t1 (cm)| 2.4 cm t2 (cm) P 10 t 10 tp + t1 (cm) .1.2 cm

Q: σ o'f σu 9 of σY o pl E proportional limit elastic limit yield stress elastic yielding region…

A: Modulus of Elasticity is the resistance of material to deformation. It represents the stiffness of…

Q: Determine: Draw Mohr's circle for the stress shown, labe a) max and min principal stresses, b) max…

A: here take stress in x direction = -12ksi, in y direction = 0 and shear stress in plane is = -6ksi.…

Q: For the truss in figure below, the cross-sectional area of the truss members is A = 500 mm² and…

A: For the truss in figure below, the cross-sectional area of the truss members isA = 500 mm²…

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: The solution is provided below

Q: The channel shape cross-section and the rectangular cross-section shown in the Figure Q4 are made of…

A: The solution is provided below

Q: Question 3 Based on the diagram below a) Find the internal forces of A, B & C. 950 тm 045 тm Ø30mm F…

A: First we need to calculate the reaction from the wall by balancing all the forces.  Sum of all the…

Q: erial when longitudinal strain is 0.12mm/mm and transverse strain is -0.03

A: Given data  Longitudinal strain=0.12mm/mm  Transverse strain=-0.0396mm/mm

Q: 2- A piece of muscle specimen has the initial length of 30mm and square cross section with original…

A: Stress : Stress is the force applied to a material, divided by the material's cross-sectional area.…

Q: rect stresses of 160N/mm tensile and 120 N/mm compressive exist on two perpendicular planes at a…

A: Given, direct tensile stress, σt=160N/mm2 Compressive stress, σc=120N/mm2 The greatest principal…

Q: 2. A element was made of a material with the material parameters of a b MPa, os 600MPa, o-1-360MPa,…

A: Given:To find:

Q: A 9 cm diameter solid aluminum post is subjected to a horizontal force of V= 7.9 kN and a…

A:

Q: material have a stress strain curve which can look similar to the equation y = x2 (for all x>0).…

A: Given Data⇒Stress strain curvey=x2Problem definition⇒Problem says choose between true and false.

Q: A 3D solid component is subject to external forces such that following three principal stresses are…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.