Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between the two nodes is 325 bit times. Suppose CSMA/CD and Ethernet packets are used for this broadcast channel. Suppose node A begins transmitting a frame and, before it finishes, node B begins transmitting a frame. Can A finish transmitting before it detects that B has transmitted? Why or why not? If the answer is yes, then A incorrectly believes that its frame was successfully transmitted without a collision. Hint: Suppose at time t=0 bits, A begins transmitting a frame. In the worst case, A transmits a minimum-sized frame of 512+64 bit times. So A would finish transmitting the frame at t=512+64 bit times. Thus, the answer is no, if B's signal reaches A before bit time t=512+64 bits. In the worst case, when does B's signal reach A?

Suppose nodes A and B are on the same 10 Mbps broadcast channel, and the propagation delay between the two nodes is 325 bit times. Suppose CSMA/CD and Ethernet packets are used for this broadcast channel. Suppose node A begins transmitting a frame and, before it finishes, node B begins transmitting a frame. Can A finish transmitting before it detects that B has transmitted? Why or why not? If the answer is yes, then A incorrectly believes that its frame was successfully transmitted without a collision. Hint: Suppose at time t=0 bits, A begins transmitting a frame. In the worst case, A transmits a minimum-sized frame of 512+64 bit times. So A would finish transmitting the frame at t=512+64 bit times. Thus, the answer is no, if B's signal reaches A before bit time t=512+64 bits. In the worst case, when does B's signal reach A?

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Suppose that KJ sends 3596 back-to-back packets, with each packet composed of 14,000 bits, to TA over 5 links (shown below). Suppose that the transmission rate of each link is 70,000 bits/sec (bps). Consider the routers to be store-and-forward routers. In such a scenario, find the endto- end delay of sending all the packets to TA (i.e., the time needed for the last bit of the last packet to arrive at TA since KJ starts transmitting the first bit of the first packet). Note, consider only the transmission delay that occurs in sending packets in your analysis. Show the steps used for derivation in detail. 70,000 bps 70,000 bps 70,000 bps 70,000 bps 70,000 bps KJ Router 1 Router 2 Router 3 Router 4 ТА
Consider two hosts S and R connected directly by a link. A link has a transmission speed of 107 bits/sec. It uses data packets of size 400 bytes. Data needed to transmitted is 400 bytes. Length of the link is 600 km and the propagation speed are 3 × 108 meter per second. T is the transmission delay and P is the propagation delay. The propagation delay in millisecond and transmission delay in microsecond respectively are
Assume that 2 packets arrive simultaneously to a switch at which one other packet is halfway done being transmitted on the outbound link and two other packets are waiting to be transmitted. Each packets is of length N = 1600 bytes and the outbound link has transmission rate R = 1.28 Mbps. Assume that the queuing buffer is big enough to hold at least five packets. What is the average queuing delay for the arriving 2 packets?
strictly....Do not copy anything from anywhere. i'll give downvotes then
A packet with 88MB long is generated at node A and sent to node C through node B. The distance betẃeen A and B is 6500km, distance between B and C is 880km in this arrangement. Data rate between A and B is 100kbs. The propagation delay is 2.9µ/km. Determine the minimum data required between data rate required between node B and C so that the buffer of node B are not flooded.
Consider a broadcast channel with N nodes and a transmission rate of R bps. Suppose the broadcast channel uses polling (with an additional polling node) for multiple access. Suppose the amount of time from when a node completes transmission until the subsequent node is permitted to transmit (that is, the polling delay) is ?poll. Suppose that within a polling round, a given node is allowed to transmit at most Q bits. What is the maximum throughput of the broadcast channel?
I need the answer quickly
Consider the following network with given line speeds and lengths: Assume the speed of light is 2×10^8 m/s, and that the processing and queuing delays are negligible. Node A sends a 1400-byte frame to node C through node B. Suppose Node A starts sending the first bit of the frame at t=0. Answer the following questions: a. At what time (t=?) node B receives the frame in full (i.e. the last bit)? b. After node B receives the frame in full, then it will start sending the frame to node C. Determine the time (t=?) when node C receives the frame in full. c. Suppose at this time node C sends a small acknowledgment back to node A. The transmission time for the acknowledgment is negligible. Calculate at what times (t=?) the acknowledgment arrives at nodes B and A. d. Assume after sending its frame, node A wait for the acknowledgment back from node C before sending the next frame. What is the average throughput (number of transmitted bits per second) of the data flow from node A to…
Consider two systems P and Q connected via a router R with the bandwidth of 2 Gbps. The length of the packet is 1000 bytes. The propagation delay between P and Q is 200 microseconds. The distance between the P and R is 10 km while the distance between R and Q is 5 km. The propagation speed in meter per second if each link is having the same 10³ km/s? propagation speed is
Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive 100 Mbps links of 2000 km length each.Assume that the signal propagation speed on both links is 2 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1480 bytes and that Computer A fills each packet to the max, if possible. How long (in seconds) does it take Computer A to send out one packet of maximum length on the first link?
Computer A is sending a 100 kByte long file to Computer B via packet-switching over two consecutive 10 Mbps links of 1000 km length each.Assume that the signal propagation speed on both links is 2.5 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1500 bytes and that Computer A fills each packet to the max, if possible. How "long" (in meters) is one bit on link 1?
Computer A is sending a 10 MByte long file to Computer B via packet-switching over two consecutive 100 Mbps links of 2000 km length each.Assume that the signal propagation speed on both links is 2 x 108 m/s.Furthermore, assume that the maximum length of a packet is 1480 bytes and that Computer A fills each packet to the max, if possible. How many bytes will be contained in the last packet?