby expert policy only first individual question is to be answered. So, answering only…

Q: What justifies the need for plenumrated cabling above the ceiling tile?

Q: A DC is supplied through a solid conductor cable. The fault in the cable can be determined by using…

Q: Fill in the blanks: Q. Expansion of LSB is

A: A combinational circuit is one in which the various gates in the circuit, such as the encoder,…

Q: Give the raceway size required for each of the following conductor combinations: 1. Five, 10 AWG,…

A: The raceway size required for each of the following conductor combination is given as per the…

Q: The power dissipated in the 15 Ω resistor. 120 V Μ 4Ω 30 Ω 2Ω 15 Ω Μ 40 Ω • 10 Ω

Q: Discuss any two types of grounding methods.

A: Two types of grounding methods: Solid grounding Resistance grounding

Q: Define cable rating in a built environment

A: Cable selection and application : It is essential to know cable construction, characteristics,…

Q: a) b) Problem 2. The circuit shown below has been set up for a long time prior to t = 0 with the…

A: Step 1: (a):Step 2: (b):

Q: Find % Regulation for the given readings VR(Line to Line ) = 394 Volts, Vs(Line to Line ) = 458 %3D…

Q: Noise Calculations Blender at near field or 3-feet ________________80.7 dB__________________…

A: The given data is as follows:-

Q: The nominal output voltage of a certain regulator is 8 V. The output changes 214 mV when the input…

A: Given The nominal output voltage of a certain regulator is 8 V. The output changes 214 mV=0.214Vwhen…

Q: What is the mean of wiring

A: Wiring is the term used for the supply system design, connection, and protection schemes employed…

Q: Main bonding jumpers are required to be made of _______ or other corrosion-resistant material. A.…

A: All of them are correct

Q: Propose THREE (3) safety practices that commonly applied for electrical systems or during conducting…

A: Any fault that occurs in any system , results in the high increase in flow of currents. This high…

Q: Ferrous metal raceways or enclosures are made with _______ content. A. brass or aluminum B. steel or…

Q: Which of the following is an approved disconnecting means for a feeder or branch circuit supplying a…

A: The disconnecting means for a feeder or branch circuit supplying a separate building or structure is…

Q: Due to the effect of the resistance of the cable connected to RTD, two-wire cables up to ……. meters…

A: c) 50-195

Q: What dimensions are used when measuring the area of a building? See NEC 220.12.

A: Referring to the NEC 220.12, the floor area is evaluated using the outside of the building…

Q: analyse the rating of wires/ cables and mcb used for different types of loads

A: A small circuit breaker called an MCB is used to trip when home appliances experience overcurrent…

Q: 13. Two electricians are discussing feeders that supply branch circuits. Electrician A says that the…

A: Feeder: A feeder is a branch of lines associated from one point means at the substation, from…

Q: What is meant by Electric Bid Package?

A: Bid package means the collection of the pertinent portion of the construction documents into a…

Q: What justifies the need for plenumrated cabling above the ceiling tile?

A: ANSWER There are several reasons why we use…

Q: The parameters of the _________equivalent circuit are defined in general terms for any operating…

A: In this question, We need to choose the correct options The parameters of the _________equivalent…

Q: Grounding lighting fixtures. Threre are specific requirements for grounding lighting fixtures. How…

A: The light fixtures may have an external chassis made out of metal. In that case, run a green wire…

Q: How Rth connected with the load resistance, explain

A: RL will be connected in series with RTH as shown in the example.

Q: A proportional band setting of 42 percent corresponds to a proportional gain setting of

A: In this question we will find proportional gain setting..

Q: Define an equipment grounding conductor. The conductive path that part. of eftective an graund-fault…

A: Grounding is generally a direct physical connection to the earth. Electrical circuits are connected…

Q: Loads, Service, and Overcurrent Protection 6.a. The general lighting load is based on a _______ per…

Q: Seven 8 AWG copper conductors are run in conduit. Each conductor has type THHN insulation. The…

A: Given Copper wire AWG =8 total number of copper wires =7 Type of insulation THHN Ambient temperature…

Q: Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD.…

Q: Determine the minimum number of cubic inches required for two 10 AWG conductors passing through a…

A: AWG or American Wire Gauge is the US standard measure for the diameter of electrical conductors. The…

Q: a metal device box has four 12 AWG conductors, two internal clamps, and a duplex receptacle. Total…

A: A metal device box has four 12 AWG conductors. According to the national electric code table,…

Q: Write the methods of Neutral Grounding.

A: Neutral grounding is a process of connecting the neutral point of an electrical system to the earth,…

Q: Each unit of a 100-unit hotel is 12 × 15 ft. In addition, there's a 60 × 20 ft officeWhat's the…

A: To calculate the service demand load for conductor sizing for lighting and receptacles in a 100-unit…

Q: Explain with neat diagram of instrument for the measurement of sunshine hours.

A: instrument for the measurement of sunshine hours

Question

Thanks

250-V, 350-A, separately excited de motor with an armature resistance of 0.05 ohm, and
a field voltage 200V and a field resistance is 50 ohm. The no-load speed is 1200 rpm.
1- Find the starting current.
2- Find the no-load current.
3- Find the speed of this motor when the line current is 250 A.
4- For part 3, if the mechanical losses is 5kW find the efficiency of this motor.
5- If we wish to limit the maximum starting current to twice its rated value, find the
modified armature resistance?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1-Calculate the minimum and maximum protection for an A/C , its conductors(75 ºC) and its grounding. For the following values:1- FLC compressor = 30 A2- FLC condenser = 3 A
In a CE configuration, the voltage gain is __________ . a.always positive b.negative c.almost zero d.very low
What's the general lighting and general-use receptacle demand load for a 24-room motel where each unit is 700 sq ft?
Please answer in typing format
What kind of cable uses BNC connectors?
What code set standard for electrical installation work
wiring/ connection diagram of fire alarm system by adruino. and dicuss it
What is mean by equipment grounding and system grounding?
powe calculrions
According to the following specifications, a single solar 295-watt solar panel has maximum power operation voltage at 24 volts. What is the maximum number of solar panels that can be used in a single string? a. 35 solar panels. b. 30 solar panels. c. 25 solar panels. d. 40 solar panels. e. 20 solar panels.