TF 7.In neutralization reaction titration, end point is revealed by the change in color of indicator TF 8. When reading the measurement on a buret, reading should always be made at the lowest point of the meniscus when heavy colored substances is being read. TF 9.Sulfuric acid VS is preferable than Hydrochloric acid VS in titration of compounds since latter yields a precipitate.

TF 7.In neutralization reaction titration, end point is revealed by the change in color of indicator TF 8. When reading the measurement on a buret, reading should always be made at the lowest point of the meniscus when heavy colored substances is being read. TF 9.Sulfuric acid VS is preferable than Hydrochloric acid VS in titration of compounds since latter yields a precipitate.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A solution contains1.0 × 10 M Cu+ and 2.0 × 10 M Pb2+ .If a source of I is added gradually to this solution, will CuI (Ksp = 1.27 × 10−12) or PbI2 (Ksp = 7.1 ×10−9) precipitate first? Specify the concentration of I- necessary to begin precipitation of each salt and determine if the complete separation of Cu+ and Pb2+ feasible by fractional precipitation.
11.) 0.115 g of an unknown diprotic acid is titrated with 0.095 M NaOH. The first equivalence point occurred in the titration at a volume of 8.80 mL of NaOH added; the second equivalence point occurred at a volume of 17.60 mL of NaOH added. How many moles of diprotic acid were titrated? mol diprotic acid = mol
An aqueous solution contains 2.1 x 103 mol/L Ca?*. Enough HF was then added to the solution to reach an equilibrium concentration of [HF] = 5.5 x 104 mol/L. What must be the pH of the solution in order to observe a precipitate of CaF2? (Hint: Assume any change in pH will not change the value of [HF]). Ksp of CaF2 = 5. 3 × 10-9 Kaof HF = 7.2 × 10-4
Answer the following questions about a titration between 20.0 mL of a weak base (Kb= 4.7*10-6) and 0.150 Mhydrochloric acid A.What is the concentration of the weak base solution if it requires 26.67 mL of the HCl solution to reach the equivalence point B.What is the initial pH of the weak base solution before any HCl is added C.What is the pH of the titration at the equivalence point D.The pKaof bruhmophenol is ~ 4.9 and the pKaof thymol blue ~ 9.2. Which indicator would be best to use in the titration
3. Determine the minimum concentration of the precipitating agent on the right to cause precipitation of the cation from the solution on the left. a. 4.0×10−2 M Ba(NO3)2;NaF b. 8.5×10−2 M CaI2;K2SO4 c. 1.8×10−3 M AgNO3;RbCl
When a weak base is titrated with a strong acid, which of the following is a suitable indicator? I. Methyl orange, pKa ≈≈ 4 II. Bromthymol blue, pKa ≈≈ 7 III. Phenolphthalein, pKa ≈≈ 9 Group of answer choices II II or III III None of the choices I
Precipitation Determine if a precipitate occurs when mixing o 40.0 mL 3.00 x 10-3 M BaCl2 • 50.0 mL 3.00 x 10-3 M Na2CO3 BaCl2 + Na2CO3 → 2NaCl + BaCO3 BaCO3 Ksp = 1.1 x 10-10 If so, what is the [Ba²+] after the precipitation?
A student performed titration to determine the concentration of potassium permanganate solution with oxalic acid. The net ionic equation is as follows: 2MnO4– + 16H+ + 5C2O42- → 2Mn2+ + 10CO2 + 8H2O The titration consumed 42.31 mL of 0.1001 M oxalate solution to reach the endpoint. Determine the concentration of permanganate (M) if 25 mL was used.
In order to determine the chloride concentration in a solution, a Mohr titration is perform. This involves adding a small amount of chromate to the solution and then slowly adding silver nitrate. Silver chloride is pale yellow solid while Silver chromate is a dark red. The appearance of the red silver chromate is the endpoint of the titration. Answer the questions below about this process. (Ksp of AgCl= 1.7x10^-10 and Ksp of Ag2CrO4= 1.12x10^-12) A 100 mL sample of water from a potentially contaminated stream is collected. A 0.0010 g of sodium chromate is dissolved in the sample. 1) if the solution had been 0.015 M in NaCl, what percent of the chloride is still in solution? Given the answer to the question above, it should be clear that "all" of the chloride is removed before the silver chromate appears. This is why we can use it as an endpoint. 2) if it requires 21.4 mL of a 0.1 M solution of silver nitrate to reach the equivalence point with 100 mL of solution, what was the original…
The initial in the unknown analysis is the addition of 6. M HCl. This results in the formation of a precipitate. The solid precipitate is separate from the liquid solution. The solution could potentially contain K+, Ca2+, and Al3+. Next, 3M NH3 is added to the solution to separate the Al3+. This is a result of the fact that the Al3+ forms the hydroxide, Al(OH)3. But Ca2+ also forms the hydroxide, Ca(OH)2. Why does the Ca(OH)2 not separate out with the Al(OH)3?
Consider the titration of a 60.0 mL of 0.321 M weak acid HA (Ka = 4.2 x 10⁻⁶) with 0.400 M KOH. 1. What is the pH before any base has been added? 2. After 30.0 mL of KOH have been added, identify the primary species left in the solution. 3. After 30.0 mL of KOH have been added, what would the pH of the solution be? 4. After 75.0 mL of KOH have been added, identify the primary species left in the solution. 5. After 75.0 mL of KOH have been added, what would the pH of the solution be?
A chemistry graduate student is given 125. mL of a 1.20M dimethylamine ((CH3)₂NH) solution. Dimethylamine is a weak base with K₁=5.4 × 10-4. What mass of (CH3)NH₂Br should the student dissolve in the (CH3) NH solution to turn it into a buffer with 2 pH = 11.05? You may assume that the volume of the solution doesn't change when the (CH3)NH₂Br is dissolved in it. Be sure your answer has a 2 unit symbol, and round it to 2 significant digits.