SUPPLEMENTARY PROBLEMS 9. Determine the torque that may be resisted by the single block brake shown in Fig. 15-14 below for a coefficient of friction of 0.3. Ans. 48.9N m 180 180 $500 100 F = 625N V-belt $250 135N 500 750 Fig. 15-14 Fig. 15-15.

Q: Define initial kinetc energy.

A: Initial kinetic energy is the kinetic energy of the body at the time we consider it to study its…

Q: Briefly describe any four important considerations in the implementation of RCM.

A: Asset Criticality Assessment:  Asset criticality analysis is essential to the implementation of RCM…

Q: Datum features must be specified in a feature control frame in order of: O Numerical order O…

A: Datum features must be specified in a feature control frame in order of precedence.  Answer - C

Q: 97) In which operating condition is the PCM most likely using the open loop strategy? O Highway…

A:

Q: Produce a 3D solid model of the Guard casing and test boss. Using solid works

A: Given Part drafting To find 3D diagram

Q: Types of External Connections (Pin, Ball in Socket (3D pin), Fix, Roller/Rocker, Sliding Support,…

A:

Q: Robotic arms can have different end effectors. An end effecor is the attachment that is put on the…

A: An end effector is a peripheral device that attaches to the end of the robot arm which allows the…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.