Suppose a 250. mL flask is filled with 1.9 mol of CH, 1.0 mol of H,S and 1.3 mol of H,. This reaction becomes possible: CH,(2) + 2H,S(g) = Cs, (g) + 4H, (g) Complete the table below, so that it lists the initial molarity of each compound, the change in molarity of each compound due to the reaction, and the equilibrium molarity of each compound after the reaction has come to equilibrium. Use x to stand for the unknown change in the molarity of CS,. You can leave out the M symbol for molarity. CH, H, S CS, H, initial change equilibrium

Suppose a 250. mL flask is filled with 1.9 mol of CH, 1.0 mol of H,S and 1.3 mol of H,. This reaction becomes possible: CH,(2) + 2H,S(g) = Cs, (g) + 4H, (g) Complete the table below, so that it lists the initial molarity of each compound, the change in molarity of each compound due to the reaction, and the equilibrium molarity of each compound after the reaction has come to equilibrium. Use x to stand for the unknown change in the molarity of CS,. You can leave out the M symbol for molarity. CH, H, S CS, H, initial change equilibrium

Introductory Chemistry: An Active Learning Approach

6th Edition

ISBN:9781305079250

Author:Mark S. Cracolice, Ed Peters

Publisher:Mark S. Cracolice, Ed Peters

Chapter8: Chemical Reactions

Section: Chapter Questions

Problem 5E

See similar textbooks

Similar questions

A student weighs out a 4.80-g sample of aluminum bromide, transfers it to a 100-mL volumetric flask, adds enough water to dissolve it, and then adds water to the 100-mL mark. What is the molarity of aluminum bromide in the resulting solution?
On Easter Sunday, April 3, 1983, nitric acid spilled from a tank car near downtown Denver, Colorado. The spill was neutralized with sodium carbonate: 2HNO3(aq)+Na2CO3(aq)2NaNO3(aq)+H2O(l)+CO2(g) a. Calculate H for this reaction. Approximately 2.0 104 gal nitric acid was spilled. Assume that the acid was an aqueous solution containing 70.0% HNO3 by mass with a density of 1.42 glcm3. What mass of sodium carbonate was required for complete neutralization of the spill, and what quantity of heat was evolved? (Hf for NaNO3(aq) = 467 kJ/mol) b. According to The Denver Post for April 4, 1983, authorities feared that dangerous air pollution might occur during the neutralization. Considering the magnitude of H, what was their major concern?
What is the difference between a solute and a solvent?
Calculate the molarity of solutions prepared by dilution or calculate the quantities needed to carry out a dilution to prepare a solution of a specified concentration.
Many over-the-counter antacid tablets are now formulated using calcium carbonate as die active ingredient, which enables such tablets to also be used as dietary calcium supplements. As an antacid for gastric hyperacidity, calcium carbonate reacts by combining with hydrochloric acid found in the stomach, producing a solution of calcium chloride, converting die stomach acid to water, and releasing carbon dioxide gas (which the person suffering from stomach problems may feel as a burp). Write die balanced chemical equation for this process.
4-89 If 7.0 kg of is added to 11.0 kg of to form which reactant is in excess?
39. Standard solutions of calcium ion used to test for water hardness are prepared by dissolving pure calcium carbonate. CaCO3, in dilute hydrochloric acid. A 1.745-g sample of CaCO3 is placed in a 250.O-mL volumetric flask and dissolved in HCI. Then the solution is diluted to the calibration mark of the volumetric flask. Calculate the resulting molarity of calcium ion.
The units of parts per million (ppm) and parts per billion (ppb) are commonly used by environmental chemists. In general, 1 ppm means 1 part of solute for every 106 parts of solution. Mathematically, by mass: ppm=gsolutegsolution=mgsolutekgsolution In the case of very dilute aqueous solutions, a concentration of 1.0 ppm is equal to 1.0 g of solute per 1.0 mL, which equals 1.0 g solution. Parts per billion is defined in a similar fashion. Calculate the molarity of each of the following aqueous solutions. a. 5.0 ppb Hg in H2O b. 1.0 ppb CHCl3 in H2O c. 10.0 ppm As in H2O d. 0.10 ppm DDT (C14H9Cl5) in H2O
Barium chloride solutions are used in chemical analysis for the quantitative precipitation of sulfate ion from solution. :math>Ba2+(aq)+SO42(aq)BaSO4(s) ppose a solution is known to contain on the order of 1 50 mg of sulfate ion. What mass of barium chloride should be added to guarantee precipitation of all the sulfate ion?
4-103 Caffeine, a central nervous system stimulant, has the molecular formula C8H10N402. (a) How many moles of caffeine are present in 6.19 1025 molecules of caffeine? (b) Imagine you dissolve caffeine in water to a volume of 100.0 mL, which is known to have a density of 1.23 g/mL. How many molecules of caffeine are present in this volume? (c) How many nitrogen atoms are present in 3.5 mg of caffeine? (d) Complete the skeletal structure of caffeine, where all the bonded atoms are shown but double bonds, triple bonds, and/or lone pairs are missing. (e) Identify the various types of geometries present in each central atom of caffeine using VSEPR theory. (f) Determine the various relative bond angles associated with each central atom of caffeine using VSEPR theory (g) What is the most polar bond in caffeine? (h) Would you predict caffeine to be polar or nonpolar? (j) Consider the combustion of caffeine, which results in formation of NO2(g) as well as other expected products. Write a balanced chemical equation for this reaction. (j) The heat of combustion for caffeine is 2211 kcall/mol. How much heat will be given off if 0.81 g of caffeine is burned completely? (k) Calculate the weight of H2O(g) that can be prepared from 8.00 g of caffeine mixed with 20.3 g of oxygen gas.
The US Environmental Protection Agency (EPA) places limits on the quantities of toxic substances that may be discharged into the sewer system. Limits have been established for a variety of substances, including hexavalent chromium, which is limited to 0.50 mg/L. If an industry is discharging hexavalent chromium as potassium dichromate (K2Cr2O7), what is the maximum permissible molarity of that substance?
Write the balanced chemical equation for the complete combustion of adipic acid, an organic acid containing 49.31% C, 6.90% H, and the remainder O, by mass.