T. °C 93.00 0.2195 0.4620 0.5242 0.5686 0.5926 0.6821 0.7421 0.9160 0.0118 0.0841 0.1978 0.3496 0.4525 0.6794 0.7693 0.9442 84.02 82.12 80.62 80.16 80.28 81.51 81.25

Q: 4. A total of 200 mol/s of a liquid mixture with 40 mol% benzene and 60mol % toluene is fed to a…

A:

Q: Using the equilibrium data shown below for benzene-toluene system at 1 atm with relative volatility…

A: The pressure of the benzene-toluene mixture The relative volatility,

Q: puon, absorption, and solvent extraction. P5.3 Use the Antoine equation to calculate the boiling…

A: Antoine equation is a correlation relating boiling temperature and vapour pressure of pure…

Q: Since NH3 gas does not dissolve at a boundary, it diffuses in N2, which does not spread. Total…

A: Total pressure PT = 1013 × 105 Pa Temperature T = 298 K Partial pressure of NH3 PA1 = 1333 × 104 Pa…

Q: A continuous single-effect evaporator concentrates 9072 kg/h of a 1.0 wt% salt solution entering at…

A: Introduction:- The heat exchanger for boiling the solution and the specific features for separating…

Q: An iron-carbon alloy initially containing 0.255 wt% C is exposed to an oxygen-rich and virtually…

A: Given data: Initial concentration of C = 0.255 wt % Surface concentration = 0.0 wt % Temperature =…

Q: The feed to a conventional distillation column and the relative volatilities are shown in the…

A: Basis: 1 mole of the feed sent to the distillation unit. Using component 2 as the light key…

Q: Absolute (100%) ethanol is produced from 95% ethanol and 5% water using the Keyesdistillation…

A: The objective of the question is to calculate the volume of benzene that should be fed to the still…

Q: Please show every step you used to solve each problem. A vapor mixture of 100 mol/s comprising 55…

A: Taking the values from previous answer

Q: In absorption, the absorbent is stripped to an extent that depends on its K-value. In stripping, the…

A: The type of process which is taking place along with the reason in the given diagram is to be…

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass…

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O…

Q: n the manufacture of sulfuric acid by the contact process iron pyrites, FeSj, is burned in dry air,…

A: (a) To calculate the weight of air to be used per 100 lb of pyrites charged, we need to consider the…

Q: An iron-carbon alloy initially containing 0.308 wt% C is exposed to an oxygen-rich and virtually…

A: Given:D=5.5×10-10m2sC0=0.308%Cs=0%Cx=0.231%t=6 h=21600 s

Q: F2 gas and excess iodine solid are heated together at high temperatures.  The iodine sublimes and…

A: Given, I=2.5g,  No. of moles of I=2.5/Atomic mass of I=2.5/127 moles No. of moles of I=0.019685…

Q: leaving the distillation column are at different temperatures. a) Determine the number of degrees of…

A: 1) feed mixer contains pure nbutane at temperature T which is only unknown so it's degrees of…

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.