Suppose 90 kW is to be transmitted over two 0.135 lines. Part A Estimate how much power is saved if the voltage is stepped up from 220 V to 2200 V and then down again, rather than simply transmitting at 220 V. Assume the transformers are each 99% efficient. Express your answer using two significant figures. Psaved = ΑΣΦ Submit Request Answer A simple generator has a square armature 9.0 cm. on a side. The armature has 90 turns of 0.59-mm-diameter copper wire and rotates in a 0.750-T magnetic field. The generator is used to power a lightbulb rated at 12.0 V and 25.0 W. Part A f= Value B Submit Request Answer At what rate should the generator rotate to provide 12.0 V to the bulb? Consider the resistance of the wire on the armature. Express your answer to two significant figures and include the appropriate units. ? Units kW ?

Q: 9. A container made of a metal has a mass of 3.5 kg and contains 19 kg of water. A 0.050 kg cube of…

A: The temperature at which ice melts is called the melting point. The melting point of ice is 0 °C.

Q: A beam of light is moving directly along the spaceship, but through an old-fashioned fiber optic…

A:

Q: A rigid, well-insulated tank contains a two-phase mixture of ammonia with 0.0025 ft3 of saturated…

A:

Q: B A coin sits on a rotating turntable as shown in the figure. At the time shown in the figure, which…

A: We need to say what the direction of friction will be on the coin on turntable.

Q: A paradox is defined in the Merriam-Webster online dictionary as 'an argument that apparently…

A: Special theory of relativity

Q: Problem 2 A rocket is launched from rest on the ground with an upward acceleration of 5 m/s². 6 s…

A: Acceleration (a) = 5 m/sTime (t) = 6 s Time (t) = 6 s

Q: 5) With A any vector, (Ā · V)F = Ā. (a) Verify this result in Cartesian coordinates. (b) Verify this…

A:

Q: Given the surface charge density ps = 100 µC/m², existing in the region p<0.2 m, z = 0, find E at…

A: Given that: ρs=100 μC/m2PA (ρ=0,z=0.5) mPB (ρ=0,z=-0.5) mWe can consider the value of radius ρ=0.2 m

Q: 12. A golfer drives a ball from its tee. The speed of the ball is 30 ms-1. The mass of the ball is…

A: Given: The speed of the ball is v=30 m/s. The mass of the ball is m=50 g. The contact time between…

Q: Significant figures are important. Three students are each asked to measure one side of a box.…

A: The answer is 53 cm3

Q: Part C What is the force F, applied to the ball by the rod? Take upward forces to be positive (e.g.,…

A:

Q: What can you say about the coefficient of friction, uk ? Assume the speed is low enough that air…

A: since the skier is moving with constant speed, the acceleration is zero. therefore, the net force…

Q: IJ 0

A: Hey, since there are multiple subparts  posted, we will answer first three subparts. If you want any…

Q: 1. Four students are trying to move a table from one corner of the classroom to another, as…

A: Given Data: Let us consider the given forces acting on rectangular table. We are to find resultant…

Q: A Ferris wheel rotates at an angular velocity of 0.29 rad/s. Starting from rest, it reaches its…

A:

Q: Starting from rest at the top plate with what velocity would an particle hit the bottom plate. The…

A: Given:- 9)  The potential difference V = 568 V  The figure of the battery is given as  Find:-  What…

Q: Required information A 55.0-kg lead ball is dropped from the Leaning Tower of Pisa. The tower is…

A:

Q: Problem 1 A rock is thrown straight upward at 9 m/s just over the side of a raised deck, 5.5 m above…

A: Initial velocity of the rock, Height from which the rock was thrown,

Q: 51, please.

A: Given: Potential energy of the stuntman = 10,000 J

Q: QUESTION 8 The force is F=7j-3k (N) acts at the position r=4i from the axis of rotation. Determine…

A:

Q: 9. What is the clectric potential at P due to charges Q, and Qz? 1.0 m 0.50 m Q- 1.0 μC QQ-4.0 μC…

A: SOlution: gievn that Q1 = 1 micro C Q2 = 4 micro C r1 = 0.5 m r2 = 1 m

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.