t = 0 {1.25 H 1= 0 75 kN3 2 A $100 310H V, i36 H Figure P7.19 Full Alternative Text

Q: The circuit is at steady state when the switch closes at time t = 0. Determine v1(0−), v1(0+),…

A:

Q: In the circuit shown below the switch is closed for a long time and then opened at t = 0.The value…

A: Given circuit,

Q: When the switch has been in position-a for a long time, what is the initial current carried by the…

A: When the switch has been in position-a for a long time, what is the initial current carried by the…

Q: The long open switch in the circuit shown in the figure is closed at t=0 find il(t) fort>=0

A:

Q: Given the following circuit where the capacitors C1 and C2 are initially uncharged and the switch is…

A:

Q: 4- Explain the effect of resistor 's value on the circuit response

A: 4-Effect of resistor's value on the circuit response.

Q: What is the time constant of the circuit? 4 (! 2 F

A: Calculation of time constant for the given circuit : The circuit consists resistances and…

Q: In the circuit below, the switch closes at time t=0. Assume that Is = 2.21 A, R = 11.4 kΩ, and L =…

A:

Q: t = 0 + VR 8Ω 16 V 12 2 1 H * F

A: We will find current through inductor .

Q: The switch is close for a long time, then at t = 0 it was opened. Determine the equation for the…

A:

Q: 3. 7.3 PSPICEMULTISIM The switch in the circuit has beenopen for a long time. At t=0 the switch is…

A: Given data: Resistance R1 = 2 Ω. Resistance R2 = 4 Ω. Voltage, V = 12 V. Inductor, L = 1 H. At to…

Q: Part A: Open circuit and short circuit faults are important in circuit analysis. These are the most…

A: As per the guidelines we are supposed to answer only first question. Please repost the remaining as…

Q: Two switches operate simultaneously. Priortot= 0 each switch has been in its indicated position for…

A: In this question we use inductor property 1. In steady state inductor act as short circuit for DC…

Q: The switch in the circuit has been open for a long time before closing at t = 0. Find İL(t) for t≥…

A: In the given circuit, the switch connects at  We need to determine the expression of inductor…

Q: 1+ a-0 62 60 V 24 V 32 2F

A: Given circuit shown

Q: What type of response (natural/step) is the circuit undergoing? Explain briefly with reasons.

A:

Q: For the following circuit, V₁=12V, V₂=5V, C=5mF, R₁=R₂=2 №2, and R3 = 4 Q. Calculate: a. Time…

A: Note :As per guidelines I am doing first 3 sub parts.

Q: 1- In the circuit below, the blue switch is closed at t=0 after a long time and the red switch is…

A:

Q: In the following circuit, the switch has been in current position for a long time. At t=0 s switch…

A:

Q: The circuit is at steady state when the switch closes at time t = 0. Determine v,(0-), v,(0+),…

A:

Q: 7. Consider the following circuit: ε = 15.0 V C₁ = 25.0 μF C2 = 35.0 μF R₁ = 45.0 52 R2 = 55.0 22 R3…

A: Since you have posted a question with multiple subparts, we will provide the solution only to the…

Q: What is the initial energy stored in the inductor in Figure 7 at t=0? Ow=84.4 m.J Ow=37.5mJ Ow-75.0…

A:

Q: ron $on RI 100 6A Than

A: Given circuit shown

Q: Questions states that the switch is closed at t=0, initial value of the inductor current= 0, Find…

A:

Q: For the circuit shown. the switch closes at t 0.the value of i(1) at (t 0)s. i() 5H 10 A 22 32…

A: To find the value of i(t) at t = 0-

Q: 11=8 A (9) 14 12, R1=300 www R3= 100 13 R2= 240 15 R4=80 Resp: 12=3 A; 13=5 A; 14=3 A: 15= 8 A

A:

Q: Puestion :- Find cIt) time constant , rise time , and following first setting time for r the order…

A: The transfer function is a way of representing a system. The transfer function is the ratio of…

Q: In the circult shown below Vs = 34 Volt, Is = 7 Amp, R= 720, and ty =7 sec. The 2 H inductor was…

A: Vs=34V Is=7A R=72ohm tx =7sec

Q: 1.The switch in the following circuit has been open for a long time. At time t=0 the switch is…

A: The given circuit isAt t = 0, the swith is closed.We need to determine the current in the inductor…

Q: The switch in the circuit has been in position "a" for a long time. At t=0 it is moved to position…

A:

Q: Prob. 4 at t=0 JOKS2 when the auitch VELE) closes. 10kn 3AF what is the time constant of the circut…

A: The given circuit diagram is:

Q: Assume that switch SW1 has been in position 1 long enough to completely charge C1. Then, at t = 0,…

A:

Q: Compute the time constant of the circuit below in units of ms (Do not enter units in the solution…

A: The solution can be achieved as follows.

Q: 3 which of the following the correct distribution of the poles of a system whose characteristic…

A: Given, Polynomial is  P(s) = s5+2s4+2s3+4s2+11s+10 We need to determine the distribution of poles of…

Q: In the circuit, switch A has beenopen and switch B has been closed for a long time. At t=0, switch…

A:

Q: QI) The switch in the circuit shown in Figure (1) below has been opened for a long time, and it is…

A:

Q: 1.Utilize an appropriate R-C circuit powered by a 120 V DC source. This RC circuit will be the…

A: Approach to solving: In this problem, the following are given:Vs = 120 V DCVon = 70 V --- turn on…

Q: A Compute the time constant 7 (for t≥0s) of the circuit below: (1+) 222 10V 32 M 2 A t=on すっ 622…

A:

Q: Determine the current through the inductor long after the switch happens, j.(0) in Amps. Round your…

A:

Q: 30N A t= 0 ell V 4H B 35 V(E :0.25 F 10Ω

A:

Q: For the circuit shown below, the switch has been in position-a for a long time. At t-0, the switch…

A: If circuit contain Resistors and Capacitors then called RC circuit If circuit contain Inductor and…

Q: 7. The two switches in the circuit below are synchronized. The switches have been closed for a long…

A: